Distrontium Cerate as a Radiopaque Component of Hydraulic Endodontic Cement

This study aimed to synthesize distrontium cerate (2SrO·CeO2: S2Ce) and evaluate its properties as an alternative component of the endodontic cement. S2Ce cement was prepared through calcination of strontium hydroxide and cerium carbonate. Subsequently, the crystal phase was confirmed using X-ray diffraction. S2Ce cement exhibited a rapid setting time (121 min) and achieved a high compressive strength (72.1 MPa) at 1 d after mixing, comparable to the compressive strength of a commercial mineral trioxide aggregate (MTA) cement (ProRoot MTA) after 28 d post mixing. However, the compressive strength decreased after 28 d of storage when the W/P ratio was 0.30–0.40 (p < 0.05). Ion dissolution test of the S2Ce cement showed that strontium ions were released after immersion in water (5.27 mg/mL after 1 d), whereas cerium dissolution was not detected. S2Ce exhibited approximately three times higher radiopacity (9.0 mm aluminum thickness equivalent) compared to the commercial MTA (p < 0.05). These findings suggest that S2Ce is a possible component for hydraulic endodontic cement that demonstrates a rapid setting and high radiopacity.

SYNTHESIS AND PROPERTIES OF Sr-CONTAINING TRYCALCIUM PHOSPHATE

Sr -замещенный трикальцийфосфат был получен методом осаждения из водных растворов. Синтетические твердые фазы исследовали с помощью рентгеннофазового анализа, ИК-Фурье спектроскопии, сканирующей электронной микроскопии, энергодисперсионного анализа. Надосадочная жидкость была исследована на наличие ионов Ca и PO для вычисления Са/Р соотношения. Выявлено, что ионы стронция входят в состав трикальцийфосфата, однако не изменяют его фазовый состав. Добавление ионов стронция в исходный раствор способствует уменьшению размеров кристаллитов и увеличению их пористости. Данные по энергодисперсионному анализу подтвердили, что ионы стронция входят в состав образцов ТКФ. Но при увеличении их концентрации, полного замещения ионов кальция на ионы стронция в структуре ТКФ не происходит. При изучении биорезорбируемости полученных образцов с помощью прямой потенциометрии установлено, что образцы, содержащие ионы стронция в своем составе, имеют меньшее значение скорости резорбции. При этом, наибольшие значения скорости растворения фиксируются в кислых средах. Sr -substituted tricalcium phosphate was obtained by precipitation from aqueous solutions. Synthetic solid phases were investigated using X-ray phase analysis, IR spectroscopy, scanning electron microscopy, energy dispersive analysis. The supernatant was examined for the presence of Ca and PO4 ions to calculate the Ca/P ratio. It was revealed that strontium ions are part of tricalcium phosphate, but do not change its phase composition. The addition of strontium ions to the initial solution contributes to a decrease in the size of crystallites and an increase in their porosity. When studying the bioresorbability of the obtained samples using direct potentiometry, it was found that the samples containing strontium ions in their composition have a lower value of the rate of resorption. Energy dispersive analysis data confirmed that strontium ions are included in the composition of TCP samples. But with an increase in their concentration, complete replacement of calcium ions with strontium ions in the TCP structure does not occur. At the same time, the highest values of the dissolution rate are recorded in acidic media.

The Influence of Strontium on Bone Tissue Metabolism and Its Application in Osteoporosis Treatment

Osteoporosis is a chronic disease characterized by low bone mass caused by increased bone turnover and impaired bone microarchitecture. In treatment, we use antiresorptive or anabolic drugs, which usually have a unidirectional effect, i.e., they inhibit the activity of osteoclasts or stimulate the effect of osteoblasts. Strontium ranelate is an anti-osteoporosis drug with a unique mechanism of action (used primarily in postmenopausal women). Unlike other medicines, it has a multidirectional effect on bone tissue, intensifying osteoblastogenesis while inhibiting osteoclastogenesis. It turns out that this effect is demonstrated by strontium ions, an element showing physical and chemical similarity to calcium, the basic element that builds the mineral fraction of bone. As a result, strontium acts through the calcium-sensing receptor (CaSR) receptor in bone tissue cells. In recent years, there has been a significant increase in interest in the introduction of strontium ions in place of calcium ions in ceramics used as bone replacement materials for the treatment of bone fractures and defects caused by osteoporosis. The aim of this study was to summarize current knowledge about the role of strontium in the treatment of osteoporosis, its effects (in various forms), and the ways in which it is administered.

Diffusion of strontium implanted in glassy carbon

Glassy carbon has properties making it attractive as a containment material for radioactive waste. In this study, the diffusivity of the radiological important fission product, strontium, is measured. Two hundred kiloelectronvolt strontium ions were implanted at room temperature. The implanted samples were either annealed isochronally for 1 h up to 900°C or by increasing the temperature linearly up to 648°C. The Sr profiles were determined by Rutherford backscattering spectrometry (RBS). The isochronally annealed samples showed Fickian diffusion at 300°C ( D = 6.7 × 10 −19 m 2 s −1 ) with segregation occurring at the higher temperatures. Raman spectroscopy indicated a link between damage annealing and the onset of segregation. During increasing temperature, the system is dynamic with diffusion taking place. An equation to determine diffusion coefficients for ramped heating was derived. Fickian diffusion occurred with an activation energy of 1.97 eV for 414–454°C, and from 458 to 558°C, it was 0.184 eV. At higher temperatures, a segregation of the strontium towards the surface was observed. A calculation of the heat of segregation of Sr in carbon supports this segregation. The results show that the in situ RBS measurements with a linear increase in temperature give additional information compared with the conventional isochronal annealing.