Impact of Supplemental Natural Gas on Engine Efficiency, Performance, and Emissions

2013 ◽  
Author(s):  
Claire Maxey ◽  
Vickey Kalaskar ◽  
Dongil Kang ◽  
Andre Boehman
Keyword(s):  
Natural Gas ◽  
Engine Efficiency ◽  
Performance And Emissions ◽  
Efficiency Performance

Performance and Emissions of a Natural Gas Fueled Two-Stroke SI Engine

2008 ◽  
Author(s):  
A. Gimelli ◽  
C. Cascone ◽  
O. Pennacchia ◽  
A. Unich ◽  
P. Capaldi
Keyword(s):  
Natural Gas ◽  
Si Engine ◽  
Performance And Emissions ◽  
Gas Fueled

scholarly journals Performance and Emissions Comparison between Biomethane and Natural Gas Fuel in Passenger Vehicles

2020 ◽  
Vol 197 ◽  
pp. 08019
Author(s):  
Fabio Cignini ◽  
Antonino Genovese ◽  
Fernando Ortenzi ◽  
Stefano Valentini ◽  
Alberto Caprioli
Keyword(s):  
Sewage Sludge ◽  
Natural Gas ◽  
Ghg Emissions ◽  
Research Centre ◽  
Passenger Cars ◽  
Gas Engine ◽  
Natural Gas Engine ◽  
Viable Solution ◽  
Performance And Emissions ◽  
Emilia Romagna Region

Bio-methane as fuel in a natural gas engine is a viable solution to reduce greenhouse gas emissions. The present paper illustrates the results of the first set of measurements carried out in the BiomethER project (EULIFE). BiomethER aimed to design and build two innovative bio-methane production plants, located in Emilia Romagna region (Italy), fed by different feedstock: the first one with sewage sludge and the other with landfill waste. Biogas extracted by the anaerobic digester was cleaned and upgraded to biomethane for road vehicles application. To verify the compatibility of biomethane in conventional compressed natural gas engine (CNG) vehicles, three passenger cars have been tested with two gases: conventional natural gas and bio-methane coming by BiomethER sewage sludge plant. Test concerned dynamic performances and exhaust emissions and was operated on the chassis dynamometer facility, in ENEA Casaccia Research Centre. Preliminary results showed no appreciable deviation was noticeable for fuel consumption and CO2 emissions between the two fuels, acceleration and maximum power were almost the same for the three vehicles tested. The WTW evaluation of GHG emissions for the biomethane resulted in up to 79% lower in comparison with natural gas provided by the Italian pipeline.

Predicting the Performance and Emissions Characteristics of a Medium Duty Engine Retrofitted with Compressed Natural Gas System Using 1-Dimensional Software

2014 ◽  
Vol 699 ◽  
pp. 702-707
Author(s):  
Ahmad Jais Alimin ◽  
Muhammad Yusri Ismail ◽  
Shahrul Azmir Osman
Keyword(s):  
Natural Gas ◽  
Alternative Fuel ◽  
Simulation Software ◽  
Compressed Natural Gas ◽  
Operational Conditions ◽  
Performance And Emissions ◽  
Power Models ◽  
Cng Engine ◽  
Experimental Process ◽  
Dimensional Simulation

The rise of crude oil price and the implications of exhaust emissions to the environment from combustion application call for a new reliable alternative fuel. A potential alternative fuel for compression ignition (C.I.) engine is the compressed natural gas (CNG). For C.I. engines to operate using CNG, or to be converted as a retrofitted CNG engine, further modifications are required. Previous works reported loss in brake power (BP) and increase in hydrocarbon (HC) emission for C.I. engine retrofitted with CNG fuelling. Verification of performance characteristics for CNG retrofitted engine through experimental analysis requires high cost and is very time consuming. Thus, a 1-Dimensional simulation software, GT-Power, was introduced in this study to reduce the experimental process and setup. A 4-cylinder medium duty C.I. engine (DE) and CNG retrofitted engine (RE) GT-Power models were used in this simulation work over various operational conditions: low, medium and high load conditions. As compared with DE model, results from RE model showed that RE model achieved an average 4.9% improvement for brake specific fuel consumption (BSFC) and loss in BP by 37.3%. For nitrogen oxides (NOX) and carbon dioxides (CO2) RE model predicted reduction of 48.1% (engine mode 1-9) and 33.4% (all engine modes), respectively. Moreover, RE produced 72.4% more carbon monoxide (CO) and 90.3% more HC emission.

