Experimental and Statistical Studies for the Design of Novel Synthetic Jet Fuels Derived from Natural Gas

2011 ◽  
pp. EGPS3
Author(s):  
Nimir Elbashir
Keyword(s):  
Natural Gas ◽  
Synthetic Jet ◽  
Jet Fuels ◽  
Statistical Studies

Ignition Characteristics of a Fischer-Tropsch Synthetic Jet Fuel

2008 ◽  
Author(s):  
P. Gokulakrishnan ◽  
M. S. Klassen ◽  
R. J. Roby
Keyword(s):  
Kinetic Model ◽  
Ignition Delay ◽  
Flow Reactor ◽  
Kinetic Mechanism ◽  
Jet Fuel ◽  
Synthetic Jet ◽  
Jet Fuels ◽  
Ignition Delay Times ◽  
Delay Times ◽  
Ignition Characteristics

Ignition delay times of a “real” synthetic jet fuel (S8) were measured using an atmospheric pressure flow reactor facility. Experiments were performed between 900 K and 1200 K at equivalence ratios from 0.5 to 1.5. Ignition delay time measurements were also performed with JP8 fuel for comparison. Liquid fuel was prevaporized to gaseous form in a preheated nitrogen environment before mixing with air in the premixing section, located at the entrance to the test section of the flow reactor. The experimental data show shorter ignition delay times for S8 fuel than for JP8 due to the absence of aromatic components in S8 fuel. However, the ignition delay time measurements indicate higher overall activation energy for S8 fuel than for JP8. A detailed surrogate kinetic model for S8 was developed by validating against the ignition delay times obtained in the present work. The chemical composition of S8 used in the experiments consisted of 99.7 vol% paraffins of which approximately 80 vol% was iso-paraffins and 20% n-paraffins. The detailed kinetic mechanism developed in the current work included n-decane and iso-octane as the surrogate components to model ignition characteristics of synthetic jet fuels. The detailed surrogate kinetic model has approximately 700 species and 2000 reactions. This kinetic mechanism represents a five-component surrogate mixture to model generic kerosene-type jets fuels, namely, n-decane (for n-paraffins), iso-octane (for iso-paraffins), n-propylcyclohexane (for naphthenes), n-propylbenzene (for aromatics) and decene (for olefins). The sensitivity of iso-paraffins on jet fuel ignition delay times was investigated using the detailed kinetic model. The amount of iso-paraffins present in the jet fuel has little effect on the ignition delay times in the high temperature oxidation regime. However, the presence of iso-paraffins in synthetic jet fuels can increase the ignition delay times by two orders of magnitude in the negative temperature (NTC) region between 700 K and 900 K, typical gas turbine conditions. This feature can have a favorable impact on preventing flashback caused by the premature autoignition of liquid fuels in lean premixed prevaporized (LPP) combustion systems.

Performance of synthetic jet fuels in a meso-scale heat recirculating combustor

2014 ◽  
Vol 118 ◽  
pp. 41-47 ◽  
Author(s):  
Teresa A. Wierzbicki ◽  
Ivan C. Lee ◽  
Ashwani K. Gupta
Keyword(s):  
Synthetic Jet ◽  
Jet Fuels ◽  
Meso Scale

Experimental and Modeling Study of the Combustion of Synthetic Jet Fuels: Naphtenic Cut and Blend With a GtL Jet Fuel

2016 ◽  
Author(s):  
Philippe Dagaut ◽  
Pascal Diévart
Keyword(s):  
Air Transportation ◽  
Chemical Kinetic ◽  
Jet Fuel ◽  
Synthetic Jet ◽  
Sensitivity Analyses ◽  
Jet Fuels ◽  
Kinetic Reaction ◽  
Experimental Database ◽  
Initial Fuel ◽  
Kinetics Of

Research on the production and combustion of synthetic jet fuels has recently gained importance because of their potential for addressing security of supply and sustainable air transportation challenges. The combustion of a 100% naphtenic cut that fits with typical chemical composition of products coming from biomass or coal liquefaction (C12.64H23.64; M=175.32 g.mol−1; H/C=1.87; DCN=39; density=863.1 g.L−1) and a 50% vol. mixture with Gas to Liquid from Shell (mixture: C11.54H23.35; M=161.83 g.mol−1; H/C=2.02; DCN=46; density=800.3 g.L−1) were studied in a jetstirred reactor under the same conditions (temperature, 550–1150 K; pressure, 10 bar; equivalence ratio, 0.5, 1, and 2; initial fuel concentration, 1000 ppm). Surrogate model-fuels were designed based on fuel composition and properties for simulating the kinetics of oxidation of these fuels. We used new model-fuels consisting of mixtures of n-decane, decalin, tetralin, 2-methylheptane, 3-methylheptane, n-propyl cyclohexane, and n-propylbenzene. The detailed chemical kinetic reaction mechanism proposed was validated using the entire experimental database obtained in the present work and for the oxidation of pure GtL, we used previous results. Kinetic computations involving reaction paths analyses and sensitivity analyses were used to interpret the results.

