scholarly journals A 12-Gb/s Stacked Dual-Channel Interface for CMOS Image Sensor Systems

Sensors ◽  
2018 ◽  
Vol 18 (8) ◽  
pp. 2709
Author(s):  
Sang-Hoon Kim ◽  
Hoon Shin ◽  
Youngkyun Jeong ◽  
June-Hee Lee ◽  
Jaehyuk Choi ◽  
...  
Keyword(s):  
Transition Density ◽  
Complementary Metal Oxide Semiconductor ◽  
Clock And Data Recovery ◽  
Cmos Technology ◽  
Image Sensor ◽  
Data Recovery ◽  
Oxide Semiconductor ◽  
Dual Channel ◽  
Charge Recycling ◽  
The Common

We propose a dual-channel interface architecture that allocates high and low transition-density bit streams to two separate channels. The transmitter utilizes the stacked drivers with charge-recycling to reduce the power consumption. The direct current (DC)-coupled receiver front-end circuits manage the common-mode level variations and compensate for the channel loss. The tracked oversampling clock and data recovery (CDR), which realizes fast lock acquisition below 1 baud period and low logic latency, is shared by the two channels. Fabricated in a 65-nm low-power complementary metal-oxide semiconductor (CMOS) technology, the dual-channel transceiver achieves 12-Gb/s data rate while the transmitter consumes 20.43 mW from a 1.2-V power supply.

scholarly journals Polarisation analysing complementary metal-oxide semiconductor image sensor in 65-nm standard CMOS technology

2013 ◽  
Vol 2013 (9) ◽  
pp. 45-47 ◽  
Author(s):  
N. Wakama ◽  
D. Okabayashi ◽  
T. Noda ◽  
K. Sasagawa ◽  
T. Tokuda ◽  
...  
Keyword(s):  
Metal Oxide ◽  
Complementary Metal Oxide Semiconductor ◽  
Cmos Technology ◽  
Image Sensor ◽  
Metal Oxide Semiconductor ◽  
Oxide Semiconductor

scholarly journals Design of Common-Source/Drain Active Balun Using 90nm CMOS Technology

2019 ◽  
pp. 1-9
Author(s):  
Frederick Ray I. Gomez ◽  
Maria Theresa G. De Leon ◽  
John Richard E. Hizon
Keyword(s):  
Phase Difference ◽  
Noise Figure ◽  
Supply Voltage ◽  
Complementary Metal Oxide Semiconductor ◽  
Cmos Technology ◽  
Metal Oxide Semiconductor ◽  
Oxide Semiconductor ◽  
Common Source ◽  
Active Balun ◽  
The Common

This research paper presents a design and study of a common-source/drain active balun circuit implemented in a standard 90-nm complementary metal-oxide semiconductor (CMOS) technology.  The active balun design is intended for worldwide interoperability for microwave access (WiMAX) application, with operating frequency of 5.8GHz and supply voltage of 1V.  Measurements are taken for parameters namely gain difference, phase difference, and noise figure.  The common-source active balun design achieved a minimal gain difference of 0.016dB, phase difference of 180° ± 7.1°, and noise figure of 7.42-9.85dB, which are comparable to past active balun designs and researches.  The design eventually achieved a low power consumption of 2.56mW.

Computational study of the staircase molecular conductivity of polyoxovanadates adsorbed on Au(111)

2021 ◽  
Vol 50 (16) ◽  
pp. 5540-5551
Author(s):  
Almudena Notario-Estévez ◽  
Xavier López ◽  
Coen de Graaf
Keyword(s):  
Metal Oxide ◽  
Computational Study ◽  
Complementary Metal Oxide Semiconductor ◽  
Cmos Technology ◽  
Metal Oxide Semiconductor ◽  
Oxide Semiconductor ◽  
Molecular Conduction ◽  
Conduction Properties ◽  
Molecular Conductivity

This computational study presents the molecular conduction properties of polyoxovanadates V6O19 (Lindqvist-type) and V18O42, as possible successors of the materials currently in use in complementary metal–oxide semiconductor (CMOS) technology.