Combustion characteristics of compressed natural gas/diesel dual-fuel turbocharged compressed ignition engine

2003 ◽  
Vol 217 (9) ◽  
pp. 833-838 ◽  
Author(s):  
Liu Shenghua ◽  
Zhou Longbao ◽  
Wang Ziyan ◽  
Ren Jiang
Keyword(s):  
Natural Gas ◽  
Ignition Delay ◽  
Combustion Characteristics ◽  
Operating Conditions ◽  
Dual Fuel ◽  
Compressed Natural Gas ◽  
Delay Effects ◽  
Low Load ◽  
Performance And Emissions ◽  
Ci Engine

The combustion characteristics of a turbocharged natural gas and diesel dual-fuelled compression ignition (CI) engine are investigated. With the measured cylinder pressures of the engine operated on pure diesel and dual fuel, the ignition delay, effects of pilot diesel and engine load on combustion characteristics are analysed. Emissions of HC, CO, NOx and smoke are measured and studied too. The results show that the quantity of pilot diesel has important effects on the performance and emissions of a dual-fuel engine at low-load operating conditions. Ignition delay varies with the concentration of natural gas. Smoke is much lower for the developed dual-fuel engine under all the operating conditions.

scholarly journals A Thermodynamic Analysis of Tubular SOFC Based Hybrid Systems

2001 ◽  
Author(s):  
A. D. Rao ◽  
G. S. Samuelsen
Keyword(s):  
Natural Gas ◽  
Gas Turbine ◽  
Hybrid Systems ◽  
Carbon Tax ◽  
Hybrid Plant ◽  
Cost Of Electricity ◽  
Efficiency Performance ◽  
Analysis Strategy ◽  
The University ◽  
Gas Price

The goals of a research program recently completed at the University of California, Irvine were to develop analysis strategy for Solid Oxide Fuel Cell (SOFC) based systems, to apply the analysis strategy to tubular SOFC hybrid systems and to identify promising hybrid configurations. A pressurized tubular SOFC combined with an intercooled-reheat gas turbine (SureCell™ cycle) is chosen as the Base Cycle over which improvements are sought. The humid air turbine (HAT) cycle features are incorporated to the Base Cycle resulting in the SOFC-HAT hybrid cycle which shows an efficiency of 69.05% while the Base Cycle has an efficiency of 66.23%. Exergy analysis identified the superior efficiency performance of the SOFC component. Therefore, an additional cycle variation added a second SOFC component followed by a low pressure combustor in place of the reheat combustor of the gas turbine of the SOFC-HAT hybrid. The resulting Dual SOFC-HAT hybrid has a thermal efficiency of 75.98%. The Single SOFC-HAT hybrid gives the lowest cost of electricity (3.54¢/kW-hr) while the Dual SOFC-HAT hybrid has the highest cost of electricity (4.02¢/kW-hr) among the three cycles with natural gas priced at $3/GJ. The Dual SOFC-HAT hybrid plant cost is calculated to be significantly higher because the fraction of power produced by the SOFC(s) is significantly higher than that in the other cases on the basis of $1100/kw initial cost for the SOFC. The Dual SOFC-HAT hybrid can only be justified in favor of the Single SOFC-HAT hybrid when price of natural gas is greater than $14/GJ or if a severe carbon tax on the order of $180/ton of CO2 is imposed while natural gas price remains at $3/GJ.

