venturi flowmeter
Recently Published Documents


TOTAL DOCUMENTS

12
(FIVE YEARS 0)

H-INDEX

1
(FIVE YEARS 0)

2020 ◽  
Vol 143 (2) ◽  
Author(s):  
Izuru Kambayashi ◽  
Donghyuk Kang ◽  
Naoki Nishimura

Abstract To examine the dynamic characteristics of turbomachinery and cavitation, the pulsating flow rates should be evaluated. As it is difficult to measure these pulsating flow rates quantitatively, systematic research has not been conducted on the dynamic characteristics of turbomachinery and cavitation. In this paper, an unsteady energy equation for a venturi tube has been proposed to measure pulsating flow rates. The pulsating flow rates were calculated using two methods based on the unsteady energy equation for incompressible flows. The first method calculated a pulsating flow rate by using the Euler method. The second one calculated the complex amplitude of a pulsating flow rate using a transfer function derived from the linearized unsteady energy equation. We analytically examined the order of magnitude for unsteady terms. The results indicated that the unknown unsteady loss was much smaller than the unsteady momentum. In the experiment, pulsating flows were generated by a reciprocating piston, and the given pulsating flow was measured using a hot wire anemometer. The pulsating flow rates evaluated by using the proposed methods were validated via numerical simulation and experiment. In particular, the influence of amplitudes on the evaluation of pulsating flow rates was numerically examined. Therefore, the nonlinear effect could be evaluated by using the proposed method, and the time-averaged loss coefficient was enough to evaluate the pulsating flow rate coefficient. The proposed unsteady venturi flowmeter can be applied to a wide range of research fields, such as analyzing dynamic characteristics of flows.


2020 ◽  
Vol 2 (5) ◽  
Author(s):  
Benjamin G. Sandberg ◽  
Michael C. Johnson ◽  
Zachary B. Sharp

2019 ◽  
Vol 1325 ◽  
pp. 012043
Author(s):  
Facai Ren ◽  
Xinghua Wu ◽  
Xiaoying Tang

2016 ◽  
Vol 21 (2) ◽  
pp. 40-46
Author(s):  
W.H. Kim ◽  
Y.J. Lee ◽  
J.S. Yang ◽  
Y.B. Kim ◽  
B.S. Kim

2016 ◽  
Author(s):  
Ö. Haldun Ünalmis ◽  
Vishal V. Raul
Keyword(s):  

1982 ◽  
Vol 104 (4) ◽  
pp. 463-467
Author(s):  
Masahiro Inoue

This paper presents a method for predicting the discharge coeffcient for a venturi flowmeter with a short laying length where the static pressure is not uniform at the throat due to streamline curvature. The discharge coefficient is determined by combining potential flow calculations and one-dimensional viscous flow considerations. For the potential flow, an accurate computational technique proposed by the author is used to calculate the pressure at the throat tap by assuming that the total pressure is equal to the average one at the throat. The average total pressure is related to the inlet pressure by use of a generalized empirical equation based on one-dimensional considerations. Validity of the method is verified by comparison with published experimental data for short venturi flowmeters.


Sign in / Sign up

Export Citation Format

Share Document