The Effects of Fuel Volatility and Structure on HC Emissions from Piston Wetting in DISI Engines

2001 ◽  
Author(s):  
Yiqun Huang ◽  
Terry Alger ◽  
Ronald D. Matthews ◽  
Janet Ellzey
Keyword(s):  
Hc Emissions ◽  
Piston Wetting

Effects of Fuel Volatility, Load, and Speed on HC Emissions Due to Piston Wetting

2001 ◽  
Author(s):  
Yiqun Huang ◽  
Ronald D. Matthews ◽  
Janet Ellzey ◽  
Wen Dai
Keyword(s):  
Hc Emissions ◽  
Piston Wetting

Engine Performance with Diesel-Biodiesel Blends Fuel and Emission Characteristics

2020 ◽  
Vol 38 (5A) ◽  
pp. 779-788
Author(s):  
Marwa N. Kareem ◽  
Adel M. Salih
Keyword(s):  
Sulfur Content ◽  
Diesel Fuel ◽  
Engine Performance ◽  
Esterification Reaction ◽  
Biodiesel Fuel ◽  
Exhaust Gas ◽  
Gas Temperature ◽  
Biodiesel Blends ◽  
Fuel Blends ◽  
Hc Emissions

In this study, the sunflowers oil was utilized as for producing biodiesel via a chemical operation, which is called trans-esterification reaction. Iraqi diesel fuel suffers from high sulfur content, which makes it one of the worst fuels in the world. This study is an attempt to improve the fuel specifications by reducing the sulfur content of the addition of biodiesel fuel to diesel where this fuel is free of sulfur and has a thermal energy that approaches to diesel.20%, 30% and 50% of Biodiesel fuel were added to the conventional diesel. Performance tests and pollutants of a four-stroke single-cylinder diesel engine were performed. The results indicated that the brake thermal efficiency a decreased by (4%, 16%, and 22%) for the B20, B30 and B50, respectively. The increase in specific fuel consumption was (60%, 33%, and 11%) for the B50, B30, and B20 fuels, respectively for the used fuel blends compared to neat diesel fuel. The engine exhaust gas emissions measures manifested a decreased of CO and HC were CO decreased by (13%), (39%) and (52%), and the HC emissions were lower by (6.3%), (32%), and (46%) for B20, B30 and B50 respectively, compared to diesel fuel. The reduction of exhaust gas temperature was (7%), (14%), and (32%) for B20, B30 and B50 respectively. The NOx emission increased with the increase in biodiesel blends ratio. For B50, the raise was (29.5%) in comparison with diesel fuel while for B30 and B20, the raise in the emissions of NOx was (18%) and...

scholarly journals Unregulated Emissions from Natural Gas Taxi Based on IVE Model

Atmosphere ◽  
2021 ◽  
Vol 12 (4) ◽  
pp. 478
Author(s):  
Hong Zhao ◽  
Liang Mu ◽  
Yan Li ◽  
Junzheng Qiu ◽  
Chuanlong Sun ◽  
...  
Keyword(s):  
Natural Gas ◽  
Total Carbon ◽  
Motor Vehicles ◽  
Pollutant Emission ◽  
Localization Model ◽  
Annual Total ◽  
Hc Emissions ◽  
Analysis System ◽  
Unregulated Emissions ◽  
Ive Model

Emissions from motor vehicles have gained the attention of government agencies. To alleviate air pollution and reduce the petroleum demand from vehicles in China, the policy of “oil to gas” was vigorously carried out. Qingdao began to promote the use of natural gas vehicles (NGVs) in 2003. By the end of 2016, there were 9460 natural gas (NG) taxis in Qingdao, which accounted for 80% of the total taxis. An understanding of policy implementation for emission reductions is required. Experiments to obtain the taxi driving conditions and local parameters were investigated and an international vehicle emissions (IVE) localization model was established. Combined with vehicle mass analysis system (VMAS) experiments, the IVE localization model was amended and included the taxi pollutant emission factors. The result indicates that annual total carbon monoxide (CO) emissions from actual taxis are 6411.87 t, carbureted hydrogen (HC) emissions are 124.85 t, nitrogen oxide (NOx) emissions are 1397.44 t and particulate matter (PM) emissions are 8.9 t. When the taxis are running on pure natural gas, the annual emissions of CO, HC, NOx and PM are 4942.3 t, 48.15 t, 1496.01 t and 5.13 t, respectively. Unregulated emissions of annual total formaldehydes, benzene, acetaldehyde, 1,3-butadience emissions from an actual taxi are 65.99 t, 4.68 t, 1.04 t and 8.83 t. When the taxi is running on pure natural gas, the above unregulated emissions are 12.11 t, 1.27 t, 1.5 t and 0.02 t, respectively.

