Fundamental Electromagnetic Emissions by a Weak Electron Beam in Solar Wind Plasmas with Density Fluctuations

The generation of Langmuir wave turbulence by a weak electron beam in a randomly inhomogeneous plasma and its subsequent electromagnetic radiation are studied owing to two-dimensional particle-in-cell simulations in conditions relevant to type III solar radio bursts. The essential impact of random density fluctuations of average levels of a few percents of the background plasma on the characteristics of the electromagnetic radiation at the fundamental plasma frequency ω p is shown. Not only wave nonlinear interactions but also processes of Langmuir waves’ transformations on the density fluctuations contribute to the generation of such emissions. During the beam relaxation, the amount of electromagnetic energy radiated at ω p in a plasma with density fluctuations strongly exceeds that observed when the plasma is homogeneous. The fraction of Langmuir wave energy involved in the generation of electromagnetic emissions at ω p saturates around 10−4, i.e., one order of magnitude above that reached when the plasma is uniform. Moreover, whereas harmonic emission at 2ω p dominates over fundamental emission during the time evolution in a homogeneous plasma, fundamental emission is strongly dominant when the plasma contains density fluctuations, at least during several thousands of plasma periods before being overcome by harmonic emission when the total electromagnetic energy begins to saturate.

Dynamics of Langmuir Wave Spectra in Randomly Inhomogeneous Solar Wind Plasmas

Solar coronal and wind plasmas often contain density fluctuations of various scales and amplitudes. The scattering of Langmuir wave turbulence on these inhomogeneities modifies the properties of the radiated electromagnetic emissions traveling from the Sun to the Earth. This paper shows the similarities between the physical results obtained by (i) a model based on the Zakharov equations, describing the self-consistent dynamics of Langmuir wave turbulence spectra in a plasma with external density fluctuations, and (ii) a modeling, within the framework of geometric optics approximation, of quasi-particles (representing plasmon quanta) moving in a fluctuating potential. It is shown that the dynamics of the Langmuir spectra is governed by anomalous diffusion processes, as a result of multiple scattering of waves on the density fluctuations; the same dynamics are observed in the momenta distributions of quasi-particles moving in potential structures with random inhomogeneities. These spectra and distributions are both characterized by a fast broadening during which energy is transported to larger wavevectors and momenta, exhibiting nonlinear time dependence of the average squares of wavevectors and quasi-particle momenta as well as non-Gaussian tails in the asymptotic stage. The corresponding diffusion coefficients depend on the time and are proportional to the square of the average level of density (or potential) fluctuations. It appears that anomalous transport and superdiffusion phenomena are responsible for the spectral broadening.

Comparative analysis of acoustic and electromagnetic emissions of rocks

Comparative analysis of acoustic and electromagnetic emissions recorded during the intact rock samples deformation and dynamic rupture of simulated crustal fault is presented. Specialized machines for uniaxial compression and shear tests of rock samples with identical data acquisition systems for both test cases were employed. Increase of acoustic emission was observed accompanied by significant rise of intensity and amplitude of electromagnetic signals at high stress of the rock samples under the uniaxial compression or dynamic failure in the spring-block model. Such correlation is consistent with the previous conclusions that an increase of electromagnetic emission may be considered as a rock failure precursor. Any specific characteristics of the detected electromagnetic signals to be used for prediction of impending rock failure or the earthquake fault rupture were not found. The similarity of electromagnetic signals and their spectra obtained at the press equipment and the spring-block model suggests that in both cases, the signals observed are generated by the crack formations and shear. The electromagnetic emission appeared only in dry samples. The samples saturated by water with the salinity of over 0.1% demonstrated no electromagnetic emission.

A Brief Introduction in the Mitigation of Conducted Electromagnetic Interference lssues

This paper deals with the mitigation of the influence of electromagnetic conducted emissions in low voltage grids, which can be performed using different filtering methods. Due to the relatively young age of the electromagnetic compatibility domain, the specific terminology is not yet fully consecrated. That is why the specific literature abounds in a bunch of definitions and notions, incomplete, redundant, or worse, even contradictory. Therefore, all over this paper, the terminology from the successive issues of the standard IEC 60050-161 International Electrotechnical Vocabulary, is used. The introductory section presents generalities regarding the broader context of electromagnetic compatibility in which the paper fit. Section II is devoted to measurement techniques and measuring equipment used in conducted electromagnetic interference tests, specifically for electromagnetic emissions that flow in/from the equipment under test through power lines in the standardized frequency range from 100 kHz to 30 MHz. These measurement techniques and equipment are further used in the next section which presents electromagnetic interference experiments, performed on an induction motor driven by a frequency converter. To mitigate the conducted electromagnetic emissions to fit into the standard limits, a cascade of two EMI filtering cells has been designed and implemented. This demonstrated the usefulness and effectiveness of mains EMI filters in low voltage power applications. The experiment also demonstrated that in some cases it would be necessary to retrofit more than one filtering cell

Inclusion of frequency dependences into prediction model of conducted electromagnetic emissions for a VFD motor system

This paper presents a quantitative prediction model of conducted electromagnetic emissions (EME) for a variable frequency drive (VFD) motor system based on the macro-modeling approach. This model relies on the effective representations of the frequency dependent characteristics of the parasitic behaviors between converter arms and heatsink, of shielded power cable, and of motor windings. The frequency dependent performances between converter arms and heatsink, and of the motor windings are obtained by processing measurement data. Then the vector fitting method (VFM) with passivity enforcement and circuit synthesis method are adopted to obtain the corresponding equivalent circuits. The equivalent circuit implementation of shielded power cable is achieved by applying a node-to-node admittance functions (NAFs) model, which considers the propagation phenomenon and frequency dependent losses accurately. The conducted EME model is compatible with commonly used transient circuit solvers since it only includes constant circuit elements. The conducted emissions of the VFD system are then evaluated by analyzing the common mode (CM) and differential mode (DM) voltages and currents.