Corrosion Surveys of Prestressed Bridge Members Using a Half-Cell Potential Technique

CORROSION ◽  
1997 ◽  
Vol 53 (6) ◽  
pp. 489-498 ◽  
Author(s):  
V. Novokshchenov
Keyword(s):  
Half Cell ◽  
Cell Potential

Quantifying chloride-induced corrosion from half-cell potential

1993 ◽  
Vol 23 (6) ◽  
pp. 1443-1454 ◽  
Author(s):  
R.K. Dhir ◽  
M.R. Jones ◽  
M.J. McCarthy
Keyword(s):  
Half Cell ◽  
Cell Potential ◽  
Chloride Induced Corrosion

THE EFFECT OF IMMERSION TIME ON THE CORROSION BEHAVIOR OF SUS304 IN BRINE USING HALF-CELL POTENTIAL MEASUREMENT

2016 ◽  
Vol 78 (6-9) ◽  
Author(s):  
Saber Rashid ◽  
N. Islami ◽  
A. K. Ariffin ◽  
M. Ridha ◽  
S. Fonna
Keyword(s):  
Stress Corrosion ◽  
Corrosion Behavior ◽  
Immersion Time ◽  
Plastic Anisotropy ◽  
Internal Stresses ◽  
Half Cell ◽  
Cell Potential ◽  
Potential Measurement ◽  
G 38 ◽  
The Impact

The aim of this study is to investigate the impact of immersion time, at different time values for two cases, with stressed and no stressed on materials. This study is conducted using SUS304 material with the presence of 3.5% NaCl at the range of stresses for the specimens lower than the yield strength.  The geometry of the C-ring specimen was selected for 18.974 mm and 1.244 mm for the outer diameters and the thickness respectively. The immersion time effect was investigated using the half-cell potential measurement following the ASTM G-38 standard. The approach of corrosion environment was applied to resemble the condition of loading history. Three levels of stresses were designed and applied in finite element analysis and the results known as the parameters of stress-corrosion measurement. The ASTM G-38 standard is prominent for making C-ring stress-corrosion for elastic stress analysis. The stress-corrosion test was performed at two parameters, fixed stress and no stress. The value of stresses for fixed stress was chosen for 179.199 MPa, 328.665 MPa and 460.131 MPa, correspondingly. The immersion time were selected from 0, 10 and 30 days. The electrochemical result shows that the immersion time did not affect vastly to the corrosion behavior for no stress-corrosion compared with fixed stress. The corrosion rate increases proportionally with the time immersion increments due to the inability of the steel layer protection to regenerate itself. Subsequently, it is also due to the metal was exposed to plastic deformation that resulting the internal stresses due to the plastic anisotropy of the grains.

scholarly journals Corrosion Behavior of Pre-Rusted Rebars in Cement Mortar Exposed to Harsh Environments

2020 ◽  
Vol 10 (23) ◽  
pp. 8705
Author(s):  
Gankhuyag Burtuujin ◽  
Dasom Son ◽  
Indong Jang ◽  
Chongku Yi ◽  
Hyerin Lee
Keyword(s):  
Corrosion Rate ◽  
Cement Mortar ◽  
Cement Composite ◽  
Harsh Environments ◽  
Experimental Program ◽  
Cement Composites ◽  
X Ray Diffraction ◽  
Half Cell ◽  
Cell Potential ◽  
X Ray

Rebar embedded inside reinforced concrete structures becomes corroded due to various factors. However, few studies have focused on the corrosion of pre-rusted rebar embedded in cement composites, and the findings reported thus far are inconsistent. Therefore, in this study, an experimental program was undertaken to examine the effect of pre-rusting on the further corrosion of reinforcements in cement composites. Pre-rust was induced using two different solutions (CaCl2 and HCl). The corrosion rate in the cement composite was analyzed using the half-cell potential and polarization resistance methods. In addition, scanning electron microscopy with energy-dispersive X-ray analysis and X-ray diffraction analysis were used to examine the morphology of the rust. The results show that the corrosion rate of the rebar embedded in the cement composite can be increased by more than 3.8 times depending on the pre-rust conditions (RE: 0.0009 mm/year, HCl: 0.0035 mm/year). In addition, we found that the corrosion products in the pre-rusted layer were comparable to those of the rebar corroded in the marine atmosphere.

scholarly journals Electrode State of Health Estimation for Lithium Ion Batteries Considering Half-cell Potential Change Due to Aging

2020 ◽  
Vol 167 (9) ◽  
pp. 090531
Author(s):  
Suhak Lee ◽  
Jason B. Siegel ◽  
Anna G. Stefanopoulou ◽  
Jang-Woo Lee ◽  
Tae-Kyung Lee
Keyword(s):  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Potential Change ◽  
State Of Health ◽  
Half Cell ◽  
Cell Potential

scholarly journals EXPERIMENTAL STUDY ON INSPECTION OF CARBONATION-INDUCED CORROSION WITH HALF-CELL POTENTIAL MEASUREMENT

2005 ◽  
pp. 21-34 ◽  
Author(s):  
Motohiro NAKAGAWA ◽  
Syuji IKUTA ◽  
Takeshi TAKAGI ◽  
Atsushi HATTORI ◽  
Toyoaki MIYAGAWA
Keyword(s):  
Experimental Study ◽  
Half Cell ◽  
Cell Potential ◽  
Potential Measurement

Half cell potential of the Pd,Pd2+Couple in 3·94-molal perchloric acid and the entropy of Pd2+(aq)

1970 ◽  
Vol 0 (0) ◽  
pp. 2514-2515 ◽  
Author(s):  
Reed M. Izatt ◽  
Delbert J. Eatough ◽  
Curtis E. Morgan ◽  
James J. Christensen
Keyword(s):  
Perchloric Acid ◽  
Half Cell ◽  
Cell Potential
Sign in / Sign up

Export Citation Format

Share Document