Investigation of Performance and Fuel Economy for Cylinder Deactivation Engine at Part Load Operation

2016 ◽  
Vol 819 ◽  
pp. 443-448 ◽  
Author(s):  
S.F. Zainal Abidin ◽  
Mohd Farid Muhamad Said ◽  
Azhar Abdul Aziz ◽  
Mohd Azman Abas ◽  
N.I. Arishad
Keyword(s):  
Fuel Economy ◽  
Fuel Injection ◽  
Injection Timing ◽  
Original Performance ◽  
Part Load ◽  
Automotive Engine ◽  
Engine Efficiency ◽  
Efficiency Performance ◽  
Valve Opening ◽  
Load Conditions

In automotive engine applications, the spark ignition (SI) engines can operate at various engine speed and load conditions. However, most of the time was spend at part load operations, where they operate below their rated output especially during cruising or idling. The needs of improvement in term of engine efficiency at part load operation become more popular among the engine manufacturers. One of the main reasons for efficiency dropped at part load conditions is the flow restrictions at the throttle valve opening area due to nearly-close position to control amount of inducted air into the cylinder, which leads to increasing in pumping losses. Hence, there are a lot of studies and investigations have been carried out to tackle these problems without sacrificing the original performance. This paper will investigate further the engine efficiency, performance as well as fuel economy by using one-dimensional (1-D) simulation tool. A baseline simulation model of a 1.6 liters four cylinders, port fuel injection engine has been developed based on the actual engine geometries. This baseline model applied predictive combustion to predict the amount of cylinder pressure based on actual ignition and injection timing on bench. The simulated results show a very good agreement with the measured data. Additionally, this study also proved that the deactivation half of the cylinders can significantly reduce the pumping losses of fired cylinder while eliminated the pumping work of unfired cylinders.

Performance and Emissions Characteristics of Bio-Diesel (B100)-Ignited Methane and Propane Combustion in a Four Cylinder Turbocharged Compression Ignition Engine

2012 ◽  
Vol 134 (8) ◽  
Author(s):  
N. T. Shoemaker ◽  
C. M. Gibson ◽  
A. C. Polk ◽  
S. R. Krishnan ◽  
K. K. Srinivasan
Keyword(s):  
Natural Gas ◽  
Fuel Efficiency ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Propane Combustion ◽  
Compression Ignition Engine ◽  
Engine Knock ◽  
Performance And Emissions ◽  
Cylinder Compression ◽  
Dual Fueling

Different combustion strategies and fuel sources are needed to deal with increasing fuel efficiency demands and emission restrictions. One possible strategy is dual fueling using readily available resources. Propane and natural gas are readily available with the current infrastructure and biodiesel is growing in popularity as a renewable fuel. This paper presents experimental results from dual fuel combustion of methane (as a surrogate for natural gas) and propane as primary fuels with biodiesel pilots in a 1.9 liter, turbocharged, 4-cylinder compression ignition engine at 1800 rev/min. Experiments were performed with different percentage energy substitutions (PES) of propane and methane and at different brake mean effective pressures (BMEP/bmep). Brake thermal efficiency (BTE) and emissions (NOx, HC, CO, CO2, O2 and smoke) were also measured. Maximum PES levels for B100-methane dual fueling were limited to 70% at 2.5 bars bmep and 48% at 10 bars bmep, and corresponding values for B100-propane dual fueling were 64% and 43%, respectively. Maximum PES was limited by misfire at 2.5 bars bmep and the onset of engine knock at 10 bars bmep. Dual fuel BTEs approached straight B100 values at 10 bars bmep while they were significantly lower than B100 values at 2.5 bars bmep. In general, dual fueling was beneficial in reducing NOx and smoke emissions by 33% and 50%, respectively, from baseline B100 levels; however, both CO and THC emissions were significantly higher than baseline B100 levels at all PES and loads.

Sign in / Sign up

Export Citation Format

Share Document