scholarly journals Investigation on Physicochemical Properties of Wastewater Grown Microalgae Methyl Ester and its Effects on CI Engine

2020 ◽  
Vol 24 (1) ◽  
pp. 72-87 ◽  
Author(s):  
Sara Tayari ◽  
Reza Abedi ◽  
Ali Abedi
Keyword(s):  
Methyl Ester ◽  
Engine Performance ◽  
Exhaust Emissions ◽  
Biodiesel Production ◽  
Emissions Reduction ◽  
Test Results ◽  
Main Fatty Acid ◽  
Ci Engine ◽  
Hc Emissions ◽  
A Minor

AbstractMicroalgae have been mentioned as a promising feedstock for biodiesel production. In this study, microalgae Chlorella vulgaris (MCV) was cultivated in a bioreactor with wastewater. After biodiesel production from MCV oil via transesterification reaction, chemical and physical properties of MCV methyl ester were evaluated with regular diesel and ASTM standard. Besides, engine performance and exhaust emissions of CI engine fuelled with the blends of diesel-biodiesel were measured. The GC-MS analysis showed that oleic and linoleic acids were the main fatty acid compounds in the MCV methyl ester. Engine test results revealed that the use of biodiesel had led to a major decrease in CO and HC emissions and a modest reduction in CO2 emissions, whereas there was a minor increase in NOx emissions. Furthermore, there was a slight decrease in the engine power and torque while a modest increase in brake specific fuel consumption which are acceptable due to exhaust emissions reduction. The experimental results illustrate considerable capabilities of applied MVC biodiesel as an alternative fuel in diesel engines to diminish the emissions.

Application of a Phenomenological Model for the Engine-Out Emissions of Unburned Hydrocarbons in Driving Cycles

2015 ◽  
Vol 138 (2) ◽  
Author(s):  
Manuel Dorsch ◽  
Jens Neumann ◽  
Christian Hasse
Keyword(s):  
Phenomenological Model ◽  
Combustion Engine ◽  
Combustion Process ◽  
Formation Mechanisms ◽  
Emission Model ◽  
Engine Operation ◽  
Driving Cycles ◽  
Hc Emissions ◽  
Piston Crevice ◽  
Engine Map

In this work, the application of a phenomenological model to determine engine-out hydrocarbon (HC) emissions in driving cycles is presented. The calculation is coupled to a physical-based simulation environment consisting of interacting submodels of engine, vehicle, and engine control. As a novelty, this virtual calibration methodology can be applied to optimize the energy conversion inside a spark-ignited (SI) internal combustion engine at transient operation. Using detailed information about the combustion process, the main origins and formation mechanisms of unburned HCs like piston crevice, oil layer, and wall quenching are considered in the prediction, as well as the in-cylinder postoxidation. Several parameterization approaches, especially, of the oil layer mechanism are discussed. After calibrating the emission model to a steady-state engine map, the transient results are validated successfully against measurements of various driving cycles based on different calibration strategies of engine operation.

Low Emissions Combustion for the Regenerative Gas Turbine: Part 1—Theoretical and Design Considerations

1974 ◽  
Vol 96 (1) ◽  
pp. 32-48 ◽  
Author(s):  
W. R. Wade ◽  
P. I. Shen ◽  
C. W. Owens ◽  
A. F. McLean
Keyword(s):  
Gas Turbine ◽  
Flame Temperature ◽  
Homogeneous System ◽  
Automotive Application ◽  
Inlet Temperature ◽  
Oxides Of Nitrogen ◽  
Turbine Engine ◽  
Homogeneous Combustion ◽  
Hc Emissions ◽  
Model Year

