Maintaining immobilization devices on trauma patients during chest and pelvic X-ray: a feasibility study

Background Most trauma systems and traumatic spinal injury guidelines mandate spinal stabilization from the site of injury to a radiological confirmation or refutal of spinal injury. Vacuum mattresses have been advocated for patients in need of prehospital spinal stabilization. Purpose To investigate the effect of different vacuum mattresses on standard resuscitation bay conventional radiography of chest and pelvis, especially regarding artefacts. Material and Methods We used a mobile X-ray machine to perform chest and pelvic conventional radiography on an anthropomorphic whole-body phantom with a trauma transfer board, three different vacuum mattresses, and without any stabilization device. The vacuum mattresses were investigated in activated, deactivated, and stretched after deactivated states. Two radiologists assessed the artefacts independently. Agreement was measured using kappa coefficient. Results All radiographs were of good technical quality and fully diagnostic. With the exception of one disagreed occurrence, artefacts were seen to hamper clinical judgment exclusively with activated vacuum mattresses. There was substantial agreement on artefact assessment. The observed agreement was 0.82 with a kappa coefficient of 0.71. The first vacuum mattress caused no artefacts hampering with clinical judgment. Conclusion Our study concludes that it is feasible to maintain some vacuum mattresses through resuscitation bay conventional radiography of chest and pelvis. They do not result in artefacts hampering with clinical judgment. Our vacuum mattress No. 1 is recommendable for this purpose. Together with our previous findings our present results indicate that some vacuum mattresses may be used throughout the initial resuscitation bay assessment and CT examination.

Vacuum mattress or long spine board: which method of spinal stabilisation in trauma patients is more time consuming? A simulation study

Background Spinal stabilisation is recommended for prehospital trauma treatment. In Germany, vacuum mattresses are traditionally used for spinal stabilisation, whereas in anglo-american countries, long spine boards are preferred. While it is recommended that the on-scene time is as short as possible, even less than 10 minutes for unstable patients, spinal stabilisation is a time-consuming procedure. For this reason, the time needed for spinal stabilisation may prevent the on-scene time from being brief. The aim of this simulation study was to compare the time required for spinal stabilisation between a scoop stretcher in conjunction with a vacuum mattress and a long spine board. Methods Medical personnel of different professions were asked to perform spinal immobilizations with both methods. A total of 172 volunteers were immobilized under ideal conditions as well as under realistic conditions. A vacuum mattress was used for 78 spinal stabilisations, and a long spinal board was used for 94. The duration of the procedures were measured by video analysis. Results Under ideal conditions, spinal stabilisation on a vacuum mattress and a spine board required 254.4 s (95 % CI 235.6–273.2 s) and 83.4 s (95 % CI 77.5–89.3 s), respectively (p < 0.01). Under realistic conditions, the vacuum mattress and spine board required 358.3 s (95 % CI 316.0–400.6 s) and 112.6 s (95 % CI 102.6–122.6 s), respectively (p < 0.01). Conclusions Spinal stabilisation for trauma patients is significantly more time consuming on a vacuum mattress than on a long spine board. Considering that the prehospital time of EMS should not exceed 60 minutes and the on-scene time should not exceed 30 minutes or even 10 minutes if the patient is in extremis, based on our results, spinal stabilisation on a vacuum mattress may consume more than 20 % of the recommended on-scene time. In contrast, stabilisation on a spine board requires only one third of the time required for that on a vacuum mattress. We conclude that a long spine board may be feasible for spinal stabilisation for critical trauma patients with timesensitive life threatening ABCDE-problems to ensure the shortest possible on-scene time for prehospital trauma treatment, not least if a patient has to be rescued from an open or inaccessible terrain, especially that with uneven overgrown land.