scholarly journals Investigation of PVT-Aware STT-MRAM Sensing Circuits for Low-VDD Scenario

Micromachines ◽  
2021 ◽  
Vol 12 (5) ◽  
pp. 551
Author(s):  
Zhongjian Bian ◽  
Xiaofeng Hong ◽  
Yanan Guo ◽  
Lirida Naviner ◽  
Wei Ge ◽  
...  
Keyword(s):  
Nonvolatile Memory ◽  
High Speed ◽  
Low Voltage ◽  
Supply Voltage ◽  
Random Access ◽  
Magnetic Tunnel Junction ◽  
Complementary Metal Oxide Semiconductor ◽  
Current Mode ◽  
Cmos Technology ◽  
Oxide Semiconductor

Spintronic based embedded magnetic random access memory (eMRAM) is becoming a foundry validated solution for the next-generation nonvolatile memory applications. The hybrid complementary metal-oxide-semiconductor (CMOS)/magnetic tunnel junction (MTJ) integration has been selected as a proper candidate for energy harvesting, area-constraint and energy-efficiency Internet of Things (IoT) systems-on-chips. Multi-VDD (low supply voltage) techniques were adopted to minimize energy dissipation in MRAM, at the cost of reduced writing/sensing speed and margin. Meanwhile, yield can be severely affected due to variations in process parameters. In this work, we conduct a thorough analysis of MRAM sensing margin and yield. We propose a current-mode sensing amplifier (CSA) named 1D high-sensing 1D margin, high 1D speed and 1D stability (HMSS-SA) with reconfigured reference path and pre-charge transistor. Process-voltage-temperature (PVT) aware analysis is performed based on an MTJ compact model and an industrial 28 nm CMOS technology, explicitly considering low-voltage (0.7 V), low tunneling magnetoresistance (TMR) (50%) and high temperature (85 °C) scenario as the worst sensing case. A case study takes a brief look at sensing circuits, which is applied to in-memory bit-wise computing. Simulation results indicate that the proposed high-sensing margin, high speed and stability sensing-sensing amplifier (HMSS-SA) achieves remarkable performance up to 2.5 GHz sensing frequency. At 0.65 V supply voltage, it can achieve 1 GHz operation frequency with only 0.3% failure rate.

A 5-Gbit/s Clock- and Data-Recovery Circuit With 1/8-Rate Linear Phase Detector in 0.18-${\rm \mu}\hbox{m}$ CMOS Technology

2009 ◽  
Vol 56 (1) ◽  
pp. 6-10 ◽  
Author(s):  
Young-Suk Seo ◽  
Jang-Woo Lee ◽  
Hong-Jung Kim ◽  
Changsik Yoo ◽  
Jae-Jin Lee ◽  
...  
Keyword(s):  
Clock And Data Recovery ◽  
Cmos Technology ◽  
Data Recovery ◽  
Phase Detector ◽  
Linear Phase

Design of 25-Gb/s Half-Rate Clock and Data Recovery Circuit for Optical Communication

2013 ◽  
Vol 385-386 ◽  
pp. 1278-1281 ◽  
Author(s):  
Zheng Fei Hu ◽  
Ying Mei Chen ◽  
Shao Jia Xue
Keyword(s):  
Optical Communication ◽  
Input Data ◽  
Clock And Data Recovery ◽  
Cmos Technology ◽  
Data Recovery ◽  
Phase Detector ◽  
Voltage Controlled Oscillator ◽  
Output Data ◽  
Data Phase ◽  
Simulation Results

A 25-Gb/s clock and data recovery (CDR) circuit with 1:2 demultiplexer which incorporates a quadrature LC voltage-controlled-oscillator and a half-rate bang-bang phase detector is presented in this paper. A quadrature LC VCO is presented to generate the four-phase output clocks. A half-rate phase detector including four flip-flops samples the 25-Gb/s input data every 20 ps and alignes the data phase. The 25-Gb/s data are retimed and demultiplexed into two 12.5-Gb/s output data. The CDR is designed in TSMC 65nm CMOS Technology. Simulation results show that the recovered clock exhibits a peak-to-peak jitter of 0.524ps and the recovered data exhibits a peak-to-peak jitter of 1.2ps. The CDR circuit consumes 121 mW from a 1.2 V supply.