This first part, of a two part paper, reviews the NOx emission problem of the regenerative gas turbine engine for automotive application. It discusses the problem of fuel droplet burning, which causes heterogenous combustion with resulting high flame temperatures and high levels of oxides of nitrogen. The paper proposes means to achieve homogeneous combustion and shows that, even with this approach, flame temperatures need to be closely controlled to effect a compromise between NOx, CO, and HC emissions in order to meet the stringent numerical levels of emissions specified by the Federal standards for 1976 and subsequent model year automobiles. The paper shows that combustor inlet temperature of a homogeneous system has little effect, theoretically, on computed NOx emissions expressed as grams per mile, thereby strengthening the case for the regenerative turbine engine. A design concept for homogeneous combustion with controlled flame temperature is discussed.

scholarly journals Numerical Study of Engine Performance and Emissions for Port Injection of Ammonia into a Gasoline\Ethanol Dual-Fuel Spark Ignition Engine

2021 ◽  
Vol 11 (4) ◽  
pp. 1441
Author(s):  
Farhad Salek ◽  
Meisam Babaie ◽  
Amin Shakeri ◽  
Seyed Vahid Hosseini ◽  
Timothy Bodisco ◽  
...  
Keyword(s):  
Numerical Study ◽  
Combustion Process ◽  
Engine Performance ◽  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Combustion Model ◽  
Dual Fuel ◽  
Spark Ignition Engines ◽  
Performance And Emissions ◽  
Hc Emissions

This study aims to investigate the effect of the port injection of ammonia on performance, knock and NOx emission across a range of engine speeds in a gasoline/ethanol dual-fuel engine. An experimentally validated numerical model of a naturally aspirated spark-ignition (SI) engine was developed in AVL BOOST for the purpose of this investigation. The vibe two zone combustion model, which is widely used for the mathematical modeling of spark-ignition engines is employed for the numerical analysis of the combustion process. A significant reduction of ~50% in NOx emissions was observed across the engine speed range. However, the port injection of ammonia imposed some negative impacts on engine equivalent BSFC, CO and HC emissions, increasing these parameters by 3%, 30% and 21%, respectively, at the 10% ammonia injection ratio. Additionally, the minimum octane number of primary fuel required to prevent knock was reduced by up to 3.6% by adding ammonia between 5 and 10%. All in all, the injection of ammonia inside a bio-fueled engine could make it robust and produce less NOx, while having some undesirable effects on BSFC, CO and HC emissions.

Economy and emission characteristics of the optimal dilution strategy in lean combustion based on GDI gasoline engine equipped with prechamber

2021 ◽  
Vol 13 (12) ◽  
pp. 168781402110381
Author(s):  
Li Wang ◽  
Zhaoming Huang ◽  
Wang Tao ◽  
Kai Shen ◽  
Weiguo Chen
Keyword(s):  
Fuel Economy ◽  
Gasoline Engine ◽  
Direct Injection ◽  
Engine Performance ◽  
Gasoline Direct Injection ◽  
Dilution Ratio ◽  
Lean Combustion ◽  
Excess Air ◽  
Combustion Phase ◽  
Hc Emissions

EGR and excess-air dilution have been investigated in a 1.5 L four cylinders gasoline direct injection (GDI) turbocharged engine equipped with prechamber. The influences of the two different dilution technologies on the engine performance are explored. The results show that at 2400 rpm and 12 bar, EGR dilution can adopt more aggressive ignition advanced angle to achieve optimal combustion phasing. However, excess-air dilution has greater fuel economy than that of EGR dilution owing to larger in-cylinder polytropic exponent. As for prechamber, when dilution ratio is greater than 37.1%, the combustion phase is advanced, resulting in fuel economy improving. Meanwhile, only when the dilution ratio is under 36.2%, the HC emissions of excess-air dilution are lower than the original engine. With the increase of dilution ratio, the CO emissions decrease continuously. The NOX emissions of both dilution technologies are 11% of those of the original engine. Excess-air dilution has better fuel economy and very low CO emissions. EGR dilution can effectively reduce NOX emissions, but increase HC emissions. Compared with spark plug ignition, the pre chamber ignition has lower HC, CO emissions, and higher NO emissions. At part load, the pre-chamber ignition reduces NOX emissions to 49 ppm.

Airless In-Line Adsorber System for Reducing Cold Start HC Emissions

1998 ◽  
Author(s):  
M. D. Patil ◽  
Y. Lisa Peng ◽  
Kathleen E. Morse
Keyword(s):  
Cold Start ◽  
Hc Emissions
Sign in / Sign up

Export Citation Format

Share Document