Numerical Simulation of Ti-Based Metallic Glasses as Whipple Shield Bumper by Smoothed Particle Hydrodynamics Methods

The debris clouds produced by hypervelocity impacts on Ti-based metallic glasses (Ti-MGs) and Al-6061-T6 bumper were studied by smoothed particle hydrodynamics (SPH) methods. The change of the vanguard shape, dispersion and ejection angle were also obtained with the same bumper thickness to the projectile-diameter ratio (h/d). For the same h/d valve, the debris cloud of Ti-MGs bumper had a more widely dispersion and ejection angle than with Al-6061-T6 bumper; the vanguard velocity of Ti-MGs bumper was also lower than Al-6061-T6 bumper. Moreover, for the same bumper areal density, the vanguard of the debris cloud in MGs bumper was plane-shaped. This study demonstrates that Ti-MGs exhibit an excellent bumper protection performance, which asset can pave new paths for their further applications.

Experimental Study on the Effects of Slot Jet on Film Cooling Performance in the Cascade Endwall With Purge Flow

Based on the infrared temperature measurement technology, in this paper, the effect of the purge flow from the upstream slot on the film cooling performance of the annular cascade endwall was studied experimentally. GE‘s E3 turbine first stage stator blades is selected as the experimental reference blade type in this experiment. In the current experiment, effects of different slot locations, slot ejection angles and slot profiles on the endwall film cooling effectiveness were taken into account. Under the influence of endwall secondary flow, the film cooling is mainly concentrated on the front part of the channel and close to the suction side of the blade, while there is almost no cooling effect close to the pressure side of the blade in the channel. With the increase of the distance between the blade leading edge and the slot, the endwall film cooling performance is reduced. While the distance increasing from 0.15Cx to 0.45Cx, and the peak endwall film cooling effectiveness is reduced by 78%, 68% and 58% respectively when the mass flow ratio (MFR) is 1.0%, 1.5%, and 2.0%. As the slot ejection angle is reduced, the endwall film cooling performance can be effectively improved. When the slot ejection angle increased from 45° to 90°, the peak endwall film cooling effectiveness decreases by 17%, 15%, and 13% respectively at the mass flow ratio (MFR) = 1.0%,1.5% and 2.0%. And the convergent slot can effectively improve the endwall cooling film formed by slot jet compared to the reference slot. When the mass flow ratio are MFR = 1.0%, 1.5%, and 2.0%, the peak endwall film cooling effectiveness at the convergent slot is increased by 50%, 20%, and 15% comparing to the reference slot.

Research of the Ejection Angle of Guiding Device in Vertical Shaft Impact Crusher Rotor

In this paper, a new rotor with two impact in the vertical shaft impact crusher is analyzed, an effect of the angle at the guide device thrown materials on the velocity that material reach the impact plate and rebound to a anvil in the crushing chamber are discussed. three mass ejection Angle are simulated by discrete element software EDEM, and the result shows that effect of two impact of new rotor on acceleration material is best when ejection angle is 25 °.