scholarly journals Development of New Canned Chub Mackerel Products Incorporating Edible Seaweeds—Influence on the Minerals and Trace Elements Composition

Molecules ◽  
2020 ◽  
Vol 25 (5) ◽  
pp. 1133
Author(s):  
Elsa F. Vieira ◽  
Cristina Soares ◽  
Susana Machado ◽  
M. Teresa Oliva-Teles ◽  
Manuela Correia ◽  
...  

This study aimed to develop new canned chub mackerel products incorporating edible seaweeds (Ascophyllum nodosum, Fucus spiralis, Saccorhiza polyschides, Chondrus crispus, Porphyra sp. and Ulva sp.) harvested in the Portuguese North-Central coast, with simultaneous sensory improvement and minerals enrichment. Two processes were compared, namely the addition of seaweeds in i) the canning step and ii) in the brining step (as the replacement for salt). The concentrations of four macrominerals (Na, K, Ca and Mg), chloride, and twelve trace elements (Co, Cu, Fe, I, Li, Mn, Mo, Rb, Se, Sr, V and Zn) were determined by high-resolution continuum source flame atomic absorption spectrometry (HR-CS-FAAS) and inductively coupled plasma mass spectrometry (ICP-MS), respectively. Results showed that canned chub mackerel incorporating C. crispus and F. spiralis was found to be the preferred sensory option, also exhibiting contents enriched with Cl, Co, Cu, Fe, I, Li, Mg, Mn, Mo, Na, Rb, Se, and Sr. This effect was more pronounced when both seaweed species were added to replace the salt added in the brining step.

Minerals ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 57
Author(s):  
Nikolay Smagunov ◽  
Vladimir Tauson ◽  
Sergey Lipko ◽  
Dmitriy Babkin ◽  
Taisa Pastushkova ◽  
...  

Partitioning experiments were done by hydrothermal synthesis of crystals containing trace elements (TEs) by internal sampling of fluid at the temperature of 450 °C and pressure of 1 kbar. The crystal phases obtained were magnetite, hematite, and Ni-spinel, which were studied using X-ray diffraction (XRD), X-ray electron probe microanalysis (EPMA), laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS), atomic absorption spectrometry (AAS), and atomic force microscopy (AFM). The solutions from the sampler’s fluid probes were analysed by AAS for TEs included elements of the iron group plus aluminium. The highest co-crystallisation coefficients of TE and Fe between mineral and fluid (DTE/Fe) in magnetite were measured for V, Al, Ni and Cr (in decreasing order of n units in value), a lower value was observed for Co (2 × 10−1), and still lower values for Ti, Zn, and Mn (n × 10−2–10−3). In hematite, DTE/Fe values were highest for Al and V (order of n units in value), while lower values characterised Ti, Cr, and Co (n × 10−1–10−3), and the lowest values were exhibited by Cu, Mn, and Zn (n × 10−5). Copper was confirmed to be the most incompatible with all minerals studied; however, Cu had a high content on crystal surfaces. This surficial segregation contributes to the average TE concentration even when a thin layer of nonautonomous phase (NAP) is enriched in the element of interest. The accumulation of TEs on the surface of crystals increased bulk content 1–2 orders of magnitude above the content of structurally-bound elements even in coarse crystals. The inverse problem—evaluation of TE/Fe ratios in fluids involved in the formation of magnetite-containing deposits—revealed that the most abundant metals in fluids were Fe followed by Mn, Zn, and Cu, which comprised 10 to 30% of the total iron content.


2003 ◽  
Vol 86 (6) ◽  
pp. 1225-1231 ◽  
Author(s):  
Laurent Noël ◽  
Thierry Guérin ◽  
Jean-Marc Frémy ◽  
Hélène Huet ◽  
Martine Kolf-Clauw

Abstract A rapid procedure, based on closed vessels microwave digestion and inductively coupled plasma-mass spectrometry (ICP-MS), was evaluated to ascertain the effect of chronic exposure to cadmium on intracellular accumulation of minor and essential trace elements in cultured epithelial cells (Caco-2 TC7). For all measurements, the method of external calibration was used and 3 elements (Be, Sc, In) were selected as internal standards. Optimization procedures are discussed and results are presented for the total determination of 9 key analytes (Na, Mg, Ca, Cr, Mn, Cu, Zn, Mo, and Cd) in certified reference materials (CRMs) and 20 samples of Caco-2 TC7 cells long-term exposed to Cd. The performance characteristics of the analytical system were evaluated by calibration and linearity, limits of detection and quantitation, accuracy with spiking, trueness and repeatability with available CRMs. As a complement to the ICP-MS determinations, both available CRMs and cell samples were analyzed either by electro thermal-or flame atomic absorption spectrometry. The results were in good agreement with the ICP-MS results.


Sign in / Sign up

Export Citation Format

Share Document