scholarly journals SCALE EFFECTS INVOLVING THE BREAKING OF WAVES

2011 ◽  
Vol 1 (6) ◽  
pp. 11
Author(s):  
J. G.H.R. Diephuis

When in the period after 1953 the projects to damm up the estuaries in the south western part of the Netherlands took shape and it turned out to be necessary to let very wide discharge sluices into at least one of them, the problem arose which waves had to be taken into account at the structure before, during and after the construction. The waves occurring at high tides and storm surges are determinant for the definite shape and dimensions of the sluices. More frequently occurring waves have to be reckoned with during the construction. Though, especially in recent years, many measurements have been done in nature by the Rijkswaterstaat, supplementary calculations and model investigations appeared necessary, to determine the design criteria at rarely occurring circumstances.

1976 ◽  
Vol 1 (15) ◽  
pp. 43 ◽  
Author(s):  
Heie F. Erchinger

The height of dikes and other coastal structures can only be calculated after determination of the wave run-up. Several formulas for the calculation of wave run-up are developed after model tests as a rule. But the influences of scale effects and natural wind conditions are practically unknown. To clear these questions further investigations and especially field measurements should be carried out. By measuring the markerline of floating trash on the slope of the seadikes the maximum wave run-up could be found out after four storm surges in 1967 and 1973- In two graphs it will be shown that on the tidal flats the run-up depends on the waterdepth. The run-up was higher than it could be expected after model tests of 1954. With a newly developed special echo sounder the run-up could be measured in January 1976. The waves and the run-up could be registrated synchronously during two severe storm surges. As shown in Fig. 9 it was found a logarithmic distribution of the wave height, wave period and the higher part of the wave run-up. The found wave run-up is considerably higher than estimated before. The measured 98 % run-up is found about twice the computed value. That is an interesting and important result of the first synchronous recording of wave run-up on sea dikes.


Author(s):  
Alexander J.P. Houben ◽  
Geert-Jan Vis

Abstract Knowledge of the stratigraphic development of pre-Carboniferous strata in the subsurface of the Netherlands is very limited, leaving the lithostratigraphic nomenclature for this time interval informal. In two wells from the southwestern Netherlands, Silurian strata have repeatedly been reported, suggesting that these are the oldest ever recovered in the Netherlands. The hypothesised presence of Silurian-aged strata has not been tested by biostratigraphic analysis. A similar lack of biostratigraphic control applies to the overlying Devonian succession. We present the results of a palynological study of core material from wells KTG-01 and S05-01. Relatively low-diversity and poorly preserved miospore associations were recorded. These, nonetheless, provide new insights into the regional stratigraphic development of the pre-Carboniferous of the SW Netherlands. The lower two cores from well KTG-01 are of a late Silurian (Ludlow–Pridoli Epoch) to earliest Devonian (Lochkovian) age, confirming that these are the oldest sedimentary strata ever recovered in the Netherlands. The results from the upper cored section from the pre-Carboniferous succession in well KTG-01 and the cored sections from the pre-Carboniferous succession in well S05-01 are more ambiguous. This inferred Devonian succession is, in the current informal lithostratigraphy of the Netherlands, assigned to the Banjaard group and its subordinate Bollen Claystone formation, of presumed Frasnian (i.e. early Late Devonian) age. Age-indicative Middle to Late Devonian palynomorphs were, however, not recorded, and the overall character of the poorly preserved palynological associations in wells KTG-01 and S05-01 may also suggest an Early Devonian age. In terms of lithofacies, however, the cores in well S05-01 can be correlated to the upper Frasnian – lower Famennian Falisolle Formation in the Campine Basin in Belgium. Hence, it remains plausible that an unconformity separates Silurian to Lower Devonian strata from Upper Devonian (Frasnian–Famennian) strata in the SW Netherlands. In general, the abundance of miospore associations points to the presence of a vegetated hinterland and a relatively proximal yet relatively deep marine setting during late Silurian and Early Devonian times. This differs markedly from the open marine depositional settings reported from the Brabant Massif area to the south in present-day Belgium, suggesting a sediment source to the north. The episodic presence of reworked (marine) acritarchs of Ordovician age suggests the influx of sedimentary material from uplifted elements on the present-day Brabant Massif to the south, possibly in relation to the activation of a Brabant Arch system.


Author(s):  
Martin Verlaan ◽  
Annette Zijderveld ◽  
Hans de Vries ◽  
Jan Kroos

The accurate forecasting of storm surges is an important issue in the Netherlands. With the emergence of the first numerical hydrodynamic models for surge forecasting at the beginning of the 1980s, new demands and possibilities were raised. This article describes the main phases of the development and the present operational set-up of the Dutch continental shelf model, which is the main hydrodynamic model for storm surges in the Netherlands. It includes a brief discussion of applied data-assimilation techniques, such as Kalman filtering, the model calibration process and some thoughts on quality assurance in an operational environment. After further describing some select recent investigations, the paper concludes with some remarks on future developments in a European context.


