scholarly journals High-resolution seismic imaging of the gas hydrate stability zone at the Mallik L-38 research site

2005 ◽  
Author(s):  
R D Miller ◽  
J A Hunter ◽  
W E Doll ◽  
B J Carr ◽  
T S Collett
Keyword(s):  
High Resolution ◽  
Gas Hydrate ◽  
Seismic Imaging ◽  
Stability Zone ◽  
Research Site ◽  
Hydrate Stability

Fluid dynamics at the base of hydrate-bearing sediments at the Vestnesa Ridge inferred from 5 years of high-resolution 4D seismic surveying

2020 ◽  
Author(s):  
Malin Waage ◽  
Stefan Bünz ◽  
Kate Waghorn ◽  
Sunny Singhorha ◽  
Pavel Serov
Keyword(s):  
High Resolution ◽  
Gas Hydrate ◽  
Seismic Data ◽  
Time Lapse ◽  
Stability Zone ◽  
Seismic Surveys ◽  
Free Gas ◽  
4D Seismic ◽  
Hydrate Bearing Sediments ◽  
Hydrate Stability

<p>The transition from gas hydrate to gas-bearing sediments at the base of the hydrate stability zone (BHSZ) is commonly identified on seismic data as a bottom-simulating reflection (BSR). At this boundary, phase transitions driven by thermal effects, pressure alternations, and gas and water flux exist. Sedimentation, erosion, subsidence, uplift, variations in bottom water temperature or heat flow cause changes in marine gas hydrate stability leading to expansion or reduction of gas hydrate accumulations and associated free gas accumulations. Pressure build-up in gas accumulations trapped beneath the hydrate layer may eventually lead to fracturing of hydrate-bearing sediments that enables advection of fluids into the hydrate layer and potentially seabed seepage. Depletion of gas along zones of weakness creates hydraulic gradients in the free gas zone where gas is forced to migrate along the lower hydrate boundary towards these weakness zones. However, due to lack of “real time” data, the magnitude and timescales of processes at the gas hydrate – gas contact zone remains largely unknown. Here we show results of high resolution 4D seismic surveys at a prominent Arctic gas hydrate accumulation – Vestnesa ridge - capturing dynamics of the gas hydrate and free gas accumulations over 5 years. The 4D time-lapse seismic method has the potential to identify and monitor fluid movement in the subsurface over certain time intervals. Although conventional 4D seismic has a long history of application to monitor fluid changes in petroleum reservoirs, high-resolution seismic data (20-300 Hz) as a tool for 4D fluid monitoring of natural geological processes has been recently identified.<br><br>Our 4D data set consists of four high-resolution P-Cable 3D seismic surveys acquired between 2012 and 2017 in the eastern segment of Vestnesa Ridge. Vestnesa Ridge has an active fluid and gas hydrate system in a contourite drift setting near the Knipovich Ridge offshore W-Svalbard. Large gas flares, ~800 m tall rise from seafloor pockmarks (~700 m diameter) at the ridge axis. Beneath the pockmarks, gas chimneys pierce the hydrate stability zone, and a strong, widespread BSR occurs at depth of 160-180 m bsf. 4D seismic datasets reveal changes in subsurface fluid distribution near the BHSZ on Vestnesa Ridge. In particular, the amplitude along the BSR reflection appears to change across surveys. Disappearance of bright reflections suggest that gas-rich fluids have escaped the free gas zone and possibly migrated into the hydrate stability zone and contributed to a gas hydrate accumulation, or alternatively, migrated laterally along the BSR. Appearance of bright reflection might also indicate lateral migration, ongoing microbial or thermogenic gas supply or be related to other phase transitions. We document that faults, chimneys and lithology constrain these anomalies imposing yet another control on vertical and lateral gas migration and accumulation. These time-lapse differences suggest that (1) we can resolve fluid changes on a year-year timescale in this natural seepage system using high-resolution P-Cable data and (2) that fluids accumulate at, migrate to and migrate from the BHSZ over the same time scale.</p>

Time Constraints on Seepage Through Fractured Regions on the Vestnesa Ridge off the W-Svalbard Coast

2021 ◽  
Author(s):  
Hariharan Ramachandran ◽  
Andreia Plaza-Faverola ◽  
Hugh Daigle ◽  
Stefan Buenz
Keyword(s):  
Fluid Flow ◽  
Effective Stress ◽  
Gas Hydrate ◽  
Fluid Pressure ◽  
Fracture Network ◽  
The Arctic ◽  
Stability Zone ◽  
Methane Seepage ◽  
Carbonate Formation ◽  
Hydrate Stability

