Cement Dust Effect from Bokajan Cement Factory on Residents of Vicinity Area: A Study in Assam, India

Cement manufacturing industries are one of the most common reasons of air pollution, surface and ground water pollution and noise pollution and is also indirectly affecting the people residing near the cement plants. This study was carried out to quantify the cement dust emission from Bokajan Cement Corporation of India’s cement factory falling on the residences and to determine its effect on some selected household activities and general well-being of the people residing near it. An experimental method was carried out to estimate the accumulated cement dust in households. The findings showed that household activities performed by the residence were dependent upon the dust exposure, which means more the dusts are more are the cleaning and maintenance. It was also found that cement dust highly affected general wellbeing of the respondents living in southern direction and lowest affect was observed among the respondents of the east direction.

Modeling NOx, CO, SO2 and PM emissions from Sabzevar cement plant using SCREEN3 software

Introduction: Nowadays, the cement industry is regarded as one of the most important air pollution industries globally. This study aimed to simulate the emission of NOx, CO, SO2, and PM pollutants caused by the Sabzevar Cement Factory chimney by SCREEN3 software. Materials and Methods: In this study, the SCREEN3 software was employed for the distribution of NOx, CO, SO2, and PM pollutants. The inputs of the model include the concentration and emission of pollutant gases, physical factors associated with the cement factory chimney, wind speed and direction, ambient temperature, and stability classes. Results: The results of this study indicated that the maximum concentrations of NOx, CO, SO2, and PM by the SCREEN3 software occurred in unstable weather conditions (B) and wind speed of 5 m.s. The highest concentrations of NOx, CO, and PM (use of gas) were at a distance of 1400 meters from the factory chimney with the rates of 0.9, 0.32, 6.2 μg.m³, respectively. Moreover, the highest concentrations of NOx, CO, SO2, and PM (using fuel oil) were predicted at a distance of 1100 m from the factory chimney with 19.5, 360, 9, and 7.9 μg.m³, respectively. A comparison of the obtained results with the standard of the Environmental Protection Agency of Iran (EPA) revealed that the concentrations of NOx, CO, SO2, and PM were not higher than the standards. Conclusion: The comparison of results with EPA standard and Iranian clean air standard showed that NOX, CO, SO2, and PM concentrations were not higher than standards during the sampling period.

Assessment of environmental impacts of Rabak cement factory on vegetation and soil by cement dust

Globally, the cement industry has been identified as a factor which causes significant pollution. This study is conducted to assess environmental impacts of cement industry - Rabak Cement Factory on vegetation and soil. Standard methods were followed in collecting, preparation and examination of some plant and soil samples from the study areas. The results showed that, the mean values of soil pH, electric conductivity and moisture contents, were (7.58, 449.38 µs/cm, 4.56%), respectively in the exposed area, and (7.28, 343.63 µs/cm, 4.31%) in the unexposed area. There were significance differences between exposed and unexposed areas with regard to concentrations of oxides of elements (Fe2O3, CaO, MgO, Mn2O, Na2O and K2O) in soil and in different vegetables (Radish, Jews mallow, Fennel, Rocket) in the study area. The factory management should further provide the latest technologies to reduce industrial emissions to protect the environment and population living around the factory. Further studies are needed to investigate the impacts of cement industry on environment.