Untersuchung der Regelwerke für den passiven Schallschutz unter Berücksichtigung aktueller Verkehrslärmspektren – Teil 1

In den Regelwerken zum passiven Schallschutz von Umfassungsbauteilen wird das erforderliche Schalldämm-Maß der Fassade als Einzahlwert entsprechend dem Bewertungsverfahren nach DIN EN ISO 717-1 [1] ermittelt. Um die spektrale Zusammensetzung verschiedener Lärmquellen und die frequenzabhängige Schalldämmung von Fassadenbauteilen zu berücksichtigen, werden in den einschlägigen Regelwerken Korrektursummanden bzw. Spektrum-Anpassungswerte verwendet. Im folgenden Beitrag wird der Einfluss verschiedener Außenlärmspektren und frequenz- abhängiger Schalldämm-Maße auf den Innenpegel diskutiert. Insbesondere werden die Unterschiede zwischen Holz- und Massivbauweise bezüglich des Schutzziels bzw. des Innenpegels betrachtet. Die Untersuchungen zeigen, dass keine generelle Differenzierung zwischen Leicht- und Massivbauweise erforderlich ist. Für hochschalldämmende Leichtbaukonstruktionen mit einem Ctr,50–5000 < –8 dB wird jedoch ein Korrekturterm für das erforderliche Fassaden-Schalldämm-Maß zur Sicherstellung des Schutzziels vorgeschlagen. &nbsp; &nbsp; Summary In the regulations for passive noise protection of surrounding components, the required sound reduction index of the facade is determined as a single value according to the assessment procedure according to DIN EN ISO 717-1 [1]. In order to take into account the spectral composition of different noise sources and the frequency-dependent sound insulation of facade components, correction summands or spectrum adaptation values are used in the relevant regulations. The following article discusses the influence of various outside noise spectra and frequency-dependent sound insulation measures on the inside level. In particular, the differences between wood and solid construction were considered with regard to the protection goal and the internal level. The investigations show that no general differentiation between lightweight and solid construction is necessary. For highly sound-insulating lightweight constructions with a Ctr, 50–5000 <-8 dB, however, a correction term for the required facade soundproofing dimension to ensure the protection goal is proposed. &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;

Technical Notes: Practical Concerns Associated with Single-Number Ratings in Measuring Sound Transmission Loss Properties of Partition Panels

The paper presents an extensive review investigating the practical aspects related to the use of single- number ratings used in describing the sound insulation performance of partition wall panels and practical complications encountered in precise measurements in extensive frequency range from 50 Hz to 5 kHz. SWOT analysis of various single number ratings is described. A laboratory investigation on a double wall partition panel combination revealed the significant dependence of STC rating on transmission loss at 125 Hz attributed to 8 dB rule. An investigation conducted on devising alternative spectrums of aircraft noise, traffic noise, vehicular horn noise and elevated metro train noise as an extension to ISO 717-1 Ctr for ascertaining the sound insulation properties of materials exclusively towards these noise sources revealed that the single-number rating Rw + Ctr calculated using ISO 717-1 Ctr gives the minimum sound insulation, when compared with Rw + Cx calculated using the alternative spectrums of aircraft noise, traffic noise, etc., which means that material provides a higher sound insulation to the other noise sources. It is also observed that spectrum adaptation term Cx calculated using the spectrum of noise sources having high sound pressure levels in lower frequencies decreases as compared to ISO 717-1 Ctr owing to significant dependence of Ctr at lower frequencies.