Insight into the water recovery characteristics of tetrabutylphosphonium hydrogen maleate ionic liquid draw solute in forward osmosis process

2019 ◽  
pp. 183-189
Author(s):  
Po-I Liu ◽  
Li-Ching Chung ◽  
David C. Wang ◽  
Chia-Hua Ho ◽  
Tzu-Yu Cheng ◽  
...  
Keyword(s):  
Ionic Liquid ◽  
Forward Osmosis ◽  
Water Recovery ◽  
Insight Into

scholarly journals Using Reverse Osmosis Membrane at High Temperature for Water Recovery and Regeneration from Thermo-Responsive Ionic Liquid-Based Draw Solution for Efficient Forward Osmosis

Membranes ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 588
Author(s):  
Eiji Kamio ◽  
Hiroki Kurisu ◽  
Tomoki Takahashi ◽  
Atsushi Matsuoka ◽  
Tomohisa Yoshioka ◽  
...  
Keyword(s):  
Ionic Liquid ◽  
High Temperature ◽  
Energy Saving ◽  
Osmotic Pressure ◽  
Reverse Osmosis ◽  
Forward Osmosis ◽  
Solution Temperature ◽  
Water Recovery ◽  
Temperature Dependent ◽  
Draw Solution

Forward osmosis (FO) membrane process is expected to realize energy-saving seawater desalination. To this end, energy-saving water recovery from a draw solution (DS) and effective DS regeneration are essential. Recently, thermo-responsive DSs have been developed to realize energy-saving water recovery and DS regeneration. We previously reported that high-temperature reverse osmosis (RO) treatment was effective in recovering water from a thermo-responsive ionic liquid (IL)-based DS. In this study, to confirm the advantages of the high-temperature RO operation, thermo-sensitive IL-based DS was treated by an RO membrane at temperatures higher than the lower critical solution temperature (LCST) of the DS. Tetrabutylammonium 2,4,6-trimethylbenznenesulfonate ([N4444][TMBS]) with an LCST of 58 °C was used as the DS. The high-temperature RO treatment was conducted at 60 °C above the LCST using the [N4444][TMBS]-based DS-lean phase after phase separation. Because the [N4444][TMBS]-based DS has a significantly temperature-dependent osmotic pressure, the DS-lean phase can be concentrated to an osmotic pressure higher than that of seawater at room temperature (20 °C). In addition, water can be effectively recovered from the DS-lean phase until the DS concentration increased to 40 wt%, and the final DS concentration reached 70 wt%. From the results, the advantages of RO treatment of the thermo-responsive DS at temperatures higher than the LCST were confirmed.

Dynamics of Ion Locking in Doubly Polymerized Ionic Liquids

2020 ◽  
Author(s):  
Swati Arora ◽  
Julisa Rozon ◽  
Jennifer Laaser
Keyword(s):  
Dielectric Constant ◽  
Ionic Liquid ◽  
Ionic Liquids ◽  
Ion Pairs ◽  
Polymer Chains ◽  
Ion Motion ◽  
Charged Species ◽  
Broadband Dielectric Spectroscopy ◽  
Covalently Linked ◽  
Insight Into

<div>In this work, we investigate the dynamics of ion motion in “doubly-polymerized” ionic liquids (DPILs) in which both charged species of an ionic liquid are covalently linked to the same polymer chains. Broadband dielectric spectroscopy is used to characterize these materials over a broad frequency and temperature range, and their behavior is compared to that of conventional “singly-polymerized” ionic liquids (SPILs) in which only one of the charged species is attached to the polymer chains. Polymerization of the DPIL decreases the bulk ionic conductivity by four orders of magnitude relative to both SPILs. The timescales for local ionic rearrangement are similarly found to be approximately four orders of magnitude slower in the DPILs than in the SPILs, and the DPILs also have a lower static dielectric constant. These results suggest that copolymerization of the ionic monomers affects ion motion on both the bulk and the local scales, with ion pairs serving to form strong physical crosslinks between the polymer chains. This study provides quantitative insight into the energetics and timescales of ion motion that drive the phenomenon of “ion locking” currently under investigation for new classes of organic electronics.</div>

scholarly journals Evaluating Fertilizer-Drawn Forward Osmosis Performance in Treating Anaerobic Palm Oil Mill Effluent