1990 ◽  
Vol 80 (2) ◽  
pp. 430-449 ◽  
Author(s):  
William Menke ◽  
Arthur L. Lerner-Lam ◽  
Bruce Dubendorff ◽  
Javier Pacheco

Abstract Except for its very onset, the P wave of earthquakes and chemical explosions observed at two narrow-aperture arrays on hard-rock sites in the Adirondack Mountains have a nearly random polarization. The amount of energy on the vertical, radial, and transverse components is about equal over the frequency range 5 to 30 Hz, for the entire seismogram. The spatial coherence of the seismograms is approximately exp(−cfΔx), where c is in the range 0.4 to 0.7 km−1Hz−1, f is frequency and Δx is the distance between array elements. Vertical, radial, and transverse components were quite coherent over the aperture of the array, indicating that the transverse motion of the compressional wave is a property of relatively large (106 m3) volumes of rock, and not just an anomaly caused by a malfunctioning instrument, poor instrument-rock coupling, or out-crop-scale effects. The spatial coherence is approximately independent of component, epicentral azimuth and range, and whether P- or S-wave coda is being considered, at least for propagation distances between 5 and 170 km. These results imply a strongly and three-dimensionally heterogeneous crust, with near-receiver scattering in the uppermost crust controlling the coherence properties of the waves.


2016 ◽  
Vol 64 (3) ◽  
pp. 277-294 ◽  
Author(s):  
Guilherme Augusto Stefanelo Franz ◽  
Paulo Leitão ◽  
Aires dos Santos ◽  
Manuela Juliano ◽  
Ramiro Neves

Abstract The applicability of a numerical model following a downscaling methodology was evaluated for the south-eastern Brazilian shelf (regional model) and Paranaguá estuarine system (local model). This approach permits the simulation of different scale processes, such as storm surges and coastal upwelling, and is suitable for operational forecasting purposes. When large areas are covered by regional models, the tidal propagation inside the domain can be significantly affected by the local tidal potential, mainly where the resonance phenomenon is observed. The south-eastern Brazilian shelf is known for the resonance of the third-diurnal principal lunar tidal constituent (M3), the largest amplitudes being found in the Paranaguá estuarine system. Therefore, the significance of the local tidal potential was assessed in this study for the most important tidal constituents inside the estuarine system (including M3). The model validation was performed with tidal gauge data, Argo float profiles and satellite measurements of Sea Surface Temperature. The methodology described in this study can be replicated for other important estuarine systems located on the south-eastern Brazilian shelf. Furthermore, the numerical model was developed within a perspective of operational nowcast/forecast simulations, useful for several activities such as navigation and response to emergencies (e.g., oil spills).


Author(s):  
Francesco Balduzzi ◽  
Alessandro Bianchini ◽  
Riccardo Maleci ◽  
Giovanni Ferrara ◽  
Lorenzo Ferrari

Darrieus wind turbines are experiencing a renewed interest in the wind energy scenario, in particular whenever small and medium-size installations are considered. In these contexts, the average wind speeds are generally quite low due to scale effects and therefore the most exploited design choices for the turbines are the H-shape configuration, as the entire blade can take advantage of the maximum rotational radius, and high chord to radius ratios, in order to ensure suitable Reynolds numbers on the airfoils. By doing so, the aerodynamic effects induced by the motion of the airfoils in a curved flowpath become more evident and the airfoils themselves have to be designed to compensate these phenomena if conventional design tools based on the BEM theory are used. In this study, fully unsteady 2D simulations were exploited to analyze a three-bladed H-Darrieus wind turbine in order to define the real flow structure and its effects on the turbine performance; in detail, the influence of both the virtual camber and the virtual incidence were investigated. CFD results were supported by experimental data collected on full-scale models reproducing two different airfoil mountings. Finally, the proper design criteria to compensate these phenomena are proposed and their benefits on a conventional simulation with a BEM approach are discussed.


2004 ◽  
Vol 83 (4) ◽  
pp. 267-285 ◽  
Author(s):  
D.K. Munsterman ◽  
H. Brinkhuis

AbstractAn integrated stratigraphical analysis emphasizing organic-walled dinoflagellate cyst (dinocyst) distribution has been carried out on multiple boreholes penetrating the Miocene in the subsurface of the Netherlands (southern North Sea Basin). The bulk of the investigated successions is attributed to the Breda Formation, a regional lithostatigraphical unit most complete in the south-eastern part of the Netherlands. In concert with a first regional integrated bio (chrono) sequence-stratigraphical framework, fourteen informal dinocyst zones for the southern North Sea Miocene (SNSM), and three subzones are proposed for the Breda Formation. By also integrating (chrono)stratigraphic information from Mediterranean and North Atlantic dinocyst studies a first ever detailed age-model is here proposed for the Miocene in the subsurface of the Netherlands.


2014 ◽  
Vol 9 (3) ◽  
pp. 291-298 ◽  
Author(s):  
Amita A Ramcharan ◽  
Casper DJ den Heijer ◽  
Ed EJ Smeets ◽  
Margriet MJ Rouflart ◽  
Frank H van Tiel ◽  
...  

Author(s):  
M. Esquirou de Parieu

The history of the United Provinces, and of Holland especially, from the close of the Spanish rule down to the establishment of the modern monarchy of the Netherlands, is distinguished for its manifestation of a permanent struggle between different opposite principles. Liberty and authority, municipal principle and state principle, republic and monarchy, the spirit of federal isolation and that of centralization, appear to give battle to each other upon a territory itself with difficulty defended from the waves of the ocean by the watchful industry of its inhabitants.


Sign in / Sign up

Export Citation Format

Share Document