An Aerosol Extinction Coefficient Retrieval Method and Characteristics Analysis of Landscape Images

Images based on RGB pixel values were used to measure the extinction coefficient of aerosols suspended in an atmospheric state. The pixel values of the object-image depend on the target-object reflection ratio, reflection direction, object type, distances, illumination intensity, atmospheric particle extinction coefficient, and scattering angle between the sun and the optical axes of the camera, among others. Therefore, the imaged intensity cannot directly provide information on the aerosol concentration or aerosol extinction coefficient. This study proposes simple methods to solve this problem, which yield reasonable extinction coefficients at the three effective RGB wavelengths. Aerosol size information was analogized using the RGB Ångström exponent measured at the three wavelengths for clean, dusty, rainy, Asian dust storm, and foggy days. Additionally, long-term measurements over four months showed reasonable values compared with existing PM2.5 measurements and the proposed method yields useful results.

Tetra-axial metamaterial

In this work we theoretically and numerically demonstrate that triple non-connected wire medium has four optical axes. The axes coinside with diagonals of the unit cell.

Terahertz Time-Domain Polarimetry for Principal Optical Axes of Anisotropic Crystals

We propose a method for measuring the terahertz properties for two principal optical axes of anisotropic crystals without optical activity using terahertz time-domain spectroscopy (THz-TDS). The method put forward in this paper utilizes the inherent polarization sensitivity of the THz-TDS electro-optic detection system. We demonstrate the practical application of the method by measuring the temperature dependence of the refractive index and the absorption coefficient of a lithium triborate crystal for three optical axes.

A novel system for measuring vehicle speed via analog signals of pyroelectric infrared sensors

This paper presents a method of measuring transportation vehicle’s speed via analog signals of a couple of pyroelectric infrared sensors. The measuring system is located along the roadside with the assumption that optical axes of the sensors are parallel to each other and perpendicular to the moving direction of vehicles. A cross-correlation method combined with interpolation has been used in order to determine the time delay between two output signals, thus defining the traveling speed of the target. The experiment results show that the proposed method has an error of less than 5 km/h over the speed range of 20–90 km/h.

Visualization of the Effect of an Impurity on the Optical Homogeneity of Lithium Niobate Doped with Boron Cations

The laser conoscopy method confirms the high optical uniformity of LiNbO3:B crystals in the range of B2O3 concentrations from 0.008 to 1.24 mol. %. Minor signs of anomalous optical biaxiality appear in the conoscopic patterns of crystals at boron concentrations of 0.12 and 0.83 mol. % at a laser power of 90 mW. The maximum value of the angle of anomalous optical axes for the studied samples is 2V = 10 ́ for the sample (0.12 mol. %), аnd the value of anomalous birefringence corresponds to ∆n = 0.02·10-5.

Terahertz Optical Properties of KTiOPO4 Crystal in the Temperature Range of (−192)–150 °C

This paper presents the results of an experimental study of the optical properties of highly resistive monocrystals of potassium titanyl phosphate (KTiOPO4, KTP) in the frequency range of 0.2–1 THz and the temperature range of (−192)–150 °C. The dispersion of the refractive indices is approximated in the form of Sellmeier equations. The results show that the temperature dependence of the Sellmeier coefficients for all three principal optical axes is close to linear and, most likely, does not experience an extremum in the vicinity of the activation temperatures of the cationic conductivity of the KTP crystal at (−73)–(−23) °C. Weak frequency dependence of an optical axis direction angle VZ in the range of 0.2–1 THz is confirmed. However, the change in VZ with temperature is three times higher than reported before.

Liquid-crystal-based topological photonics

Liquid crystals are complex fluids that allow exquisite control of light propagation thanks to their orientational order and optical anisotropy. Inspired by recent advances in liquid-crystal photo-patterning technology, we propose a soft-matter platform for assembling topological photonic materials that holds promise for protected unidirectional waveguides, sensors, and lasers. Crucial to our approach is to use spatial variations in the orientation of the nematic liquid-crystal molecules to emulate the time modulations needed in a so-called Floquet topological insulator. The varying orientation of the nematic director introduces a geometric phase that rotates the local optical axes. In conjunction with suitably designed structural properties, this geometric phase leads to the creation of topologically protected states of light. We propose and analyze in detail soft photonic realizations of two iconic topological systems: a Su–Schrieffer–Heeger chain and a Chern insulator. The use of soft building blocks potentially allows for reconfigurable systems that exploit the interplay between topological states of light and the underlying responsive medium.

Technology of thermally stimulated diagnostics of anisotropy and optical axes in crystals

For implementing the technology of thermally stimulated diagnostics of anisotropy and optical axes in crystals, the sample is thermostated at a temperature not exceeding the melting point, an electric field not exceeding the breakdown field is applied to the sample and polarization is produced for a time greater than the relaxation time at this temperature. After that, without switching off the electric field, the sample is cooled to the liquid nitrogen temperature, following which the field is switched off, the sample is linearly heated to a temperature above the polarization temperature and the resultant thermally stimulated depolarization (TSD) spectra taken along and perpendicular to the optical axis of the crystal are examined. When comparing the spectra the presence of anisotropy is detected and the direction of the optical axes is determined from the magnitude and presence of the TSD maxima.