scholarly journals Design of Fuzzy Logic Controller for Lateral Dynamics Control of Aircraft by Considering the Cross-Coupling Effect of Yaw and Roll on Each Other

2012 ◽  
Vol 47 (13) ◽  
pp. 44-48 ◽  
Author(s):  
Vishnu GNair ◽  
Dileep M V ◽  
Prahalad K R
2014 ◽  
Vol 612 ◽  
pp. 169-174 ◽  
Author(s):  
Anshul Sharma ◽  
C.K. Susheel ◽  
Rajeev Kumar ◽  
V.S. Chauhan

In this paper, a finite element model of piezolaminated composite shell structure is developed using nine-noded degenerated shell element. The stiffness, mass and thermo-electro-mechanical coupling effect is incorporated in finite element modeling using first order shear deformation theory and linear piezoelectric theory. The sensor voltage is calculated using the same formulation and fuzzy logic controller is used to calculate the actuator voltage. The fuzzy logic controller is designed as double input-single output (DISO) system using 49 If-Then rules. The performance of fuzzy logic controller is compared with convention constant-gain negative feedback controller. The simulation results illustrate the superiority of fuzzy logic controller over constant-gain negative feedback controller.


1992 ◽  
Vol 114 (1) ◽  
pp. 54-59 ◽  
Author(s):  
Y. Okada ◽  
B. Nagai ◽  
T. Shimane

A method of stabilizing a high speed rotor supported by magnetic bearings is presented. The magnetic bearing is controlled by a digital controller with rotationally synchronized interruption. The main problem with the rotating disc is the cross-coupling effect caused by the gyroscopic or inductive forces which sometimes make the high speed rotor unstable. Standard PID control is carried out with constant time interval interruption, while the rotational interrupt subroutine performs the cross-coupling feedback. The cross-feedback in the x-y directions well compensates for the undesirable coupling effect. This scheme is applied to a four-mass, two-bearing rotor system and its capability is tested.


2018 ◽  
Vol 07 (02n03) ◽  
pp. 1850007
Author(s):  
Lihua Wu ◽  
Yu Huang

The active vibration isolation of low-frequency tilt is important for precise scientific measurement. However, the cross-coupling effects in tilt sensitive probes introduce negative effects on the performance of active isolation devices. In this paper, we show the structure and basic principle of compound pendulum (CP)-type tiltmeter, and analyze the dynamic response of the CP to the two-dimensional tilt vibrations. Besides, we deduce theoretically the mathematical model of the capacitive sensing of the displacements of the CP. Finally, we evaluate numerically the cross-coupling effects of a tilt sensitive probe including the cross-couplings of dynamic response and the different capacitance variations in two orthogonal degrees of freedoms. The maximum of the mechanical dynamic coupling factor is less than −60[Formula: see text]dB. The total cross-coupling coefficients including the different capacitance variations of the probe are both less than [Formula: see text]. Therefore, the cross-coupling effects don’t have to be considered for this kind of two-dimensional tilt sensitive probe.


Energies ◽  
2020 ◽  
Vol 13 (3) ◽  
pp. 599 ◽  
Author(s):  
Weikun Cai ◽  
Dianguang Ma ◽  
Xiaoyang Lai ◽  
Khurram Hashmi ◽  
Houjun Tang ◽  
...  

The cross-coupling effect between the induction coils of a multiple-receiver wireless power transfer (MRWPT) system severely weakens its overall performance. In this paper, a time-sharing control strategy for MRWPT systems is proposed to reduce the cross-coupling between receiver coils. An active-bridge rectifier is introduced to the receivers to replace the uncontrollable rectifier to achieve synchronization of the time-sharing control. The synchronization signal generated by an active-bridge rectifier can be directly used to realize the synchronization of time-sharing control and hence saved the traditional zero-crossing point detection circuits for time-sharing circuits. Moreover, the proposed time-sharing system has the advantages of both operating under a resistance-matching condition and providing target output voltage for each receiver. Furthermore, a voltage control strategy was developed to provide both high efficiency and a target output voltage for each receiver. Finally, the simulation and experimental results show that the time-sharing MRWPT system reduced the cross-coupling effect between the receiver coils, and the voltage control strategy provided both a high efficiency and a target output voltage for each receiver.


Author(s):  
G. Mino-Aguilar ◽  
G.A. Muñoz-Hernández ◽  
J.F. Guerrero-Castellanos ◽  
E. Molina-Flores ◽  
A. Díaz-Sánchez ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document