Membranes ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 566
Author(s):  
Ruwaida Abdul Wahid ◽  
Wei Lun Ang ◽  
Abdul Wahab Mohammad ◽  
Daniel James Johnson ◽  
Nidal Hilal
Keyword(s):  
Palm Oil ◽  
Pure Water ◽  
Water Flux ◽  
Forward Osmosis ◽  
Salt Flux ◽  
Palm Oil Mill Effluent ◽  
Performance Ratio ◽  
Water Recovery ◽  
Flux Decline ◽  
Palm Oil Mill

Fertilizer-drawn forward osmosis (FDFO) is a potential alternative to recover and reuse water and nutrients from agricultural wastewater, such as palm oil mill effluent that consists of 95% water and is rich in nutrients. This study investigated the potential of commercial fertilizers as draw solution (DS) in FDFO to treat anaerobic palm oil mill effluent (An-POME). The process parameters affecting FO were studied and optimized, which were then applied to fertilizer selection based on FO performance and fouling propensity. Six commonly used fertilizers were screened and assessed in terms of pure water flux (Jw) and reverse salt flux (JS). Ammonium sulfate ((NH4)2SO4), mono-ammonium phosphate (MAP), and potassium chloride (KCl) were further evaluated with An-POME. MAP showed the best performance against An-POME, with a high average water flux, low flux decline, the highest performance ratio (PR), and highest water recovery of 5.9% for a 4-h operation. In a 24-h fouling run, the average flux decline and water recovered were 84% and 15%, respectively. Both hydraulic flushing and osmotic backwashing cleaning were able to effectively restore the water flux. The results demonstrated that FDFO using commercial fertilizers has the potential for the treatment of An-POME for water recovery. Nevertheless, further investigation is needed to address challenges such as JS and the dilution factor of DS for direct use of fertigation.

Effect of temperature on the osmotic behavior of LCST type ionic liquid solutions as draw solutions in the forward osmosis process

2021 ◽  
pp. 119164
Author(s):  
Eiji Kamio ◽  
Hiroki Kurisu ◽  
Tomoki Takahashi ◽  
Atsushi Matsuoka ◽  
Tomohisa Yoshioka ◽  
...  
Keyword(s):  
Ionic Liquid ◽  
Forward Osmosis ◽  
Effect Of Temperature ◽  
Liquid Solutions ◽  
Osmotic Behavior

scholarly journals EVALUATION OF BACTERIAL CELLULOSE-SODIUM ALGINATE FORWARD OSMOSIS MEMBRANE FOR WATER RECOVERY

2018 ◽  
Vol 80 (3-2) ◽  
Author(s):  
Ngan T. B. Dang ◽  
Liza B. Patacsil ◽  
Aileen H. Orbecido ◽  
Ramon Christian P. Eusebio ◽  
Arnel B. Beltran
Keyword(s):  
Contact Angle ◽  
Bacterial Cellulose ◽  
Sodium Alginate ◽  
Water Flux ◽  
Forward Osmosis ◽  
Composite Membranes ◽  
Membrane Thickness ◽  
Water Recovery ◽  
Sem Images ◽  
Salt Rejection

