scholarly journals Desorption of Implanted Deuterium in Heavy Ion-Irradiated Zry-2

2021 ◽  
Vol 5 (2) ◽  
pp. 9
Author(s):  
Hideo Watanabe ◽  
Yoshiki Saita ◽  
Katsuhito Takahashi ◽  
Kazufumi Yasunaga
Keyword(s):  
Electron Microscope ◽  
Defect Formation ◽  
Ion Irradiation ◽  
Spherical Aberration ◽  
Thermal Desorption Spectroscopy ◽  
Heavy Ion ◽  
Dislocation Loops ◽  
Fuel Cladding ◽  
Hydrogen Pickup ◽  
Radiation Induced

To understand the degradation behavior of light water reactor (LWR) fuel-cladding tubes under neutron irradiation, a detailed mechanism of hydrogen pickup related to the point defect formation (i.e., a-component and c-component dislocation loops) and to the dissolution of precipitates must be elucidated. In this study, 3.2 MeV Ni3+ ion irradiation was conducted on Zircaloy-2 samples at room temperature. Thermal desorption spectroscopy is used to evaluate the deuterium desorption with and without Ni3+ ion irradiation. A conventional transmission electron microscope and a spherical aberration-corrected high-resolution analytical electron microscope are used to observe the microstructure. The experimental results indicate that radiation-induced dislocation loops and hydrides form in Zircaloy-2 and act as major trapping sites at lower (400–600 °C) and higher (700–900 °C)-temperature regions, respectively. These results show that the detailed microstructural changes related to the hydrogen pickup at the defect sinks formed by irradiation are necessary for the degradation of LWR fuel-cladding tubes during operation.

Xenon ion irradiation of superconducting YBa2Cu3O7 thin films

1990 ◽  
Vol 48 (4) ◽  
pp. 92-93
Author(s):  
H. Watanabe ◽  
B. Kabius ◽  
B. Roas ◽  
K. Urban
Keyword(s):  
Defect Formation ◽  
Ion Irradiation ◽  
High Resolution Electron Microscopy ◽  
Structural Disorder ◽  
Flux Lines ◽  
Pinning Effect ◽  
Magnetic Flux Lines ◽  
Resolution Electron ◽  
Radiation Induced ◽  
Induced Defects

Recently it was reported that the critical current density(Jc) of YBa2Cu2O7, in the presence of magnetic field, is enhanced by ion irradiation. The enhancement is thought to be due to the pinning of the magnetic flux lines by radiation-induced defects or by structural disorder. The aim of the present study was to understand the fundamental mechanisms of the defect formation in association with the pinning effect in YBa2Cu3O7 by means of high-resolution electron microscopy(HRTEM).The YBa2Cu3O7 specimens were prepared by laser ablation in an insitu process. During deposition, a substrate temperature and oxygen atmosphere were kept at about 1073 K and 0.4 mbar, respectively. In this way high quality epitaxially films can be obtained with the caxis parallel to the <100 > SrTiO3 substrate normal. The specimens were irradiated at a temperature of 77 K with 173 MeV Xe ions up to a dose of 3.0 × 1016 m−2.

Nucleation and amorphization of radiation-produced phases in a modified austenitic stainless steel during Ni-ion irradiation

1988 ◽  
Vol 3 (5) ◽  
pp. 840-844 ◽  
Author(s):  
E. H. Lee ◽  
E. A. Kenik
Keyword(s):  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Ion Irradiation ◽  
Amorphous State ◽  
Dislocation Loops ◽  
Nickel Ion ◽  
Carbide Phases ◽  
Direct Formation ◽  
Radiation Induced ◽  
Lower Temperature

The nucleation and amorphization of radiation-induced (G) and radiation-enhanced (η) phases in a silicon- and titanium-modified austenitic stainless steel have been studied under nickel-ion irradiation. These silicon- and nickel-enriched phases form under high-temperature (950 K) irradiation as the result of radiation-induced segregation to radiation-produced interstitial dislocation loops. Availability of carbon promotes the formation of η phase relative to G phase. Under lower temperature (450 K) irradiation, G and η phases are amorphized without significant change in composition of metallic elements. Two carbide phases (MC, M23C6) remain crystalline for the same irradiation conditions. The amorphization of the silicides may result from (1) radiation damage increasing their free energy above that of the amorphous state or (2) direct formation of the amorphous phase in the damage cascade.

