Investigations on the Combined Effect of Oxygen Enrichment and Water Injection Techniques on Engine’s Performance, Emission and Combustion of a Mahua Oil Based Compression Ignition Engine

Author(s):  
Senthil Kumar Masimalai ◽  
Nataraj Ganesan ◽  
S Pasupathiraju ◽  
T Mohanraj
Fuel ◽  
2021 ◽  
Vol 284 ◽  
pp. 119007
Author(s):  
A.K. Mohamed Farmaan ◽  
R. Mukund ◽  
S. Arun Prakash ◽  
P. Pradeep ◽  
V. Antony Aroul Raj ◽  
...  

2016 ◽  
Vol 138 (3) ◽  
Author(s):  
SenthilKumar Masimalai ◽  
Sasikumar Nandagopal

This paper aims at studying the combined effect of oxygen enrichment and dual fueling on performance, emission, and combustion characteristics of a mono cylinder diesel engine using a blend of cashew nut shell pyro oil (CSO) and conventional diesel oil (called BD—base diesel) as fuel. Experiments were initially conducted using 100% BD as fuel at variable power output conditions. Subsequently, experiments were repeated with CSO40D60 (blend of 40% of CSO and 60% of BD by volume) at different power outputs. In the third phase, the engine was run with oxygen enrichment of 24% by volume in the intake air using CSO40D60 as fuel. Finally, the engine was operated in dual fuel mode of operation with the oxygen concentrations of 24% using CSO40D60 as pilot fuel and ethanol as the primary inducted fuel. Ethanol induction was made up to the maximum possible limit until misfire or knock. The brake thermal efficiency (BTE) was found as 25% with CSO40D60 29.5% and 30.5% with BD at the rated power output of 3.7 kW. The smoke number was noted as 55 filter smoke number (FSN) and 40 FSN, respectively, with CSO40D60 and BD. Hydrocarbon (HC) and carbon monoxide (CO) emissions were found to be higher with CSO40D60 as compared to BD. Ignition delay (ID) and combustion duration (CD) were also noted to be higher with CSO40D60 at all power outputs. Combined oxygen enrichment and ethanol induction sufficiently increased the BTE using CSO40D60 as fuel at all power outputs. At peak power output, the BTE was noted as 34.5%. The lowest smoke number of 36 FSN was found for 24% of oxygen with 34.3% of ethanol energy share at peak power output with CSO40D60 as fuel, whereas it was 40 FSN with BD and 55 FSN with CSO40D60 for 21% of oxygen. Significant improvement in heat release rates was observed by combining ethanol induction and oxygen enrichment techniques using CSO40D60 as fuel. Overall, it is concluded that by combining oxygen enrichment and ethanol induction superior performance and reduced emissions can be achieved at all power outputs using CSO40D60 as fuel.


2020 ◽  
Vol 24 (1 Part A) ◽  
pp. 75-86
Author(s):  
Senthilkumar Masimalai

The effect of water injection at the air side and water addition at fuel side on engine?s performance of a Diesel engine was studied under oxygen enriched intake air using neat mahua oil as fuel. Initially experiments were carried out using neat mahua oil as fuel with different oxygen concentrations such as 21% (ambient), 22.4%, 23.8%, and 24.7% by volume at the air side. The optimal oxygen concentration was found based on the engine?s brake thermal efficiency. At the optimal oxygen concentration water injection was done on air side at 4% by mass and the experiments were repeated with neat mahua oil as fuel under oxygen enrichment mode. Finally, mahua oil emulsion was prepared using the same amount of water (i. e. 4%) and tested in the engine. A comparative study was made for the same amount of water (i. e. 4% as optimal) for water injection and neat mahua oil emulsion on engines behavior. Oxygen enrichment increased the brake thermal efficiency with all concentrations and reached the maximum value from 25.2% with ambient oxygen to a maximum of 30.6% at 23.8% of oxygen enrichment at the maximum brake mean effective pressure of 5.4 bar whereas it was 30.8% with neat diesel. The smoke, HC, and CO emissions were significantly reduced with oxygen enrichment. However, oxygen enrichment increased the NO emissions at all concentrations. Injection of water and emulsification techniques reduced the NO emissions considerably. Emulsification showed more reduction in NO emission than water injection for the same amount of water. It was concluded from the study that neat mahua oil could be effective used as fuel in compression ignition engines by combusting it under oxygen enriched condition. The optimal oxygen concentration of 23.8% could be recommended for the highest brake thermal efficiency. Injection of water at the intake manifold and emulsification techniques could solve the problem of higher NO emissions. The optimal amount of water that could be injected without affecting the engines power and brake thermal efficiency could be recommended as 4% by volume. Emulsification has the added advantage of further improvement in engine?s brake thermal efficiency.


Heat Transfer ◽  
2019 ◽  
Vol 49 (2) ◽  
pp. 858-871
Author(s):  
Mohammed Kareemullah ◽  
Asif Afzal ◽  
K. Fazlur Rehman ◽  
Kiran Shahapurkar ◽  
Hurmathulla Khan ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document