Expansion of the Operating Range with In-Cylinder Water Injection in a Premixed Charge Compression Ignition Engine

Author(s):  
Naoya Kaneko ◽  
Hirokazu Ando ◽  
Hideyuki Ogawa ◽  
Noboru Miyamoto
2005 ◽  
Vol 6 (4) ◽  
pp. 341-359 ◽  
Author(s):  
H Ogawa ◽  
N Miyamoto ◽  
N Kaneko ◽  
H Ando

Light naphtha, which exhibits two-stage ignition, was induced from the intake manifold and water or a low-ignitability fuel, which does not exhibit low temperature oxidation, was directly injected early in the compression stroke for ignition suppression in an homogeneous charge compression ignition (HCCI) engine. Their quantitative balance was flexibly controlled to optimize ignition timing according to operating conditions. Ultra-low NOx and smokeless combustion without knocking or misfiring was realized over a wide operating range with water or alcohol injection. The water injection significantly reduced the low-temperature oxidation, which suppressed the increase in charge temperature and the rapid combustion caused by the high-temperature oxidation. Rapid combustion was suppressed by reductions in the maximum in-cylinder gas temperature due to water injection while the combustion efficiency suffered. Therefore, the maximum charge temperature needs to be controlled within an extremely limited range to maintain a satisfactory compromise between mild combustion and high combustion efficiency. Alcohols inhibit low-temperature oxidation more strongly than other oxygenated or unoxygenated hydrocarbons, water, and hydrogen. Chemical kinetic modelling with methanol showed a reduction of OH radical before the onset of low-temperature oxidation, and this may be the main mechanism by which alcohols inhibit low-temperature oxidation.


Author(s):  
Seyfi Polat ◽  
Hamit Solmaz ◽  
Ahmet Uyumaz ◽  
Alper Calam ◽  
Emre Yılmaz ◽  
...  

Abstract In this study, the effects of negative valve overlap (NVO) on homogenous charge compression ignition (HCCI) combustion and engine performance were experimentally investigated. A four stroke, single cylinder, port injection HCCI engine was operated at −16 deg crank angle (CA), −8 deg CA, and +8 deg CA valve overlap values and different lambda values and engine speeds at wide open throttle. RON40 and RON60 were used as test fuels in view of combustion and performance characteristics in HCCI mode. The variations of indicated mean effective pressure (IMEP), residual gas, CA50, indicated thermal efficiency (ITE), indicated specific fuel consumption (ISFC), maximum pressure rise rate (MPRR) and ringing intensity (RI) were observed on HCCI combustion. The results showed that NVO caused to trap residual gases in the combustion chamber. Hot residual gases showed heating and dilution effect on HCCI combustion. Combustion was retarded with the presence of residual gas at −16 deg CA NVO. Test results showed that higher imep and maximum in-cylinder pressure were obtained with RON60 according to RON40. As expected, CA50 was obtained later with RON60 compared to RON40 due to more resistance of auto-ignition. RON60 residual gas prevented the rapid and sudden combustion due to higher heat capacity of charge mixture. RI decreased with the usage of RON60 compared to RON40. Significant decrease was seen on RI with RON60 especially at lower lambda values. It was seen that HCCI combustion can be controlled with NVO and operating range of HCCI engines can be extended.


Sign in / Sign up

Export Citation Format

Share Document