scholarly journals Impacts of Freezing Temperature Based Thermal Conductivity on the Heat Transfer Gradient in Nanofluids: Applications for a Curved Riga Surface

Molecules ◽  
2020 ◽  
Vol 25 (9) ◽  
pp. 2152
Author(s):  
Adnan ◽  
Syed Zulfiqar Ali Zaidi ◽  
Umar Khan ◽  
Naveed Ahmed ◽  
Syed Tauseef Mohyud-Din ◽  
...  
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Volume Fraction ◽  
Freezing Temperature ◽  
Effective Density ◽  
Similarity Transformations ◽  
Flow Parameters ◽  
Boundary Layer Region ◽  
Layer Region ◽  
Effective Models

The flow of nanofluid over a curved Riga surface is a topic of interest in the field of fluid dynamics. A literature survey revealed that the impacts of freezing temperature and the diameter of nanoparticles on the heat transfer over a curved Riga surface have not been examined so far. Therefore, the flow of nanoparticles, which comprises the influences of freezing temperature and nanoparticle diameter in the energy equation, was modeled over a curved Riga surface. The model was reduced successfully in the nondimensional version by implementing the feasible similarity transformations and effective models of nanofluids. The coupled nonlinear model was then examined numerically and highlighted the impacts of various flow quantities in the flow regimes and heat transfer, with graphical aid. It was examined that nanofluid velocity dropped by increasing the flow parameters γ and S, and an abrupt decrement occurred at the surface of the Riga sheet. The boundary layer region enhances for larger γ. The temperature distribution was enhanced for a more magnetized nanofluid, and the thermal boundary layer increased with a larger R parameter. The volume fraction of the nanoparticles favors the effective density and dynamic viscosity of the nanofluids. A maximum amount of heat transfer at the surface was observed for a more magnetized nanofluid.

scholarly journals The Effect of Heat Transfer on MHD Marangoni Boundary Layer Flow Past a Flat Plate in Nanofluid

2013 ◽  
Vol 2013 ◽  
pp. 1-6 ◽  
Author(s):  
D. R. V. S. R. K. Sastry ◽  
A. S. N. Murti ◽  
T. Poorna Kantha
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Differential Equations ◽  
Boundary Layer Flow ◽  
Numerical Solutions ◽  
Volume Fraction ◽  
Solid Volume Fraction ◽  
Convection Boundary Layer ◽  
Similarity Transformations ◽  
Layer Flow

The problem of heat transfer on the Marangoni convection boundary layer flow in an electrically conducting nanofluid is studied. Similarity transformations are used to transform the set of governing partial differential equations of the flow into a set of nonlinear ordinary differential equations. Numerical solutions of the similarity equations are then solved through the MATLAB “bvp4c” function. Different nanoparticles like Cu, Al2O3, and TiO2 are taken into consideration with water as base fluid. The velocity and temperature profiles are shown in graphs. Also the effects of the Prandtl number and solid volume fraction on heat transfer are discussed.

Simultaneous flow of ions and heat to a plate electrode in the region of natural convection

1979 ◽  
Vol 44 (6) ◽  
pp. 1857-1868 ◽  
Author(s):  
Petr Novák ◽  
Ivo Roušar
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Natural Convection ◽  
Convective Diffusion ◽  
Navier Stokes ◽  
Exponential Polynomials ◽  
Plate Electrode ◽  
Transfer Equations ◽  
Boundary Layer Region ◽  
Layer Region

The Sherwood criterion was calculated for a flow of ions to the surface of a plate electrode during natural convection by solving the Navier-Stokes, convective diffusion, and convective heat transfer equations. The solution for the boundary layer region was performed by the collocation method using orthogonal exponential polynomials. Values of the Sh criterion were obtained for Sc ##m <500; 2 000>, Pr ##m <5; 20>, and GrT/GrM ##m <0.2; 8.0>. A comparison with literature data revealed the best agreement with average errors of +2.0 and -1.4%. Another equation with an error of only +0.5% is proposed.

Effect of Nanofluid on Heat Transfer Enhancement for Mixed Convection Flow Over a Corrugated Surface

2020 ◽  
Vol 45 (4) ◽  
pp. 373-383
Author(s):  
Nepal Chandra Roy ◽  
Sadia Siddiqa
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Nusselt Number ◽  
Mixed Convection ◽  
Local Nusselt Number ◽  
Richardson Number ◽  
Thermal Boundary Layer ◽  
Volume Fraction ◽  
Convection Flow ◽  
Mixed Convection Flow

