Design of Magnesia–Spinel Bricks for Improved Coating Adherence in Cement Rotary Kilns

It is well known that doloma bricks present better coating adherence than magnesia–spinel bricks when applied in cement rotary kilns, which is related to the different coating formation mechanism. The coating has an essential role in prolonged operation by protecting the refractory lining; thus, it is important to improve its adherence on magnesia–spinel refractories. The objective of this investigation is to study different compositions of magnesia–spinel bricks, achieved by varying additives used (calcined alumina, limestone, hematite and zirconia) and firing temperature (1500 °C and 1700 °C), to enhance the coating adherence measured by the sandwich test. The results have pointed out that the use of higher firing temperature contributes positively to physical adherence due to well-sintered refractory structure and elevated permeability, attaining coating strength superior to 2 MPa. For the chemical adherence, the addition of 2 wt.% of limestone increased the coating strength to 3 MPa, but resulted in a drop in hot properties. In this context, the most suitable approach to improve adherence of clinker coating and maintain hot properties in suitable levels is to increase the firing temperature.

Qualitative and Quantitative Coating Tests: A Comparison in Magnesia–Spinel Refractory Bricks

In cement processing, which involves the production of clinker in rotary kilns, the main refractories used in the transition and burning zones are magnesia–spinel bricks. These bricks present suitable chemical and thermomechanical properties, not to mention that they can be easily landfilled. Among the main wear mechanisms of these bricks in the kiln, the infiltration of alkaline salts is noteworthy and occurs through the open pores of the refractory. In this way, the coating—a clinker layer adhered to the brick surface—appears as a protection mechanism of the lining against infiltration. Thus, the objective of this investigation is to run a qualitative coating test based on the contact method, and quantitative coating test based on the sandwich method to check the suitability of the methodologies and to evaluate the coating adherence on two different magnesia–spinel bricks. It was possible to distinguish the superior adherence ability of brick B in both coatings due to the higher porosity and the presence of nonreacted ZrO2. Despite the similarity between the test results, the quantitative sandwich-coating test is preferable because it does not depend on subjective analysis.

Deoxidizing effect on the low-alloyed steel's nonmetallic inclusion's compositions

The investigating results are given in the article for the deoxidizing effect on the non-metallic inclusion compositions tubes steels melted in the vacuum induction furnaces with periclase lining. The oxygen thermodynamic activity was calculated for the lanthanum, cerium, alumina and yttrium melts during four heats. The magnesia spinel inclusion's formation condition was evaluated depending on the deoxidizer's used and on the deoxidizing depth. It was shown how the reduced alumina concentration during the steel ladle treatment governs the non-metal inclusions' compositions and on the possibility of their modification during the commercial tubes steels melting.