Water resources are very important to sustain life. However, these resources have been subjected to stress due to population growth, economic and industrial growth, pollution and climate change. With these, the recovery of water from sources such as wastewater, dirty water, floodwater and seawater is a sustainable alternative. The potential of recovering water from these sources could be done by utilizing forward osmosis, a membrane process that exploits the natural osmotic pressure gradient between solutions which requires low energy operation. This study evaluated the potential of forward osmosis (FO) composite membranes fabricated from bacterial cellulose (BC) and modified with sodium alginate. The membranes were evaluated for water flux and salt rejection. The effect of alginate concentrations and impregnation temperatures were evaluated using 0.6 M sodium chloride solution as feed and 2 M glucose solution as the draw solution. The membranes were characterized by Scanning Electron Microscopy (SEM), Fourier Transform Infrared Spectroscopy (FTIR), and Contact Angle Meter (CAM). The use of sodium alginate in BC membrane showed a thicker membrane (38.3 μm to 67.6 μm), denser structure (shown in the SEM images), and more hydrophilic (contact angle ranges from 28.39° to 32.97°) compared to the pristine BC membrane (thickness = 12.8 μm and contact angle = 66.13°). Furthermore, the alginate modification lowered the water flux of the BC membrane from 9.283 L/m2-h (LMH) to value ranging from 2.314 to 4.797 LMH but the improvement in salt rejection was prominent (up to 98.57%).

Insight into the Microenvironments of the Metal–Ionic Liquid Interface during Electrochemical CO2 Reduction

ACS Catalysis ◽  
2018 ◽  
Vol 8 (3) ◽  
pp. 2420-2427 ◽  
Author(s):  
Hyung-Kyu Lim ◽  
Youngkook Kwon ◽  
Han Seul Kim ◽  
Jiwon Jeon ◽  
Yong-Hoon Kim ◽  
...  
Keyword(s):  
Ionic Liquid ◽  
Co2 Reduction ◽  
Liquid Interface ◽  
Electrochemical Co2 Reduction ◽  
Insight Into

scholarly journals Biofouling Mitigation Approaches during Water Recovery from Fermented Broth via Forward Osmosis

Membranes ◽  
2020 ◽  
Vol 10 (11) ◽  
pp. 307
Author(s):  
Stavros Kalafatakis ◽  
Agata Zarebska ◽  
Lene Lange ◽  
Claus Hélix-Nielsen ◽  
Ioannis V. Skiadas ◽  
...  
Keyword(s):  
Flow Velocity ◽  
Forward Osmosis ◽  
Cross Flow ◽  
Feed Solution ◽  
Mitigation Strategies ◽  
Water Recovery ◽  
Operational Parameters ◽  
Solution Ph ◽  
Sustainable Solutions ◽  
Cross Flow Velocity

Forward Osmosis (FO) is a promising technology that can offer sustainable solutions in the biorefinery wastewater and desalination fields, via low energy water recovery. However, microbial biomass and organic matter accumulation on membrane surfaces can hinder the water recovery and potentially lead to total membrane blockage. Biofouling development is a rather complex process and can be affected by several factors such as nutrient availability, chemical composition of the solutions, and hydrodynamic conditions. Therefore, operational parameters like cross-flow velocity and pH of the filtration solution have been proposed as effective biofouling mitigation strategies. Nevertheless, most of the studies have been conducted with the use of rather simple solutions. As a result, biofouling mitigation practices based on such studies might not be as effective when applying complex industrial mixtures. In the present study, the effect of cross-flow velocity, pH, and cell concentration of the feed solution was investigated, with the use of complex solutions during FO separation. Specifically, fermentation effluent and crude glycerol were used as a feed and draw solution, respectively, with the purpose of recirculating water by using FO alone. The effect of the abovementioned parameters on (i) ATP accumulation, (ii) organic foulant deposition, (iii) total water recovery, (iv) reverse glycerol flux, and (v) process butanol rejection has been studied. The main findings of the present study suggest that significant reduction of biofouling can be achieved as a combined effect of high-cross flow velocity and low feed solution pH. Furthermore, cell removal from the feed solution prior filtration may further assist the reduction of membrane blockage. These results may shed light on the challenging, but promising field of FO process dealing with complex industrial solutions.

Sign in / Sign up

Export Citation Format

Share Document