scholarly journals The growth and spectral characteristics of BaWO4:Tm3+ single crystal

2010 ◽  
Vol 59 (1) ◽  
pp. 609
Author(s):  
Zang Jing-Cun ◽  
Zheng Kai ◽  
Zou Yu-Lin ◽  
Wu Jing-Peng ◽  
Song Yan-Rong ◽  
...  
Keyword(s):  
Single Crystal ◽  
Spectral Characteristics

Ca10Li(VO4)7:Nd3+, a promising laser material: growth, structure and spectral characteristics of a Czochralski-grown single crystal

2016 ◽  
Vol 445 ◽  
pp. 101-107 ◽  
Author(s):  
M.B. Kosmyna ◽  
B.P. Nazarenko ◽  
V.M. Puzikov ◽  
A.N. Shekhovtsov ◽  
W. Paszkowicz ◽  
...  
Keyword(s):  
Single Crystal ◽  
Spectral Characteristics ◽  
Laser Material ◽  
Material Growth ◽  
Growth Structure ◽  
Grown Single Crystal

scholarly journals ANALYSIS OF THE SEPARATION METHODS OF OPTICAL SPECTRA FOR INDIVIDUAL COMPONENTS

2018 ◽  
Vol 8 (4) ◽  
pp. 8-11
Author(s):  
Victor Makhniy ◽  
Oksana Kinzerska ◽  
Illia Senko
Keyword(s):  
Comparative Analysis ◽  
Single Crystal ◽  
Spectral Characteristics ◽  
Emission Spectra ◽  
Optical Spectra ◽  
Modulation Spectroscopy ◽  
Direct Differentiation Method ◽  
Direct Differentiation ◽  
Differentiation Method

A comparative analysis of various methods for the decomposition of broad bands into individual components has been carried out. It is shown that the most universal are the methods of modulation spectroscopy and direct differentiation of conventional spectral characteristics, which, unlike the widely used Alentsev-Fock method, are applicable to spectra of any type (luminescence, transmission, absorption, etc.). The features and capabilities of the direct differentiation method are used to identify the structure in the emission spectra and transmission of ZnSe <Al> single-crystal substrates.

Spectral characteristics of Nd3+/Yb3+:YPO4 single crystal with strong multi-wavelength emission

CrystEngComm ◽  
2021 ◽  
Author(s):  
Yang Che ◽  
Fei Zheng ◽  
Jingyao Lu ◽  
Yanzhen Yin ◽  
Zhen Wang ◽  
...  
Keyword(s):  
Single Crystal ◽  
Spectral Characteristics ◽  
Multi Wavelength ◽  
Wavelength Emission

We report the growth and spectral characteristics of the 0.32 at.%Nd3+/1.2 at.%Yb3+:YPO4 crystal. Based on AlGaAs LD pumping, the Yb3+ and Nd3+ ions emission were successfully achieved simultaneously with strong...

scholarly journals Thallium(I) Tropolonates: Synthesis, Structure, Spectral Characteristics, and Antimicrobial Activity Compared to Lead(II) and Bismuth(III) Analogues

Molecules ◽  
2021 ◽  
Vol 27 (1) ◽  
pp. 183
Author(s):  
Krzysztof Lyczko ◽  
Monika Lyczko ◽  
Marzena Banasiewicz ◽  
Karolina Wegrzynska ◽  
Anna Ziółko ◽  
...  
Keyword(s):  
Antimicrobial Activity ◽  
Single Crystal ◽  
Spectral Characteristics ◽  
Luminescence Spectra ◽  
X Ray ◽  
Ft Ir

Synthesis, single-crystal X-ray determination diffraction and FT-IR, NMR (1H, 13C, 19F and 205Tl), UV–vis, and luminescence spectra characteristics were described for series of thallium(I) compounds: thallium(I) triflate (Tl(OTf)), 1:1 co-crystals of thallium(I) triflate and tropolone (Htrop), Tl(OTf)·Htrop, as well as simple thallium(I) chelates: Tl(trop) (1), Tl(5-metrop) (2), Tl(hino) (3), with Htrop, 5-methyltropolone (5-meHtrop), 4-isopropyltropolone (hinokitiol, Hhino), respectively, and additionally more complex {Tl@[Tl(hino)]6}(OTf) (4) compound. Comparison of their antimicrobial activity with selected lead(II) and bismuth(III) analogs and free ligands showed that only bismuth(III) complexes demonstrated significant antimicrobial activity, from two- to fivefold larger than the free ligands.

A Preparation of High Resolution Standards for Electron Microscopy. Part II

1971 ◽  
Vol 29 ◽  
pp. 160-161
Author(s):  
Akira Tanaka ◽  
David F. Harling
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
Carbon Black ◽  
Single Crystal ◽  
Dark Field ◽  
Graphitized Carbon Black ◽  
Graphitized Carbon ◽  
Dark Field Imaging ◽  
Crystal Films ◽  
Micro Holes

In the previous paper, the author reported on a technique for preparing vapor-deposited single crystal films as high resolution standards for electron microscopy. The present paper is intended to describe the preparation of several high resolution standards for dark field microscopy and also to mention some results obtained from these studies. Three preparations were used initially: 1.) Graphitized carbon black, 2.) Epitaxially grown particles of different metals prepared by vapor deposition, and 3.) Particles grown epitaxially on the edge of micro-holes formed in a gold single crystal film.The authors successfully obtained dark field micrographs demonstrating the 3.4Å lattice spacing of graphitized carbon black and the Au single crystal (111) lattice of 2.35Å. The latter spacing is especially suitable for dark field imaging because of its preparation, as in 3.), above. After the deposited film of Au (001) orientation is prepared at 400°C the substrate temperature is raised, resulting in the formation of many square micro-holes caused by partial evaporation of the Au film.

