scholarly journals Peculiarities of Thermodynamic Behaviors of Xenon Adsorption on the Activated Carbon Prepared from Silicon Carbide

Nanomaterials ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 971
Author(s):  
Ilya Men’shchikov ◽  
Andrey Shkolin ◽  
Elena Khozina ◽  
Anatoly Fomkin
Keyword(s):  
Silicon Carbide ◽  
Activated Carbon ◽  
Textural Properties ◽  
Bound State ◽  
High Energy ◽  
Adsorption System ◽  
Temperature Range ◽  
Adsorption Sites ◽  
Xenon Adsorption ◽  
Nitrogen Vapor

An activated carbon prepared from silicon carbide by thermochemical synthesis and designated as SiC-AC was studied as an adsorbent for xenon. The examination of textural properties of the SiC-AC adsorbent by nitrogen vapor adsorption measurements at 77 K, powder X-ray diffraction, and scanning electron microscopy revealed a relatively homogeneous microporous structure, a low content of heteroatoms, and an absence of evident transport macropores. The study of xenon adsorption and adsorption-induced deformation of the Si-AC adsorbent over the temperature range of 178 to 393 K and pressures up to 6 MPa disclosed the contraction of the material up to −0.01%, followed by its expansion up to 0.49%. The data on temperature-induced deformation of Si-AC measured within the 260 to 575 K range was approximated by a linear function with a thermal expansion factor of (3 ± 0.15) × 10−6 K−1. These findings of the SiC-AC non-inertness taken together with the non-ideality of an equilibrium xenon gaseous phase allowed us to make accurate calculations of the differential isosteric heats of adsorption, entropy, enthalpy, and heat capacity of the Xe/SiC-AC adsorption system from the experimental adsorption data over the temperature range from 178 to 393 K and pressures up to 6 MPa. The variations in the thermodynamic state functions of the Xe/SiC-AC adsorption system with temperature and amount of adsorbed Xe were attributed to the transitions in the state of the adsorbate in the micropores of SiC-AC from the bound state near the high-energy adsorption sites to the molecular associates.

Assessment of alternate characterization tests for prediction of taste and odour control by granular activated carbon

2012 ◽  
Vol 12 (4) ◽  
pp. 531-539 ◽  
Author(s):  
Kyla Smith ◽  
Xiaodan Zhang ◽  
Ron Hofmann
Keyword(s):  
Activated Carbon ◽  
Natural Waters ◽  
Activated Carbons ◽  
High Energy ◽  
Bet Surface Area ◽  
Small Scale ◽  
Adsorption Sites ◽  
Surface Areas ◽  
Odour Control ◽  
American Society

The acetoxime number test was recently identified by the American Society for Testing and Materials as a method to characterize activated carbon. This adsorption isotherm gives information about the number of high energy adsorption sites on the surface of an activated carbon. A similar test uses tetrafluoromethane for the same purpose. In contrast, the more common iodine number and Brunauer, Emmet and Teller (BET) surface area parameters are a measure of the total number of adsorption sites. 2-Methylisoborneol (MIB) is reported to require high energy sites for removal, so it was hypothesized that data from acetoxime and tetrafluoromethane isotherm tests for different activated carbons would be better correlated to MIB removal than iodine numbers or BET surface areas. MIB breakthrough was monitored in rapid small-scale column tests (RSSCTs) using four natural waters and five activated carbons. Results showed no correlation between acetoxime or tetrafluoromethane isotherms and MIB breakthrough.

scholarly journals 1.8 V Aqueous Symmetric Carbon-Based Supercapacitors with Agarose-Bound Activated Carbons in an Acidic Electrolyte

Nanomaterials ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 1731
Author(s):  
Chih-Chung Lai ◽  
Feng-Hao Hsu ◽  
Su-Yang Hsu ◽  
Ming-Jay Deng ◽  
Kueih-Tzu Lu ◽  
...  
Keyword(s):  
Activated Carbon ◽  
Sulfuric Acid ◽  
Energy Density ◽  
Activated Carbons ◽  
High Energy ◽  
Aqueous Electrolytes ◽  
Alternative Material ◽  
Aqueous Cells ◽  
Acidic Electrolyte ◽  
Cycling Behavior