scholarly journals Dislocation Loop Generation Differences between Thin Films and Bulk in EFDA Pure Iron under Self-Ion Irradiation at 20 MeV

Metals ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 2000
Author(s):  
Marcelo Roldán ◽  
Fernando José Sánchez ◽  
Pilar Fernández ◽  
Christophe J. Ortiz ◽  
Adrián Gómez-Herrero ◽  
...  
Keyword(s):  
Thin Films ◽  
Computational Models ◽  
Defect Formation ◽  
Ion Irradiation ◽  
Damage Zone ◽  
High Energy ◽  
Model Material ◽  
Dislocation Nucleation ◽  
Dislocation Loops ◽  
Experimental Conditions

In the present investigation, high-energy self-ion irradiation experiments (20 MeV Fe+4) were performed on two types of pure Fe samples to evaluate the formation of dislocation loops as a function of material volume. The choice of model material, namely EFDA pure Fe, was made to emulate experiments simulated with computational models that study defect evolution. The experimental conditions were an ion fluence of 4.25 and 8.5 × 1015 ions/cm2 and an irradiation temperature of 350 and 450 °C, respectively. First, the ions pass through the samples, which are thin films of less than 100 nm. With this procedure, the formation of the accumulated damage zone, which is the peak where the ions stop, and the injection of interstitials are prevented. As a result, the effect of two free surfaces on defect formation can be studied. In the second type of experiments, the same irradiations were performed on bulk samples to compare the creation of defects in the first 100 nm depth with the microstructure found in the whole thickness of the thin films. Apparent differences were found between the thin foil irradiation and the first 100 nm in bulk specimens in terms of dislocation loops, even with a similar primary knock-on atom (PKA) spectrum. In thin films, the most loops identified in all four experimental conditions were b ±a0<100>{200} type with sizes of hundreds of nm depending on the experimental conditions, similarly to bulk samples where practically no defects were detected. These important results would help validate computational simulations about the evolution of defects in alpha iron thin films irradiated with energetic ions at large doses, which would predict the dislocation nucleation and growth.

scholarly journals Protective Effects of p53 Regulatory Agents Against High-LET Radiation-Induced Injury in Mice

2020 ◽  
Vol 8 ◽  
Author(s):  
Akinori Morita ◽  
Bing Wang ◽  
Kaoru Tanaka ◽  
Takanori Katsube ◽  
Masahiro Murakami ◽  
...  
Keyword(s):  
Cell Death ◽  
Radiation Injury ◽  
Ion Irradiation ◽  
Heavy Ion ◽  
Protective Effects ◽  
Iron Ion ◽  
Normal Tissues ◽  
High Let Radiation ◽  
High Let ◽  
Radiation Induced

Radiation damage to normal tissues is one of the most serious concerns in radiation therapy, and the tolerance dose of the normal tissues limits the therapeutic dose to the patients. p53 is well known as a transcription factor closely associated with radiation-induced cell death. We recently demonstrated the protective effects of several p53 regulatory agents against low-LET X- or γ-ray-induced damage. Although it was reported that high-LET heavy ion radiation (&gt;85 keV/μm) could cause p53-independent cell death in some cancer cell lines, whether there is any radioprotective effect of the p53 regulatory agents against the high-LET radiation injury in vivo is still unclear. In the present study, we verified the efficacy of these agents on bone marrow and intestinal damages induced by high-LET heavy-ion irradiation in mice. We used a carbon-beam (14 keV/μm) that was shown to induce a p53-dependent effect and an iron-beam (189 keV/μm) that was shown to induce a p53-independent effect in a previous study. Vanadate significantly improved 60-day survival rate in mice treated with total-body carbon-ion (p &lt; 0.0001) or iron-ion (p &lt; 0.05) irradiation, indicating its effective protection of the hematopoietic system from radiation injury after high-LET irradiation over 85 keV/μm. 5CHQ also significantly increased the survival rate after abdominal carbon-ion (p &lt; 0.02), but not iron-ion irradiation, suggesting the moderate relief of the intestinal damage. These results demonstrated the effectiveness of p53 regulators on acute radiation syndrome induced by high-LET radiation.