AbstractA mathematical model for mixed convection flow of a nanofluid along a vertical wavy surface has been studied. Numerical results reveal the effects of the volume fraction of nanoparticles, the axial distribution, the Richardson number, and the amplitude/wavelength ratio on the heat transfer of Al2O3-water nanofluid. By increasing the volume fraction of nanoparticles, the local Nusselt number and the thermal boundary layer increases significantly. In case of \mathrm{Ri}=1.0, the inclusion of 2 % and 5 % nanoparticles in the pure fluid augments the local Nusselt number, measured at the axial position 6.0, by 6.6 % and 16.3 % for a flat plate and by 5.9 % and 14.5 %, and 5.4 % and 13.3 % for the wavy surfaces with an amplitude/wavelength ratio of 0.1 and 0.2, respectively. However, when the Richardson number is increased, the local Nusselt number is found to increase but the thermal boundary layer decreases. For small values of the amplitude/wavelength ratio, the two harmonics pattern of the energy field cannot be detected by the local Nusselt number curve, however the isotherms clearly demonstrate this characteristic. The pressure leads to the first harmonic, and the buoyancy, diffusion, and inertia forces produce the second harmonic.

Study of the boundary layer heat transfer of nanofluids over a stretching sheet: Passive control of nanoparticles at the surface

2015 ◽  
Vol 93 (7) ◽  
pp. 725-733 ◽  
Author(s):  
M. Ghalambaz ◽  
E. Izadpanahi ◽  
A. Noghrehabadi ◽  
A. Chamkha
Keyword(s):  
Heat Transfer ◽  
Thermal Conductivity ◽  
Boundary Layer ◽  
Nusselt Number ◽  
Heat Transfer Enhancement ◽  
Base Fluid ◽  
Stretching Sheet ◽  
Volume Fraction ◽  
Enhancement Ratio ◽  
Transfer Enhancement

The boundary layer heat and mass transfer of nanofluids over an isothermal stretching sheet is analyzed using a drift-flux model. The relative slip velocity between the nanoparticles and the base fluid is taken into account. The nanoparticles’ volume fractions at the surface of the sheet are considered to be adjusted passively. The thermal conductivity and the dynamic viscosity of the nanofluid are considered as functions of the local volume fraction of the nanoparticles. A non-dimensional parameter, heat transfer enhancement ratio, is introduced, which shows the alteration of the thermal convective coefficient of the nanofluid compared to the base fluid. The governing partial differential equations are reduced into a set of nonlinear ordinary differential equations using appropriate similarity transformations and then solved numerically using the fourth-order Runge–Kutta and Newton–Raphson methods along with the shooting technique. The effects of six non-dimensional parameters, namely, the Prandtl number of the base fluid Prbf, Lewis number Le, Brownian motion parameter Nb, thermophoresis parameter Nt, variable thermal conductivity parameter Nc and the variable viscosity parameter Nv, on the velocity, temperature, and concentration profiles as well as the reduced Nusselt number and the enhancement ratio are investigated. Finally, case studies for Al2O3 and Cu nanoparticles dispersed in water are performed. It is found that increases in the ambient values of the nanoparticles volume fraction cause decreases in both the dimensionless shear stress f″(0) and the reduced Nusselt number Nur. Furthermore, an augmentation of the ambient value of the volume fraction of nanoparticles results in an increase the heat transfer enhancement ratio hnf/hbf. Therefore, using nanoparticles produces heat transfer enhancement from the sheet.

The Effect of Magnetic Field on Compressible Boundary Layer by Homotopy Analysis Method

2021 ◽  
Vol 88 (1-2) ◽  
pp. 125
Author(s):  
R. Madhusudhan ◽  
Achala L. Nargund ◽  
S. B. Sathyanarayana
Keyword(s):  
Magnetic Field ◽  
Boundary Layer ◽  
Homotopy Analysis Method ◽  
Adverse Pressure Gradient ◽  
Analysis Method ◽  
Boundary Layer Region ◽  
Homotopy Analysis ◽  
Curve Singularities ◽  
Large Injection ◽  
Layer Region

We analyse the effect of applied magnetic field on the flow of compressible fluid with an adverse pressure gradient. The governing partial differential equations are solved analytically by Homotopy analysis method (HAM) and numerically by finite difference method. A detailed analysis is carried out for different values of the magnetic parameter, where suction/ injection is imposed at the wall. It is also observed that flow separation is seen in boundary layer region for large injection. HAM is a series solution which consists of a convergence parameter h which is estimated numerically by plotting <em>h</em> curve. Singularities of the solution are identified by Pade approximation.

Role of mixed nanofluids on fluid flow and intensify energy transfer in a boundary layer region driven by a free convective force

2019 ◽  
Vol 48 (8) ◽  
pp. 3986-3999 ◽  
Author(s):  
B. Ammani Kuttan ◽  
S. Manjunatha ◽  
S. Jayanthi ◽  
B. J. Gireesha
Keyword(s):  
Boundary Layer ◽  
Energy Transfer ◽  
Fluid Flow ◽  
Boundary Layer Region ◽  
Layer Region
Sign in / Sign up

Export Citation Format

Share Document