Deep-Submicron Single-Gate Complementary Metal Oxide Semiconductor (CMOS) Technology Using Channel Preamorphization

1998 ◽  
Vol 37 (Part 1, No. 3B) ◽  
pp. 1050-1053 ◽  
Author(s):  
Masayasu Miyake ◽  
Toshio Kobayashi ◽  
Yutaka Sakakibara ◽  
Kimiyoshi Deguchi ◽  
Mitsutoshi Takahashi
Keyword(s):  
Metal Oxide ◽  
Complementary Metal Oxide Semiconductor ◽  
Cmos Technology ◽  
Deep Submicron ◽  
Metal Oxide Semiconductor ◽  
Oxide Semiconductor

A 60 GHz reconfigurable active phase shifter based on a vector modulator in 65 nm CMOS technology

2016 ◽  
Vol 8 (3) ◽  
pp. 399-404 ◽  
Author(s):  
Boris Moret ◽  
Nathalie Deltimple ◽  
Eric Kerhervé ◽  
Baudouin Martineau ◽  
Didier Belot
Keyword(s):  
Phase Shift ◽  
Phase Shifter ◽  
Complementary Metal Oxide Semiconductor ◽  
Active Phase ◽  
Cmos Technology ◽  
Oxide Semiconductor ◽  
60 Ghz ◽  
Semiconductor Technology ◽  
Vector Modulator ◽  
Active Phase Shifter

This paper presents a 60 GHz reconfigurable active phase shifter based on a vector modulator implemented in 65 nm complementary metal–oxide–semiconductor technology. This circuit is based on the recombination of two differential paths in quadrature. The proposed vector modulator allows us to generate a phase shift between 0° and 360°. The voltage gain varies between −13 and −9 dB in function of the phase shift generated with a static consumption between 26 and 63 mW depending on its configuration.

scholarly journals Low Power Robust Early Output Asynchronous Block Carry Lookahead Adder with Redundant Carry Logic

Electronics ◽  
2018 ◽  
Vol 7 (10) ◽  
pp. 243 ◽  
Author(s):  
Padmanabhan Balasubramanian ◽  
Douglas Maskell ◽  
Nikos Mastorakis
Keyword(s):  
Low Power ◽  
Digital Signal Processor ◽  
Digital Signal ◽  
Complementary Metal Oxide Semiconductor ◽  
Low Power Design ◽  
Cmos Technology ◽  
General Purpose ◽  
Metal Oxide Semiconductor ◽  
Oxide Semiconductor ◽  
Power Cycle

Adder is an important datapath unit of a general-purpose microprocessor or a digital signal processor. In the nanoelectronics era, the design of an adder that is modular and which can withstand variations in process, voltage and temperature are of interest. In this context, this article presents a new robust early output asynchronous block carry lookahead adder (BCLA) with redundant carry logic (BCLARC) that has a reduced power-cycle time product (PCTP) and is a low power design. The proposed asynchronous BCLARC is implemented using the delay-insensitive dual-rail code and adheres to the 4-phase return-to-zero (RTZ) and the 4-phase return-to-one (RTO) handshaking. Many existing asynchronous ripple-carry adders (RCAs), carry lookahead adders (CLAs) and carry select adders (CSLAs) were implemented alongside to perform a comparison based on a 32/28 nm complementary metal-oxide-semiconductor (CMOS) technology. The 32-bit addition was considered for an example. For implementation using the delay-insensitive dual-rail code and subject to the 4-phase RTZ handshaking (4-phase RTO handshaking), the proposed BCLARC which is robust and of early output type achieves: (i) 8% (5.7%) reduction in PCTP compared to the optimum RCA, (ii) 14.9% (15.5%) reduction in PCTP compared to the optimum BCLARC, and (iii) 26% (25.5%) reduction in PCTP compared to the optimum CSLA.

Sign in / Sign up

Export Citation Format

Share Document