scholarly journals Thermodynamic Analysis and Experimental Study of Selective Dehydrogenation of 1,2-cyclohexanediol over Cu2+1O/MgO Catalysts

2019 ◽  
Vol 11 (3) ◽  
pp. 902
Author(s):  
Haiou Wang ◽  
Qiusheng Yang ◽  
Yucong Song ◽  
Yanji Wang
Keyword(s):  
Density Functional Theory ◽  
Experimental Study ◽  
Thermodynamic Analysis ◽  
Density Functional ◽  
Dft Calculation ◽  
Catalytic Performance ◽  
Reaction Conditions ◽  
Functional Theory ◽  
Effective Utilization ◽  
Vicinal Diols

The dehydrogenation of 1,2-cyclohexanediol (CHD) helps in the effective utilization of not only fossil derivatives but also vicinal diols and polyols from sustainable biomass-derived resources. A thermodynamic analysis of CHD dehydrogenation was computed with density functional theory (DFT) calculation using Gaussian 09. The result indicates that CHD can be converted to 2-hydroxy cyclohexanone (HCO), 2-hydroxy-2-cyclohexen-1-one (HCEO) and pyrocatechol depending on the degree of dehydrogenation. HCO and HCEO are the stable products of the primary and secondary dehydrogenation. Experimentally, Cu/MgO catalysts were prepared using glucose as a reductant, and were characterized by SEM, TEM, XRD, XPS, TPR, BET and ICP. Furthermore, their catalytic performance regarding the oxygen-free dehydrogenation of CHD was investigated. The results indicate that the primary active crystalline phase of Cu/MgO was Cu2+1O, and that the dehydrogenation products were mainly HCO and HCEO, in accordance with thermodynamic predictions. Upon optimizing the reaction conditions, the total selectivity of HCO and HCEO exceeded 90% and the conversion of CHD was approximately 95%.

Catalytic performance of Pdn (n = 1, 2, 3, 4 and 6) clusters supported on TiO2-V for the formation of dimethyl oxalate via the CO catalytic coupling reaction: a theoretical study

2020 ◽  
Vol 22 (8) ◽  
pp. 4549-4560 ◽  
Author(s):  
Lixia Ling ◽  
Yueting Cao ◽  
Min Han ◽  
Ping Liu ◽  
Riguang Zhang ◽  
...  
Keyword(s):  
Density Functional Theory ◽  
Density Functional ◽  
Dft Calculation ◽  
Theoretical Study ◽  
Coupling Reaction ◽  
Catalytic Performance ◽  
Functional Theory ◽  
Dimethyl Oxalate

The formation of dimethyl oxalate (DMO) via CO catalytic coupling on a series of catalysts including Pdn (n = 1, 2, 3, 4 and 6) clusters loaded on TiO2-V has been explored by density functional theory (DFT) calculation.

In Situ Exsolved Au Nanoparticles from Perovskite Oxide for Efficient Epoxidation of Styrene

2021 ◽  
Author(s):  
Yang Gao ◽  
Xing Chen ◽  
Shuqi Hu ◽  
Shiguo Zhang
Keyword(s):  
Density Functional Theory ◽  
Thermodynamic Analysis ◽  
Density Functional ◽  
Au Nanoparticles ◽  
Oxide Catalyst ◽  
Density Functional Theory Calculations ◽  
Average Diameter ◽  
Perovskite Oxide ◽  
Functional Theory

Au-doped SrTiO3 perovskite oxide catalyst (Sr0.995Au0.005TiO3-δ) has been designed and synthesized based on thermodynamic analysis and density functional theory calculations. During reduction, Au nanoparticles with an average diameter of 2...

scholarly journals Pd/Pt embedded CN monolayers as efficient catalysts for CO oxidation

2019 ◽  
Vol 21 (46) ◽  
pp. 25743-25748
Author(s):  
Yong-Chao Rao ◽  
Xiang-Mei Duan
Keyword(s):  
Density Functional Theory ◽  
Co Oxidation ◽  
Density Functional ◽  
Carbon Nitride ◽  
Density Functional Theory Calculations ◽  
Catalytic Performance ◽  
Functional Theory ◽  
Spin Polarized ◽  
Planar Carbon

The catalytic performance of Pd/Pt embedded planar carbon nitride for CO oxidation has been investigated via spin-polarized density functional theory calculations.

scholarly journals Do two oxidants (ferric-peroxo and ferryl-oxo species) act in the biosynthesis of estrogens? A DFT calculation

RSC Advances ◽  
2018 ◽  
Vol 8 (27) ◽  
pp. 15196-15201 ◽  
Author(s):  
Xiang-Yun Wang ◽  
Hui-Min Yan ◽  
Yan-Li Han ◽  
Zhu-Xia Zhang ◽  
Xiao-Yun Zhang ◽  
...  
Keyword(s):  
Density Functional Theory ◽  
Density Functional ◽  
Dft Calculation ◽  
Density Functional Theory Calculations ◽  
Functional Theory ◽  
Two Oxidants ◽  
Ferric Peroxo

Density functional theory calculations were performed in order to reveal the mysterious catalytic step of the biosynthesis of estrogens.