Laminar Flame Speed Experiments of Alternative Liquid Fuels

2019 ◽  
Author(s):  
Charles L. Keesee ◽  
Bing Guo ◽  
Eric L. Petersen
Keyword(s):  
Equivalence Ratio ◽  
Laminar Flame ◽  
Initial Conditions ◽  
Synthetic Jet ◽  
Flame Speed ◽  
Liquid Fuels ◽  
Jet Fuels ◽  
Data Sets ◽  
Laminar Flame Speed ◽  
Best Parameter

Abstract New laminar flame speed experiments have been collected for multiple alternative liquid fuels. Understanding the combustion characteristics of these synthetic fuels is an important step in developing new chemical kinetics mechanisms that can be applied to real fuels. Included in this study are two synthetic Jet fuels: Syntroleum S-8 and Shell GTL. The precise composition of these fuels is known to change from sample to sample. Since these are low vapor pressure fuels, there are additional uncertainties in their introduction into gas-phase mixtures, leading to uncertainty in the mixture equivalence ratio. An in-situ laser absorption technique was implemented to verify the procedure for filling the vessel and to minimize and quantify the uncertainty in the experimental equivalence ratio. The diagnostic utilized a 3.39-μm HeNe laser in conjunction with Beer’s Law. The resulting spherically expanding flame experiments were conducted over a range of equivalence ratios from φ = 0.7 to φ = 1.5 at initial conditions of 1 atm and 403 K in the high-temperature, high-pressure constant-volume vessel at Texas A&M University. The experimental results show that both fuels have similar flame speeds with a peak value just under 60 cm/s. However, it is shown that when comparing the results from different data sets for these real fuels, equivalence ratio is not necessarily the best parameter to use. Fuel mole fraction may be a better parameter to use as it is independent of the average fuel molecule or fuel surrogate used to calculate equivalence ratio in these real fuel/air mixtures.

scholarly journals Catalytic Production of Jet Fuels from Biomass

Molecules ◽  
2020 ◽  
Vol 25 (4) ◽  
pp. 802 ◽  
Author(s):  
Manuel Antonio Díaz-Pérez ◽  
Juan Carlos Serrano-Ruiz
Keyword(s):  
Molecular Weight ◽  
Global Warming ◽  
Natural Gas ◽  
Heterogeneous Catalysts ◽  
Fossil Fuels ◽  
Fossil Fuel ◽  
Liquid Hydrocarbon ◽  
Jet Fuels ◽  
Renewable Source ◽  
The World

Concerns about depleting fossil fuels and global warming effects are pushing our society to search for new renewable sources of energy with the potential to substitute coal, natural gas, and petroleum. In this sense, biomass, the only renewable source of carbon available on Earth, is the perfect replacement for petroleum in producing renewable fuels. The aviation sector is responsible for a significant fraction of greenhouse gas emissions, and two billion barrels of petroleum are being consumed annually to produce the jet fuels required to transport people and goods around the world. Governments are pushing directives to replace fossil fuel-derived jet fuels with those derived from biomass. The present mini review is aimed to summarize the main technologies available today for converting biomass into liquid hydrocarbon fuels with a molecular weight and structure suitable for being used as aviation fuels. Particular emphasis will be placed on those routes involving heterogeneous catalysts.

scholarly journals An experimental and modeling study of burning velocities of possible future synthetic jet fuels

Energy ◽  
2012 ◽  
Vol 43 (1) ◽  
pp. 111-123 ◽  
Author(s):  
Th. Kick ◽  
J. Herbst ◽  
T. Kathrotia ◽  
J. Marquetand ◽  
M. Braun-Unkhoff ◽  
...  
Keyword(s):  
Synthetic Jet ◽  
Jet Fuels ◽  
Modeling Study
Sign in / Sign up

Export Citation Format

Share Document