Packaging. Flexible laminate and plastic tubes. Test method to determine the adhesive strength of the membrane

2015 ◽  
Keyword(s):  
Adhesive Strength ◽  
Test Method

Surface Analysis of Shear Strength Tested Tungsten Carbide Thermal Spray Coatings+

1997 ◽  
Vol 3 (S2) ◽  
pp. 791-792 ◽  
Author(s):  
S. V. Naidu ◽  
Carlos Green ◽  
Christopher Maxie ◽  
James D. Garber ◽  
Gary A. Glass
Keyword(s):  
Thermal Spray ◽  
Adhesive Strength ◽  
Shear Test ◽  
Spray Coating ◽  
Test Method ◽  
Thermal Spray Coatings ◽  
Oxide Content ◽  
Ring Shear Test ◽  
Spray Coatings ◽  
Ring Shear

Thermal spray processing has become an important powder-consolidation technique to yield new materials for extremes of temperature, radiation, wear, corrosion and mechanical stresses. High Velocity Oxy-Fuel (HVOF) spray coating process gives higher deposition densities and coating hardness; lower oxide content and porosity. The adhesive strength of thermal spray coatings is greatly effected by the interfacial impurities. The ring shear test method shown in Fig. 1 appears to give the most accurate results on shear adhesive strength. A typical ring shear test result of 88WC12Co 1/4" ring HVOF thermal spray coating on 4140 steel rod using a Jet kote thermal spray gun is shown in Fig. 2. Repeated ring shear tests on similar samples prepared under same spray and test conditions resulted in different shear bond strength and coating ring displacement before break off. We examined the ring shear tested coatings using a Zeiss DMS942 Scanning Electron Microscope (SEM) and Kevex Energy Dispersive X-ray Spectrometer (EDXS) with LPX1 Quantum Si(Li) Detector.

scholarly journals Adhesive strength in a high voltage mica insulation system

2019 ◽  
Vol 140 ◽  
pp. 11006
Author(s):  
Tatiana Shikova
Keyword(s):  
Adhesion Strength ◽  
High Voltage ◽  
Adhesive Strength ◽  
Adhesive Contact ◽  
Test Method ◽  
Technological Parameters ◽  
Contact Materials ◽  
Pressing Process ◽  
Thermal Pressing ◽  
Degree Of Curing

The problem of maintaining a monolithic high-voltage mica insulation made by the Resin Rich technology for windings of electrical machines and conductors is considered. The violation of solidity like delaminations and peeling off from conductor can happen both during the process of manufacturing and during exploitation of constructions. The possibility of breaking the solidity is directly related to the magnitude of adhesion strength. Design and manufacturing technology of samples in laboratory and industrial conditions to determine the adhesion strength were developed. Adhesive strength is determined by the method of shear and tensile test method between insulation layers and in system of metal- mica insulation.The created method for the manufacture of samples made it possible to test samples with various designs of adhesive contact, materials of adhesive contact and technological parameters of the pressing process. The adhesion strength depends on the parameters of the thermal pressing process and the degree of curing of the binder in the initial resin rich tape. Adhesive contact of mica insulation to metal through fiberglass is more durable than through film

Sign in / Sign up

Export Citation Format

Share Document