A Multi-Output Multi-String High-Efficiency WLED Driver Using 40 nm CMOS Technology

In this work, a multi-independent-output, multi-string, high-efficiency, boost-converter-based white LED (WLED) driver architecture is proposed. It utilizes a single inductor main switch with a common maximum duty cycle controller (MDCC) in the feedback loop. A simple pulse skipping controller (PSC) is utilized in each high-side switch of the multiple independent outputs. Despite the presence of multiple independent outputs, a single over-voltage protection (OVP) circuit is used at the output to protect the circuit from any voltage above 27 V. An open circuit in any of the strings is addressed, in addition to the LED’s short-circuit conditions. Excellent current matching between strings is achieved, despite the low ON-resistance (Rdson) of transistors used in the 40 nm process. Most circuits are designed in digital CMOS logic to overcome the extreme process variations in the 40 nm node. Compared to a single output parallel strings topology, a 50% improvement in efficiency is achieved relative to extremely unbalanced strings. Three strings are used in this proposal, but more strings can be supported with the same topology. Each string is driven by a 25 mA current sink. An input voltage of 3.2–4.2 V and an output voltage up to 27 V are supported.

Simulation of double-junction III-phosphides/silicon solar cells

The characteristics of two-junction solar cells were calculated in this work, in which phosphides of group III are used as the top junction, and Si as the bottom junction. The following ternary phosphide compounds Ga0.52In0.48P (1.85 eV), GaPN0.02 (1.9 eV), and GaPN0.04 (1.7 eV) were considered as the active material of the top junction. The use of GaPN0.04 allowed one to reach the current matching with the bottom Si junction and an efficiency of 30% was achieved. In addition, the influence of the layer thickness, the lifetime of minority charge carriers and the electronic affinity on the efficiency of solar energy conversion were considered.

Numerical Simulations of 22% Efficient All-Perovskite Tandem Solar Cell Utilizing Lead-Free and Low Lead Content Halide Perovskites

Lead-free or low lead content perovskite materials are explored in photovoltaic devices to mitigate the challenges of toxic lead-based halides. However, the conversion efficiency from such materials is far below compared to its counterparts. Therefore, to make a humble contribution in the development of lead-free or low lead content perovskite solar cells (PSCs) for future thin-film photovoltaic (PV) technology, a simulation study of tin (Sn) and Pb mixed halide (MAPb0.5Sn0.5I3, 1.22 eV) PSC is carried out in this manuscript. The device is further optimized in terms of transport layer and thickness variation to get 15.1% conversion efficiency. Moreover, the optimized narrow bandgap halide (NBH) based device is further deployed in the monolithic tandem configuration with lead-free wide bandgap (1.82 eV) halide, i.e., Cs2AgBi0.75Sb0.25Br6, 1.82eV (WBH) PSC, to mitigate the thermalization as well as transparent Eg losses. Filtered spectrum, current matching, and construction of tandem J-V curve at the current matching point are utilized to design the tandem solar cell under consideration. Tandem device delivered short current density, JSC (15.21 mA.cm-2), open-circuit voltage, VOC (1.95 V), fill factor, FF (74.09 %) and power conversion efficiency, PCE (21.97%). The performance of the devices considered in this work is found to be in good approximation with experimental work.