Investigation of the effect of solidification rate on microstructure of Al-0.13Si-0.3Fe DC-cast alloy using EBSD and DSC techniques

Direct chill (DC) casting is used to cast aluminum alloy ingots. Casting speed influences the distribution and types of iron intermetallics in aluminum ingot microstructure. This study attempted to identify and quantify the iron intermetallic phases in the microstructure of laboratory scale DC Al- 0.13Si-0.3Fe samples using differential scanning calorimetry, scanning electron microscopy, electron backscatter diffraction, and energy dispersive X-ray spectroscopy. Both stable and non-stable iron intermetallic phases were observed but to different extents in all alloy samples’ microstructure. Two different types of iron-rich, AlFeSi globular particles were observed in the alloy samples’ microstructure. As a result, an attempt was made to understand the formation temperature and composition of these small, globular particles. DSC results confirmed that the enthalpy change of phase formation is dependent mainly on the volume fraction of the iron intermetallic phase in the microstructure. A good agreement was observed between the quantitative analysis results and the DSC analysis, which supports the reliability of the quantitative methods used in this study. The results obtained in this study bridge existing gaps in literature on the effect of cooling rate on the selection of iron intermetallic phases, in general, and in the AlSiFe globular particles, in particular.

Iron Intermetallic Phases in the Alloy Based on Al-Si-Mg by Applying Manganese

Manganese is an effective element used for the modification of needle intermetallic phases in Al-Si alloy. These particles seriously degrade mechanical characteristics of the alloy and promote the formation of porosity. By adding manganese the particles are being excluded in more compact shape of “Chinese script” or skeletal form, which are less initiative to cracks as Al5FeSi phase. In the present article, AlSi7Mg0.3 aluminium foundry alloy with several manganese content were studied. The alloy was controlled pollution for achieve higher iron content (about 0.7 wt. % Fe). The manganese were added in amount of 0.2 wt. %, 0.6 wt. %, 1.0 wt. % and 1.4 wt. %. The influence of the alloying element on the process of crystallization of intermetallic phases were compared to microstructural observations. The results indicate that increasing manganese content (> 0.2 wt. % Mn) lead to increase the temperature of solidification iron rich phase (TAl5FeSi) and reduction this particles. The temperature of nucleation Al-Si eutectic increase with higher manganese content also. At adding 1.4 wt. % Mn grain refinement and skeleton particles were observed.