Mixture Formation During Cold Starting and Warm-up in Spark Ignition Engines

1996 ◽  
Author(s):  
Yoshishige Ohyama ◽  
Teruo Yamauchi ◽  
Minoru Ohsuga
Energies ◽  
2021 ◽  
Vol 14 (3) ◽  
pp. 779
Author(s):  
Ashraf Elfasakhany

Biofuels are receiving increased scientific attention, and recently different biofuels have been proposed for spark ignition engines. This paper presents the state of art of using biofuels in spark ignition engines (SIE). Different biofuels, mainly ethanol, methanol, i-butanol-n-butanol, and acetone, are blended together in single dual issues and evaluated as renewables for SIE. The biofuels were compared with each other as well as with the fossil fuel in SIE. Future biofuels for SIE are highlighted. A proposed method to reduce automobile emissions and reformulate the emissions into new fuels is presented and discussed. The benefits and weaknesses of using biofuels in SIE are summarized. The study established that ethanol has several benefits as a biofuel for SIE; it enhanced engine performance and decreased pollutant emissions significantly; however, ethanol showed some drawbacks, which cause problems in cold starting conditions and, additionally, the engine may suffer from a vapor lock situation. Methanol also showed improvements in engine emissions/performance similarly to ethanol, but it is poisonous biofuel and it has some sort of incompatibility with engine materials/systems; its being miscible with water is another disadvantage. The lowest engine performance was displayed by n-butanol and i-butanol biofuels, and they also showed the greatest amount of unburned hydrocarbons (UHC) and CO emissions, but the lowest greenhouse effect. Ethanol and methanol introduced the highest engine performance, but they also showed the greatest CO2 emissions. Acetone introduced a moderate engine performance and the best/lowest CO and UHC emissions. Single biofuel blends are also compared with dual ones, and the results showed the benefits of the dual ones. The study concluded that the next generation of biofuels is expected to be dual blended biofuels. Different dual biofuel blends are also compared with each other, and the results showed that the ethanol–methanol (EM) biofuel is superior in comparison with n-butanol–i-butanol (niB) and i-butanol–ethanol (iBE).


Author(s):  
Shenghua Liu ◽  
Yi Li ◽  
Guangle Li ◽  
Lei Chi

Methanol and ethanol are known as potential alcohol alternative fuels for spark ignition Engines, which can be blended with gasoline to increase oxygen content and to decrease emissions. Six kinds of fuels were prepared, which were commercial 93#gasoline, M10, M20, M30, E10 and E20. With a constant volume bomb, flame propagation speeds were studied under different temperatures, exhaust dilution and air fuel ratios. The flame radiuses were used to calculate the flame speed. The results indicate that methanol can increase flame speed no matter with or without exhaust dilution. At the ambient temperature of 5°C and 15°C, engine cold starting tests prove that methanol can improve engine combustion and lower HC and CO emissions during the first 200 seconds, while ethanol has little effects at the same conditions.


Author(s):  
D J Boam ◽  
I C Finlay ◽  
T W Biddulph ◽  
T A Ma ◽  
R Lee ◽  
...  

The results of a three-year collaborative research study into the sources of unburnt hydrocarbon (uHC) emissions are reported. The study sought to extend existing knowledge of the sources in an engine to the crucial period following a cold start and before the exhaust catalyst becomes fully effective. The study, carried out on a range of engines but centred on the Rover M 16 four-valve engine, identified a number of sources, all of which are equally important in the warm-up period. The paper concludes with some recommendations for the control of uHC emissions


Sign in / Sign up

Export Citation Format

Share Document