The specific energy of an aqueous carbon supercapacitor is generally small, resulting mainly from a narrow potential window of aqueous electrolytes. Here, we introduced agarose, an ecologically compatible polymer, as a novel binder to fabricate an activated carbon supercapacitor, enabling a wider potential window attributed to a high overpotential of the hydrogen-evolution reaction (HER) of agarose-bound activated carbons in sulfuric acid. Assembled symmetric aqueous cells can be galvanostatically cycled up to 1.8 V, attaining an enhanced energy density of 13.5 W h/kg (9.5 µW h/cm2) at 450 W/kg (315 µW/cm2). Furthermore, a great cycling behavior was obtained, with a 94.2% retention of capacitance after 10,000 cycles at 2 A/g. This work might guide the design of an alternative material for high-energy aqueous supercapacitors.

scholarly journals Na0.76V6O15/Activated Carbon Hybrid Cathode for High-Performance Lithium-Ion Capacitors

Materials ◽  
2020 ◽  
Vol 14 (1) ◽  
pp. 122
Author(s):  
Renwei Lu ◽  
Xiaolong Ren ◽  
Chong Wang ◽  
Changzhen Zhan ◽  
Ding Nan ◽  
...  
Keyword(s):  
Activated Carbon ◽  
Energy Density ◽  
Power Density ◽  
Cathode Materials ◽  
Low Cost ◽  
Lithium Ion ◽  
High Energy ◽  
Cycling Stability ◽  
High Energy Density ◽  
Artificial Graphite

Lithium-ion hybrid capacitors (LICs) are regarded as one of the most promising next generation energy storage devices. Commercial activated carbon materials with low cost and excellent cycling stability are widely used as cathode materials for LICs, however, their low energy density remains a significant challenge for the practical applications of LICs. Herein, Na0.76V6O15 nanobelts (NaVO) were prepared and combined with commercial activated carbon YP50D to form hybrid cathode materials. Credit to the synergism of its capacitive effect and diffusion-controlled faradaic effect, NaVO/C hybrid cathode displays both superior cyclability and enhanced capacity. LICs were assembled with the as-prepared NaVO/C hybrid cathode and artificial graphite anode which was pre-lithiated. Furthermore, 10-NaVO/C//AG LIC delivers a high energy density of 118.9 Wh kg−1 at a power density of 220.6 W kg−1 and retains 43.7 Wh kg−1 even at a high power density of 21,793.0 W kg−1. The LIC can also maintain long-term cycling stability with capacitance retention of approximately 70% after 5000 cycles at 1 A g−1. Accordingly, hybrid cathodes composed of commercial activated carbon and a small amount of high energy battery-type materials are expected to be a candidate for low-cost advanced LICs with both high energy density and power density.

Enabling highly reversible sodium metal cycling across a wide temperature range with dual-salt electrolytes

2021 ◽  
Author(s):  
Akila C. Thenuwara ◽  
Pralav P. Shetty ◽  
Neha Kondekar ◽  
Chuanlong Wang ◽  
Weiyang Li ◽  
...  
Keyword(s):  
Wide Temperature Range ◽  
High Energy ◽  
Liquid Electrolyte ◽  
Metal Cycling ◽  
Temperature Range ◽  
Sodium Metal ◽  
Wide Range

A new dual-salt liquid electrolyte is developed that enables the reversible operation of high-energy sodium-metal-based batteries over a wide range of temperatures down to −50 °C.

scholarly journals Development of Formaldehyde Adsorption using Modified Activated Carbon – A Review

2012 ◽  
Vol 1 (3) ◽  
pp. 75 ◽  
Author(s):  
W.D.P Rengga ◽  
M. Sudibandriyo ◽  
M Nasikin
Keyword(s):  
Activated Carbon ◽  
Activated Carbons ◽  
Chemical Activation ◽  
High Energy ◽  
Hydrogen Gas ◽  
Agricultural Product ◽  
Adsorption Method ◽  
Modified Activated Carbon ◽  
Nano Size ◽  
Formaldehyde Adsorption

