Grinding efficiency and profile accuracy of diamond grinding wheels dressed with wire electrical discharge conditioning (WEDC)

Super abrasive diamond grinding wheels are the most promising tools for the precision machining of advanced ceramics and carbide materials. However, the efficiency of conventional conditioning of these tools is limited owing to high dressing tool wear, long process time, low form flexibility, and induced damage to the abrasive grains. Wire electrical discharge machining (WEDM) is an alternative method for conditioning of superabrasive grinding wheels with electrically conductive bonding materials. In this study, cylindrical plunge grinding of an alumina ceramic with a resin-bonded diamond grinding wheel is investigated. The assigned type of resin bond contains copper particles and is accordingly electrically conductive for wire electrical discharge conditioning (WEDC). Conventional (mechanical) and WEDC methods are used for generating the same profile on two similar diamond grinding wheels. As a result, the specific grinding energy was reduced up to 26% and 29% during rough and finish plunge grinding, respectively. Reduced specific grinding energy and forces, along with more effective grain protrusion and sharpness by using WEDC for profiling of grinding wheels, have contributed positively to the ground surface conditions despite the relatively rougher wheel surface topography in comparison to the conventional profiling. The more considerable reduction in the mean roughness depth (Rz) than in the arithmetical mean roughness value (Ra) (11% smaller Rz values in WEDC versus mechanical conditioning) verifies that the workpiece surface underwent less surface degradation in case of WEDC because of smaller grinding forces. Furthermore, the profile wear behavior of the workpiece ground with the WED conditioned grinding wheel was superior to the conventionally conditioned one.

Experimental oscillation-assisted cylindrical plunge grinding

The paper presents experimental studies of the influence of amplitude, frequency, time of oscillation and average value of the rotational speed of the workpiece on the waviness of the ground surface during cylindrical outer diameter plunge grinding on a mass-produced cylindrical grinder. Oscillations were introduced in order to counteract the development of self-excited vibrations during spark-out. The waviness of the surface was determined by a laser distance measurement system. The results of the experiments indicate the important positive influence of the oscillations applied during spark-out on the waviness of the ground surface. The conclusions of the study regarding the process as well as technology of cylindrical plunge grinding are presented.

The Effect of Grinding Wheel Contact Stiffness on Plunge Grinding Cycle

This paper presents the effect of grinding wheel contact stiffness on the plunge grinding cycle. First, it proposes a novel model of the generalized plunge grinding system. The model is applicable to all plunge grinding operations including cylindrical, centerless, shoe-centerless, internal, and shoe-internal grinding. The analysis of the model explicitly describes transient behaviors during the ramp infeed and the spark-out in the plunge grinding cycle. Clarification is provided regarding the premise that the system stiffness is composed of machine stiffness and wheel contact stiffness, and these stiffnesses significantly affect productivity and grinding accuracy. The elastic deflection of the grinding wheel is accurately measured and formulas for representing the deflection nature under various contact loads are derived. The deflection model allows us to find the non-linear contact stiffness with respect to the normal load. The contact stiffnesses of four kinds of grinding wheels with different grades and bond materials are presented. Both cylindrical grinding and centerless grinding tests are carried out, and it is experimentally revealed that the time constant at ramp infeed and spark-out is significantly prolonged by reducing the grinding force. It is verified that a simulation of the grinding tests using the proposed model can accurately predict critical parameters like forces and machine deflection during plunge grinding operations. Finally, this paper provides a guideline for grinding cycle design in order to achieve the required productivity and grinding accuracy.