Swift heavy ion irradiation of ZnO nanoparticles embedded in silica: Radiation-induced deoxidation and shape elongation

2013 ◽  
Vol 103 (20) ◽  
pp. 203106 ◽  
Author(s):  
H. Amekura ◽  
N. Okubo ◽  
N. Ishikawa ◽  
D. Tsuya ◽  
K. Mitsuishi ◽  
...  
Keyword(s):  
Zno Nanoparticles ◽  
Ion Irradiation ◽  
Heavy Ion ◽  
Swift Heavy Ion Irradiation ◽  
Heavy Ion Irradiation ◽  
Swift Heavy Ion ◽  
Radiation Induced

scholarly journals NADPH Oxidase Activation Contributes to Heavy Ion Irradiation–Induced Cell Death

Dose-Response ◽  
2017 ◽  
Vol 15 (1) ◽  
pp. 155932581769969 ◽  
Author(s):  
Yupei Wang ◽  
Qing Liu ◽  
Weiping Zhao ◽  
Xin Zhou ◽  
Guoying Miao ◽  
...  
Keyword(s):  
Cell Death ◽  
Nadph Oxidase ◽  
Ion Irradiation ◽  
Heavy Ion ◽  
Ros Generation ◽  
Heavy Ion Irradiation ◽  
Radiation Induced ◽  
Heavy Ion Radiation ◽  
Nox Family ◽  
Nadph Oxidase Activation

Increased oxidative stress plays an important role in heavy ion radiation–induced cell death. The mechanism involved in the generation of elevated reactive oxygen species (ROS) is not fully illustrated. Here we show that NADPH oxidase activation is closely related to heavy ion radiation–induced cell death via excessive ROS generation. Cell death and cellular ROS can be greatly reduced in irradiated cancer cells with the preincubation of diphenyleneiodium, an inhibitor of NADPH oxidase. Most of the NADPH oxidase (NOX) family proteins (NOX1, NOX2, NOX3, NOX4, and NOX5) showed increased expression after heavy ion irradiation. Meanwhile, the cytoplasmic subunit p47phox was translocated to the cell membrane and localized with NOX2 to form reactive NADPH oxidase. Our data suggest for the first time that ROS generation, as mediated by NADPH oxidase activation, could be an important contributor to heavy ion irradiation–induced cell death.

scholarly journals Effects of the Surface on Displacement Cascades Produced by Heavy-Ion Irradiation of Ni3Al and Cu3Au

1996 ◽  
Vol 439 ◽  
Author(s):  
S. Müller ◽  
M. L. Jenkins ◽  
C. Abromeit ◽  
H. Wollenberger
Keyword(s):  
Ion Irradiation ◽  
Incident Angle ◽  
Ion Beam ◽  
Heavy Ion ◽  
Small Population ◽  
Dislocation Loops ◽  
Near Surface ◽  
Ion Energy ◽  
Heavy Ion Irradiation ◽  
Transmission Electron

AbstractStereo transmission electron microscopy has been used to characterise the distribution in depth of disordered zones and associated dislocation loops in the ordered alloys Ni3Al and Cu3Au after heavy ion irradiation, most extensively for Ni3Al irradiated with 50 keV Ta+ ions at a temperature of 573 K. The Cu3Au specimen was irradiated with 50 keV Ni+ ions at an incident angle of 45° at a temperature of 373 K. In Ni3Al the defect yield, i.e. the probability for a disordered zone to contain a loop was found to be strongly dependent on the depth of the zone in the foil, varying from about 0.7 for near-surface zones to about 0.2 in the bulk. The sizes and shapes of disordered zones were only weakly dependent on depth, except for a small population of zones very near the surface which were strongly elongated parallel to the incident ion beam. In Cu3Au the surface had a smaller but still significant effect on the defect yield. The dependence of the tranverse disordered zone diameter d on ion energy E for Ta+ irradiation of NiA was found to follow a relationship d = k1, E1/α with k, = 2.4 ± 0.4 and α = 3.3 ± 0.4. A similar relationship with the same value of α is valid for a wide variety of incident ion/target combinations found in the literature.

Sign in / Sign up

Export Citation Format

Share Document