Remaining Cervical Spine Movement Under Different Immobilization Techniques

Background:Immobilization of the cervical spine by Emergency Medical Services (EMS) personnel is a standard procedure. In most EMS, multiple immobilization tools are available.The aim of this study is the analysis of residual spine motion under different types of cervical spine immobilization.Methods:In this explorative biomechanical study, different immobilization techniques were performed on three healthy subjects. The test subjects’ heads were then passively moved to cause standardized spinal motion. The primary endpoints were the remaining range of motion for flexion, extension, bending, and rotation measured with a wireless human motion detector.Results:In the case of immobilization of the test person (TP) on a straight (0°) vacuum mattress, the remaining rotation of the cervical spine could be reduced from 7° to 3° by additional headblocks. Also, the remaining flexion and extension were reduced from 14° to 3° and from 15° to 6°, respectively. The subjects’ immobilization was best on a spine board using a headlock system and the Spider Strap belt system (MIH-Medical; Georgsmarienhütte, Germany). However, the remaining cervical spine extension increased from 1° to 9° if a Speedclip belt system was used (Laerdal; Stavanger, Norway). The additional use of a cervical collar was not advantageous in reducing cervical spine movement with a spine board or vacuum mattress.Conclusions:The remaining movement of the cervical spine is minimal when the patient is immobilized on a spine board with a headlock system and a Spider Strap harness system or on a vacuum mattress with additional headblocks. The remaining movement of the cervical spine could not be reduced by the additional use of a cervical collar.

MAINTAINING IMMOBILISATION DEVICES ON TRAUMA PATIENTS DURING CHEST AND PELVIC X-RAY: A FEASIBILITY STUDY

BACKGROUND The aim of our study was to investigate the effect of different vacuum mattresses on standard resuscitation bay conventional radiography of chest and pelvis, especially regarding artefacts. METHODS We used a mobile X-ray machine to perform chest and pelvic conventional radiography on an anthropomorphic whole body phantom with a trauma transfer board, three different vacuum mattresses and without any stabilization device. The vacuum mattresses were investigated in activated, deactivated and stretched after deactivated states. Two radiologists assessed the artefacts independently. Agreement was measured using kappa coefficient. RESULTS All radiographs were of good technical quality and fully diagnostic. With the exception of one disagreed occurrence, artefacts were seen to hamper clinical judgement exclusively with activated vacuum mattresses. There was substantial agreement between the two radiologists on artefact assessment. The observed agreement was 0,82 with a kappa coefficient of 0,71. The first vacuum mattress caused no artefacts hampering with clinical judgment. CONCLUSION Our study concludes that it is feasible to maintain some vacuum mattresses through resuscitation bay conventional radiography of chest and pelvis. They do not result in artefacts hampering with clinical judgment. Our vacuum mattress nr 1 is recommendable for this purpose. Together with our previous findings our present results indicate that some vacuum mattresses may be used throughout the initial resuscitation bay assessment and CT examination.

A Comparison of Cervical Spine Motion After Immobilization With a Traditional Spine Board and Full-Body Vacuum-Mattress Splint

Background: The National Athletic Trainers’ Association (NATA) advocates for cervical spine immobilization on a rigid board or vacuum splint and for removal of athletic equipment before transfer to an emergency medical facility. Purpose: To (1) compare triplanar cervical spine motion using motion capture between a traditional rigid spine board and a full-body vacuum splint in equipped and unequipped athletes, (2) assess cervical spine motion during the removal of a football helmet and shoulder pads, and (3) evaluate the effect of body mass on cervical spine motion. Study Design: Controlled laboratory study. Methods: Twenty healthy male participants volunteered for this study to examine the influence of immobilization type and presence of equipment on triplanar angular cervical spine motion. Three-dimensional cervical spine kinematics was measured using an electromagnetic motion analysis system. Independent variables included testing condition (static lift and hold, 30° tilt, transfer, equipment removal), immobilization type (rigid, vacuum-mattress), and equipment (on, off). Peak sagittal-, frontal-, and transverse-plane angular motions were the primary outcome measures of interest. Results: Subjective ratings of comfort and security did not differ between immobilization types ( P > .05). Motion between the rigid board and vacuum splint did not differ by more than 2° under any testing condition, either with or without equipment. In removing equipment, the mean peak motion ranged from 12.5° to 14.0° for the rigid spine board and from 11.4° to 15.4° for the vacuum-mattress splint, and more transverse-plane motion occurred when using the vacuum-mattress splint compared with the rigid spine board (mean difference, 0.14 deg/s [95% CI, 0.05-0.23 deg/s]; P = .002). In patients weighing more than 250 lb, the rigid board provided less motion in the frontal plane ( P = .027) and sagittal plane ( P = .030) during the tilt condition and transfer condition, respectively. Conclusion: The current study confirms similar motion in the vacuum-mattress splint compared with the rigid backboard in varying sized equipped or nonequipped athletes. Cervical spine motion occurs when removing a football helmet and shoulder pads, at an unknown risk to the injured athlete. In athletes who weighed more than 250 lb, immobilization with the rigid board helped to reduce cervical spine motion. Clinical Relevance: Athletic trainers and team physicians should consider immobilization of athletes who weigh more than 250 lb with a rigid board.