Gas storage is a technology developed with an adsorptive storage method, in which gases are stored as adsorbed components on the certain adsorbent. Formaldehyde is one of the major indoor gaseous pollutants. Depending on its concentration, formaldehyde may cause minor disorder symptoms to a serious injury. Some of the successful applications of technology for the removal of formaldehyde have been reported. However, this paper presents an overview of several studies on the elimination of formaldehyde that has been done by adsorption method because of its simplicity. The adsorption method does not require high energy and the adsorbent used can be obtained from inexpensive materials. Most researchers used activated carbon as an adsorbent for removal of formaldehyde because of its high adsorption capacity. Activated carbons can be produced from many materials such as coals, woods, or agricultural waste. Some of them were prepared by specific activation methods to improve the surface area. Some researchers also used modified activated carbon by adding specific additive to improve its performance in attracting formaldehyde molecules. Proposed modification methods on activation and additive impregnated carbon are thus discussed in this paper for future development and improvement of formaldehyde adsorption on activated carbon. Specifically, a waste agricultural product is chosen for activated carbon raw material because it is renewable and gives an added value to the materials. The study indicates that the performance of the adsorption of formaldehyde might be improved by using modified activated carbon. Bamboo seems to be the most appropriate raw materials to produce activated carbon combined with applying chemical activation method and addition of metal oxidative catalysts such as Cu or Ag in nano size particles. Bamboo activated carbon can be developed in addition to the capture of formaldehyde as well as the storage of adsorptive hydrogen gas that supports renewable energy. Keywords: adsorption; bamboo; formaldehyde; modified activated carbon; nano size particles

Development of a new composite ceramic membrane from mullite, silicon carbide and activated carbon for treating greywater

2021 ◽  
Author(s):  
Behrouz Jafari ◽  
Edris Rezaei ◽  
Mohammad Javad Dianat ◽  
Mohsen Abbasi ◽  
Seyed Abdollatif Hashemifard ◽  
...  
Keyword(s):  
Silicon Carbide ◽  
Activated Carbon ◽  
Ceramic Membrane ◽  
Composite Ceramic

Temperature and the Regulation of Enzyme Activity in the Hibernator. Isoenzymes of Liver Pyruvate Kinase from the Hibernating and Non-hibernating Arctic Ground Squirrel

1974 ◽  
Vol 52 (10) ◽  
pp. 894-902 ◽  
Author(s):  
Hans W. Behrisch
Keyword(s):  
Molecular Weight ◽  
Pyruvate Kinase ◽  
Wide Temperature Range ◽  
Ground Squirrel ◽  
Energy Charge ◽  
High Energy ◽  
Ground Squirrels ◽  
The Arctic ◽  
Arctic Ground Squirrel ◽  
Temperature Range

Liver of the hibernating (H) Arctic ground squirrel (Citellus undulatus) contains a single species of pyruvate kinase (PyK) that is distinct from the single isoenzyme of pyK observed in the non-hibernating (NH) ground squirrel, which has been previously described (Behrisch &Johnson (1974) Can. J. Biochem. 52, 547–559). The H-PyK has a pI value of 5.7 and a molecular weight of 241 000 – 243 000. Affinity of the H-PyK for the substrates phosphoenolpyruvate (PEP) and ADP is not affected by changing temperature. It is argued that this stability of the apparent Km's for substrate over a wide temperature range permits the hibernator to take advantage of the Q10 effect in maintaining a low rate of the PyK reaction. Similarly, affinity of H-PyK for the allosteric activator fructose-1,6-phosphate (FDP) and the inhibitor ATP is also conspicuously independent of temperature, suggesting a fine stoichiometry in the relative concentrations of the regulatory ligands in control of H-PyK over a wide temperature range. Further, affinity of H-PyK for the inhibitor ATP is about three- to fourfold lower than that of the NH-PyK, a condition that would favor the maintenance of a high energy charge in the hibernating liver cell. ATP apparently inhibits PyK by causing a dissociation of the enzyme molecule into two "halves" of about 110 000 molecular weight each. This dissociation is offset and reversed by FDP. Removal of the ATP by dialysis does not of itself result in a reassociation of the PyK "halves"; FDP and/or the substrates are required for the two subunits of PyK to reassociate. As the apparent Ki of H-PyK for ATP is higher than that of NH-PyK, substantially higher concentrations of ATP are required to effect the dissociation of H-PyK. Similarly, elevated concentrations of FDP are required to offset the ATP-caused dissociation of the H-PyK.Hibernating Arctic ground squirrels that are preparing to emerge finally from the hibernating state already possess substantial activities of the NH-PyK isoenzyme. This suggests that the animal "anticipates" its transition from one metabolic state from another. On the basis of these data a formal mechanism is proposed for the regulation of liver PyK in the Arctic ground squirrel in both the non-hibernating and hibernating states.

Sign in / Sign up

Export Citation Format

Share Document