Probabilistic Capacity Estimation of Cold-Formed Steel Channel Sections with Type-1 Imperfections

2014 ◽  
Author(s):  
H.S.S. Ahmed ◽  
A. Sable ◽  
S. Ghosh
Keyword(s):  
Capacity Estimation ◽  
Cold Formed Steel

scholarly journals Bolt connection behaviour of the cold-formed steel joint

2018 ◽  
Vol 154 ◽  
pp. 01112
Author(s):  
Sabril Haris ◽  
Hazmal Herman ◽  
Zaidir ◽  
Rendy Thamrin
Keyword(s):  
Failure Modes ◽  
Shear Failure ◽  
Analytical Calculation ◽  
Channel Section ◽  
Steel Joint ◽  
Cold Formed Steel ◽  
Connection Type ◽  
Bolt Connection

This paper presents an experimental study of bolt connection behaviour of the cold-formed steel joint. A 5-mm bolt was used to combine two channel sections. The size of channel section was 75 mm height, 35 mm width and 0.75 mm thickness. Tension test was conducted to obtain material characteristics of the channel section. Two type of connections were observed: Connection Type-1 that back-to-back channel sections were joined on their web directly, and Connection Type-2 that two channel sections were joined on their flanges through a same-size channel connector. The specimen was pulled by an increasing monotonically load. It was found that ultimate condition of the joint occurred when the bolt was split due to shear failure and the bolt was rotated because the hole size increased; these two failure modes are covered in the Indonesian and Australian/New Zealand cold-formed steel codes. The ultimate loads from the test were compared to analytical calculations using the formulae provided in the codes. The analytical calculation predicted the resistances conservatively within the range of 4 – 22 %.

scholarly journals A traffic micro-simulation model to estimate four-lane highways' capacity in Thailand

2018 ◽  
Vol 192 ◽  
pp. 02005
Author(s):  
Wuttikrai Chaipanha ◽  
Ladda Tanwanichkul ◽  
Jumrus Pitaksringkarn
Keyword(s):  
Simulation Model ◽  
Access Point ◽  
Affecting Factors ◽  
Capacity Estimation ◽  
Passenger Car ◽  
Factors Affecting ◽  
Maximum Capacity ◽  
Micro Simulation ◽  
Type 3

This article purposed to present the maximum capacity and to develop the equation in the capacity estimation of 4 types of four-lane highways by using the micro-simulation model. Regarding the analysis, the factors affecting the capacity include access-point, heavy vehicles and median u-turn. According to the study, it was found that the maximum capacity of the four-lane highways in type 1 is 2194 passenger car/hour/lane. In the descending orders, the maximum capacity of the highways with four lanes in type 2, 3, and 4 are 2161, 2094 and 2017 passenger car/hour/lane, respectively. At the same time, the maximum capacity of the prevailing condition in the study is 1300-1600 vehicles/hour/lane, which is different from the HCM2010 method for 20-30%, due to the Thai's highway characteristics directly affect the traffic and driving behavior. Median u-turn affects the four-lane highways in type 1 and 2 the most, while access-point factor has the most influence towards type 3 and 4. In addition, the author has developed the equation models for capacity estimation, which the result derived from the relationship between the capacities and affecting factors. It was aimed at using as the guidelines in the capacity assessment of Thai's four-lane highways in the future.

Crystalloid Inclusions in Hepatocyte Mitochondria and Their Similarity to Cytoplasmic Crystalloids

1974 ◽  
Vol 32 ◽  
pp. 198-199
Author(s):  
Odell T. Minick ◽  
Hidejiro Yokoo
Keyword(s):  
Liver Disease ◽  
Alcoholic Liver Disease ◽  
Special Interest ◽  
Structural Variations ◽  
Mitochondrial Alterations ◽  
The Matrix ◽  
Crystalloid Inclusions ◽  
Liver Biopsies

Mitochondrial alterations were studied in 25 liver biopsies from patients with alcoholic liver disease. Of special interest were the morphologic resemblance of certain fine structural variations in mitochondria and crystalloid inclusions. Four types of alterations within mitochondria were found that seemed to relate to cytoplasmic crystalloids.Type 1 alteration consisted of localized groups of cristae, usually oriented in the long direction of the organelle (Fig. 1A). In this plane they appeared serrated at the periphery with blind endings in the matrix. Other sections revealed a system of equally-spaced diagonal lines lengthwise in the mitochondrion with cristae protruding from both ends (Fig. 1B). Profiles of this inclusion were not unlike tangential cuts of a crystalloid structure frequently seen in enlarged mitochondria described below.

Evidence for a shear mechanism for the precipitation of γ-zirconium hydride in zirconium

1978 ◽  
Vol 36 (1) ◽  
pp. 658-659
Author(s):  
G.J.C. Carpenter
Keyword(s):  
Elevated Temperature ◽  
Strain Field ◽  
Zirconium Hydride ◽  
Zirconium Atom ◽  
Atom Diffusion ◽  
Solvus Temperature ◽  
Hexagonal Close Packed ◽  
Partial Dislocations ◽  
The Face

In zirconium-hydrogen alloys, rapid cooling from an elevated temperature causes precipitation of the face-centred tetragonal (fct) phase, γZrH, in the form of needles, parallel to the close-packed <1120>zr directions (1). With low hydrogen concentrations, the hydride solvus is sufficiently low that zirconium atom diffusion cannot occur. For example, with 6 μg/g hydrogen, the solvus temperature is approximately 370 K (2), at which only the hydrogen diffuses readily. Shears are therefore necessary to produce the crystallographic transformation from hexagonal close-packed (hep) zirconium to fct hydride.The simplest mechanism for the transformation is the passage of Shockley partial dislocations having Burgers vectors (b) of the type 1/3<0110> on every second (0001)Zr plane. If the partial dislocations are in the form of loops with the same b, the crosssection of a hydride precipitate will be as shown in fig.1. A consequence of this type of transformation is that a cumulative shear, S, is produced that leads to a strain field in the surrounding zirconium matrix, as illustrated in fig.2a.