Spin Alignment Studies on the Muon-Site Determination in La2CuO4

2020 ◽  
Vol 860 ◽  
pp. 154-159
Author(s):  
Muhammad Redo Ramadhan ◽  
Irwan Ramli ◽  
Dita Puspita Sari ◽  
Budhy Kurniawan ◽  
Azwar Manaf ◽  
...  
Keyword(s):  
Density Functional Theory ◽  
Potential Distribution ◽  
Density Functional ◽  
Dft Calculation ◽  
Minimum Energy ◽  
Point Dipole ◽  
Spin Alignment ◽  
Functional Theory ◽  
Muon Site ◽  
Insulating Gap

Here we report spin-alignment contributions to muon coordinate calculated utilizing density functional theory (DFT) calculation. We estimated four different antiferromagnetic (AF) spin alignments in La2CuO4. We observed small changes by adjusting spin configurations in DFT calculations. Cu-spin value of 0.61 µB is constant in all calculations. The insulating gap of 1.9 eV is unchanged in all configurations. Muon coordinate was defined as the most minimum energy in atomic potential distribution. By assuming that Cu-spin is a point dipole for each atom, internal fields for muon were calculated and compared to known experimental results.

Catalytic performance of graphene quantum dot supported manganese phthalocyanine for efficient oxygen reduction: density functional theory approach

2019 ◽  
Vol 43 (1) ◽  
pp. 348-355 ◽  
Author(s):  
Nguyet N. T. Pham ◽  
Jong S. Park ◽  
Hee-Tak Kim ◽  
Hyoung-Juhn Kim ◽  
Young-A Son ◽  
...  
Keyword(s):  
Density Functional Theory ◽  
Free Energy ◽  
Quantum Dot ◽  
Oxygen Reduction ◽  
Density Functional ◽  
Catalytic Performance ◽  
Theory Approach ◽  
Functional Theory ◽  
Graphene Quantum Dot ◽  
Orr Activity

The thermodynamic free-energy diagrams predict that MnPc/GQD is more active toward ORR than the isolated MnPc, clearly highlighting the effect of the GQD matrix on ORR activity from a thermodynamic perspective.

scholarly journals Influence of Varying Functionalization on the Peroxidase Activity of Nickel(II)–Pyridine Macrocycle Catalysts: Mechanistic Insights from Density Functional Theory

Computation ◽  
2020 ◽  
Vol 8 (2) ◽  
pp. 52
Author(s):  
Jerwin Jay E. Taping ◽  
Junie B. Billones ◽  
Voltaire G. Organo
Keyword(s):  
Density Functional Theory ◽  
Proton Transfer ◽  
Density Functional ◽  
Experimental Studies ◽  
Density Functional Theory Calculations ◽  
Catalytic Performance ◽  
Stoichiometric Ratio ◽  
Functional Theory ◽  
Pendant Arm ◽  
Spin Singlet

Nickel(II) complexes of mono-functionalized pyridine-tetraazamacrocycles (PyMACs) are a new class of catalysts that possess promising activity similar to biological peroxidases. Experimental studies with ABTS (2,2′-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid), substrate) and H2O2 (oxidant) proposed that hydrogen-bonding and proton-transfer reactions facilitated by their pendant arm were responsible for their catalytic activity. In this work, density functional theory calculations were performed to unravel the influence of pendant arm functionalization on the catalytic performance of Ni(II)–PyMACs. Generated frontier orbitals suggested that Ni(II)–PyMACs activate H2O2 by satisfying two requirements: (1) the deprotonation of H2O2 to form the highly nucleophilic HOO−, and (2) the generation of low-spin, singlet state Ni(II)–PyMACs to allow the binding of HOO−. COSMO solvation-based energies revealed that the O–O Ni(II)–hydroperoxo bond, regardless of pendant arm type, ruptures favorably via heterolysis to produce high-spin (S = 1) [(L)Ni3+–O·]2+ and HO−. Aqueous solvation was found crucial in the stabilization of charged species, thereby favoring the heterolytic process over homolytic. The redox reaction of [(L)Ni3+–O·]2+ with ABTS obeyed a 1:2 stoichiometric ratio, followed by proton transfer to produce the final intermediate. The regeneration of Ni(II)–PyMACs at the final step involved the liberation of HO−, which was highly favorable when protons were readily available or when the pKa of the pendant arm was low.

Sign in / Sign up

Export Citation Format

Share Document