<p>Evidences of subsurface fluid flow-driven fractures (from seismic interpretation) are quite common at Vestnesa Ridge (around 79ºN in the Arctic Ocean), W-Svalbard margin. Ultimately, the fractured systems have led to the formation of pockmarks on the seafloor. At present day, the eastern segment of the ridge has active pockmarks with continuous methane seep observations in sonar data. The pockmarks in the western segment are considered inactive or to seep at a rate that is harder to identify. The ridge is at ~1200m water depth with the base of the gas hydrate stability zone (GHSZ) at ~200m below the seafloor. Considerable free gas zone is present below the hydrates. Besides the obvious concern of amount and rates of historic methane seeping into the ocean biosphere and its associated effects, significant gaps exist in the ability to model the processes of flow of methane through this faulted and fractured region. Our aim is to highlight the interactions between physical flow, geomechanics and geological control processes that govern the rates and timing of methane seepage.</p><p>For this purpose, we performed numerical fluid flow simulations. We integrate fundamental mass and component conservation equations with a phase equilibrium approach accounting for hydrate phase boundary effects to simulate the transport of gas from the base of the GHSZ through rock matrix and interconnected fractures until the seafloor. The relation between effective stress and fluid pressure is considered and fractures are activated once the effective stress exceeds the tensile limit. We use field data (seismic, oedometer tests on calypso cores, pore fluid pressure and temperature) to constrain the range of validity of various flow and geomechanical parameters in the simulation (such as vertical stress, porosity, permeability, saturations).</p><p>Preliminary results indicate fluid overpressure greater than 1.5 MPa is required to initiate fractures at the base of the gas hydrate stability zone for the investigated system. Focused fluid flow occurs through the narrow fracture networks and the gas reaches the seafloor within 1 day. The surrounding regions near the fracture network exhibit slower seepage towards the seafloor, but over a wider area. Advective flux through the less fractured surrounding regions, reaches the seafloor within 15 years and a diffusive flux reaches within 1200 years. These times are controlled by the permeability of the sediments and are retarded further due to considerable hydrate/carbonate formation during vertical migration. Next course of action includes constraining the methane availability at the base of the GHSZ and estimating its impact on seepage behavior.</p>

scholarly journals Role of Salt Migration in Destabilization of Intra Permafrost Hydrates in the Arctic Shelf: Experimental Modeling

Geosciences ◽  
2019 ◽  
Vol 9 (4) ◽  
pp. 188 ◽  
Author(s):  
Evgeny Chuvilin ◽  
Valentina Ekimova ◽  
Boris Bukhanov ◽  
Sergey Grebenkin ◽  
Natalia Shakhova ◽  
...  
Keyword(s):  
Gas Hydrates ◽  
Methane Emission ◽  
Gas Hydrate ◽  
Negative Temperature ◽  
Arctic Shelf ◽  
The Arctic ◽  
Permafrost Degradation ◽  
Stability Zone ◽  
Local Pressure ◽  
Hydrate Stability

Destabilization of intrapermafrost gas hydrate is one possible reason for methane emission on the Arctic shelf. The formation of these intrapermafrost gas hydrates could occur almost simultaneously with the permafrost sediments due to the occurrence of a hydrate stability zone after sea regression and the subsequent deep cooling and freezing of sediments. The top of the gas hydrate stability zone could exist not only at depths of 200–250 m, but also higher due to local pressure increase in gas-saturated horizons during freezing. Formed at a shallow depth, intrapermafrost gas hydrates could later be preserved and transform into a metastable (relict) state. Under the conditions of submarine permafrost degradation, exactly relict hydrates located above the modern gas hydrate stability zone will, first of all, be involved in the decomposition process caused by negative temperature rising, permafrost thawing, and sediment salinity increasing. That’s why special experiments were conducted on the interaction of frozen sandy sediments containing relict methane hydrates with salt solutions of different concentrations at negative temperatures to assess the conditions of intrapermafrost gas hydrates dissociation. Experiments showed that the migration of salts into frozen hydrate-containing sediments activates the decomposition of pore gas hydrates and increase the methane emission. These results allowed for an understanding of the mechanism of massive methane release from bottom sediments of the East Siberian Arctic shelf.

scholarly journals Permafrost and Gas Hydrate Stability Zone of the Glacial Part of the East-Siberian Shelf

Geosciences ◽  
2020 ◽  
Vol 10 (12) ◽  
pp. 484
Author(s):  
Anatoly Gavrilov ◽  
Valentina Malakhova ◽  
Elena Pizhankova ◽  
Alexandra Popova
Keyword(s):  
Cross Sections ◽  
Gas Hydrate ◽  
Historical Development ◽  
Lower Boundary ◽  
Time Range ◽  
Stability Zone ◽  
East Siberian Shelf ◽  
Geothermal Flux ◽  
Hydrate Stability ◽  
Siberian Shelf

By using thermal mathematical modeling for the time range of 200,000 years ago, the authors have been studying the role the glaciation, covered the De Long Islands and partly the Anjou Islands at the end of Middle Neopleistocene, played in the formation of permafrost and gas hydrates stability zone. For the modeling purpose, we used actual geological borehole cross-sections from the New Siberia Island. The modeling was conducted at geothermal flux densities of 50, 60, and 75 mW/m2 for glacial and extraglacial conditions. Based on the modeling results, the glaciated area is characterized by permafrost thickness of 150–200 m lower than under extraglacial conditions. The lower boundary of the gas hydrate stability zone in the glacial area at 50–60 mW/m2 is located 300 m higher than the same under extraglacial conditions. At 75 mW/m2 in the area of 20–40 m isobaths, open taliks are formed, and the gas hydrate stability zone was destroyed in the middle of the Holocene. The specified conditions and events were being formed in the course of the historical development of the glacial area with a predominance of the marine conditions peculiar to it from the middle of the Middle Neopleistocene.

Sign in / Sign up

Export Citation Format

Share Document