Structure of Palladium Single-Crystal Films Prepared by Flash Evaporation onto (001) NaCl Substrates

1970 ◽  
Vol 28 ◽  
pp. 456-457
Author(s):  
L. E. Murr ◽  
G. Wong
Keyword(s):  
Single Crystal ◽  
High Vacuum ◽  
Ultra High Vacuum ◽  
High Rate ◽  
Flash Evaporation ◽  
Optimum Load ◽  
Single Crystal Films ◽  
Crystal Films ◽  
A Current

Palladium single-crystal films have been prepared by Matthews in ultra-high vacuum by evaporation onto (001) NaCl substrates cleaved in-situ, and maintained at ∼ 350° C. Murr has also produced large-grained and single-crystal Pd films by high-rate evaporation onto (001) NaCl air-cleaved substrates at 350°C. In the present work, very large (∼ 3cm2), continuous single-crystal films of Pd have been prepared by flash evaporation onto air-cleaved (001) NaCl substrates at temperatures at or below 250°C. Evaporation rates estimated to be ≧ 2000 Å/sec, were obtained by effectively short-circuiting 1 mil tungsten evaporation boats in a self-regulating system which maintained an optimum load current of approximately 90 amperes; corresponding to a current density through the boat of ∼ 4 × 104 amperes/cm2.

Dislocations, Ordering and Antiferromagnetic Domains in MnO

1970 ◽  
Vol 28 ◽  
pp. 522-523
Author(s):  
D. J. Barber ◽  
R. G. Evans
Keyword(s):  
Electron Diffraction ◽  
Single Crystal ◽  
Optical Microscopy ◽  
Defect Chemistry ◽  
Magnetic Structures ◽  
Optically Transparent ◽  
Magnetic Features ◽  
Antiferromagnetic Domains

Manganese (II) oxide, MnO, in common with CoO, NiO and FeO, possesses the NaCl structure and shows antiferromagnetism below its Neel point, Tn∼ 122 K. However, the defect chemistry of the four oxides is different and the magnetic structures are not identical. The non-stoichiometry in MnO2 small (∼2%) and below the Tn the spins lie in (111) planes. Previous work reported observations of magnetic features in CoO and NiO. The aim of our work was to find explanations for certain resonance results on antiferromagnetic MnO.Foils of single crystal MnO were prepared from shaped discs by dissolution in a mixture of HCl and HNO3. Optical microscopy revealed that the etch-pitted foils contained cruciform-shaped precipitates, often thick and proud of the surface but red-colored when optically transparent (MnO is green). Electron diffraction and probe microanalysis indicated that the precipitates were Mn2O3, in contrast with recent findings of Co3O4 in CoO.

Electron Microscopy of Shock Loaded Polycrystalline Beryllium

1974 ◽  
Vol 32 ◽  
pp. 506-507 ◽  
Author(s):  
J. M. Galbraith ◽  
L. E. Murr ◽  
A. L. Stevens
Keyword(s):  
Electron Microscopy ◽  
Wave Propagation ◽  
Structural Change ◽  
Single Crystal ◽  
Diffraction Pattern ◽  
Shock Loading ◽  
Slip Systems ◽  
Compression Tests ◽  
X Ray Diffraction ◽  
X Ray

Uniaxial compression tests and hydrostatic tests at pressures up to 27 kbars have been performed to determine operating slip systems in single crystal and polycrystal1ine beryllium. A recent study has been made of wave propagation in single crystal beryllium by shock loading to selectively activate various slip systems, and this has been followed by a study of wave propagation and spallation in textured, polycrystal1ine beryllium. An alteration in the X-ray diffraction pattern has been noted after shock loading, but this alteration has not yet been correlated with any structural change occurring during shock loading of polycrystal1ine beryllium.This study is being conducted in an effort to characterize the effects of shock loading on textured, polycrystal1ine beryllium. Samples were fabricated from a billet of Kawecki-Berylco hot pressed HP-10 beryllium.

Studies of Oxide Formation on Copper Thin Films by Electron Microscopy

1977 ◽  
Vol 35 ◽  
pp. 316-317
Author(s):  
G. G. Hembree ◽  
M. A. Otooni ◽  
J. M. Cowley
Keyword(s):  
Electron Microscopy ◽  
Electron Diffraction ◽  
Single Crystal ◽  
Crystal Surface ◽  
Crystal Defects ◽  
Diffraction Reflection ◽  
Reaction Products ◽  
Intermediate Energies ◽  
Crystal Films ◽  
Reflection Electron Microscopy

The formation of oxide structures on single crystal films of metals has been investigated using the REMEDIE system (for Reflection Electron Microscopy and Electron Diffraction at Intermediate Energies) (1). Using this instrument scanning images can be obtained with a 5 to 15keV incident electron beam by collecting either secondary or diffracted electrons from the crystal surface (2). It is particularly suited to studies of the present sort where the surface reactions are strongly related to surface morphology and crystal defects and the growth of reaction products is inhomogeneous and not adequately described in terms of a single parameter. Observation of the samples has also been made by reflection electron diffraction, reflection electron microscopy and replication techniques in a JEM-100B electron microscope.A thin single crystal film of copper, epitaxially grown on NaCl of (100) orientation, was repositioned on a large copper single crystal of (111) orientation.

Sign in / Sign up

Export Citation Format

Share Document