Direct structure images of 30° partial dislocation cores in silicon

1987 ◽  
Vol 45 ◽  
pp. 242-243
Author(s):  
J. C. Barry ◽  
H. Alexander
Keyword(s):  
Dislocation Core ◽  
Preparation Technique ◽  
Burgers Vector ◽  
Vector Type ◽  
Sample Preparation Technique ◽  
Lattice Images ◽  
Dislocation Core Structure ◽  
Type Lattice ◽  
Direct Inspection

Dislocations in silicon produced by plastic deformation are generally dissociated into partials. 60° dislocations (Burgers vector type 1/2[101]) are dissociated into 30°(Burgers vector type 1/6[211]) and 90°(Burgers vector type 1/6[112]) dislocations. The 30° partials may be either of “glide” or “shuffle” type. Lattice images of the 30° dislocation have been obtained with a JEM 100B, and with a JEM 200Cx. In the aforementioned experiments a reasonable but imperfect match was obtained with calculated images for the “glide” model. In the present experiment direct structure images of 30° dislocation cores have been obtained with a JEOL 4000EX. It is possible to deduce the 30° dislocation core structure by direct inspection of the images. Dislocations were produced by compression of single crystal Si (sample preparation technique described in Alexander et al.).

Electron Microscopic investigation of crooke’s change in the pituitaries of patients with hypercorticism

1989 ◽  
Vol 47 ◽  
pp. 848-849
Author(s):  
E. Horvath ◽  
K. Kovacs ◽  
L. Stefaneanu ◽  
N. Losinski
Keyword(s):  
Nucleolar Organizer ◽  
Microscopic Investigation ◽  
Electron Microscopic Investigation ◽  
Ectopic Acth Syndrome ◽  
Nucleolar Organizer Regions ◽  
Electron Microscopic ◽  
Human Pituitary ◽  
Ectopic Acth ◽  
Crooke’S Hyalinization

Human pituitary corticotropins have unique morphologic markers: bundles of type-1 filaments, measuring approximately 70 A in width and representing cytokeratin. The extreme ring-like accumulation of type-1 filaments, known as Crooke's hyalinization, signals functional suppression of the corticotropins and occurs in endogenous and exogenous glucocorticoid excess, caused by ACTH-secreting pituitary adenoma, glucocorticoid secreting adrenocortical tumor, ectopic ACTH-syndrome and administration of pharmacologic doses of glucocorticoids. Cells of autonomous corticotroph adenomas usually do not show Crooke's hyalin change. A minority of these tumors, however, retains sensitivity to the negative feed-back effect of elevated blood glucocorticoid levels and display typical Crooke’s change.In the present study pituitary corticotropins in various phases of Crooke's hyalinization were investigated in patients with glucocorticoid excess of various origin, applying histology, immunocytochemistry, count of argyrophilic nucleolar organizer regions (AgNOR), and transmission electron microscopy.

Challenges in the Diagnostic Conceptualization of CRPS-1 (Formerly Conceptualized as RSD)

2006 ◽  
Vol 11 (2) ◽  
pp. 1-3, 9-12
Author(s):  
Robert J. Barth ◽  
Tom W. Bohr
Keyword(s):  
Clinical Practice ◽  
Complex Regional Pain Syndrome ◽  
Somatoform Disorders ◽  
International Association ◽  
Pain Syndrome ◽  
Somatoform Disorder ◽  
Syndrome Type ◽  
Previous Issue

Abstract From the previous issue, this article continues a discussion of the potentially confusing aspects of the diagnostic formulation for complex regional pain syndrome type 1 (CRPS-1) proposed by the International Association for the Study of Pain (IASP), the relevance of these issues for a proposed future protocol, and recommendations for clinical practice. IASP is working to resolve the contradictions in its approach to CRPS-1 diagnosis, but it continues to include the following criterion: “[c]ontinuing pain, which is disproportionate to any inciting event.” This language only perpetuates existing issues with current definitions, specifically the overlap between the IASP criteria for CRPS-1 and somatoform disorders, overlap with the guidelines for malingering, and self-contradiction with respect to the suggestion of injury-relatedness. The authors propose to overcome the last of these by revising the criterion: “[c]omplaints of pain in the absence of any identifiable injury that could credibly account for the complaints.” Similarly, the overlap with somatoform disorders could be reworded: “The possibility of a somatoform disorder has been thoroughly assessed, with the results of that assessment failing to produce any consistencies with a somatoform scenario.” The overlap with malingering could be addressed in this manner: “The possibility of malingering has been thoroughly assessed, with the results of that assessment failing to produce any consistencies with a malingering scenario.” The article concludes with six recommendations, and a sidebar discusses rating impairment for CRPS-1 (with explicit instructions not to use the pain chapter for this purpose).

Sign in / Sign up

Export Citation Format

Share Document