scholarly journals Wind–Wave Coupling Effect on the Dynamic Response of a Combined Wind–Wave Energy Converter

2021 ◽  
Vol 9 (10) ◽  
pp. 1101
Author(s):  
Jinghui Li ◽  
Wei Shi ◽  
Lixian Zhang ◽  
Constantine Michailides ◽  
Xin Li
Keyword(s):  
Renewable Energy ◽  
Dynamic Response ◽  
Wave Energy ◽  
Wind Wave ◽  
Renewable Energy Sources ◽  
Wave Energy Converter ◽  
Coupled Analysis ◽  
Energy Converter ◽  
Combined System ◽  
Energy Devices

There is a huge energy demand from offshore renewable energy resources. To maximize the use of various renewable energy sources, a combined floating energy system consisting of different types of energy devices is an ideal option to reduce the levelized cost of energy (LCOE) by sharing the infrastructure of the platform and enhancing the power production capacity. This study proposed a combined concept of energy systems by combing a heave-type wave energy converter (WEC) with a semisubmersible floating wind turbine. In order to investigate the power performance and dynamic response of the combined concept, coupled aero-hydro-servo-elastic analysis was carried out using the open-source code F2A, which is based on the coupling of the FAST and AQWA tools by integrating all the possible environmental loadings (e.g., aerodynamic, hydrodynamic). Numerical results obtained by AQWA are used to verify the accuracy of the coupled model in F2A in predicting dynamic responses of the combined system. The main hydrodynamic characteristics of the combined system under typical operational conditions were examined, and the calculated responses (motions, mooring line tension and produced wave power) are discussed. Additionally, the effect of aerodynamic damping on the dynamic response of the combined system was examined and presented. Moreover, a second fully coupled analysis model was developed, and its response predictions were compared with the predictions of the model developed with F2A in order for the differences of the calculated responses resulted by the different modeling techniques to be discussed and explained. Finally, the survivability of the combined concept has been examined for different possible proposed survival modes.

Optimization of Mooring Configuration Parameters of Floating Wave Energy Converters

2011 ◽  
Author(s):  
Pedro C. Vicente ◽  
Anto´nio F. O. Falca˜o ◽  
Paulo A. P. Justino
Keyword(s):  
Wave Energy ◽  
Oil And Gas ◽  
Wave Energy Converter ◽  
Domain Model ◽  
Floating Point ◽  
Mooring System ◽  
Energy Converter ◽  
Energy Devices ◽  
Wave Energy Converters ◽  
Energy Converters

Floating point absorbers devices are a large class of wave energy converters for deployment offshore, typically in water depths between 40 and 100m. As floating oil and gas platforms, the devices are subject to drift forces due to waves, currents and wind, and therefore have to be kept in place by a proper mooring system. Although similarities can be found between the energy converting systems and floating platforms, the mooring design requirements will have some important differences between them, one of them associated to the fact that, in the case of a wave energy converter, the mooring connections may significantly modify its energy absorption properties by interacting with its oscillations. It is therefore important to examine what might be the more suitable mooring design for wave energy devices, according to the converters specifications. When defining a mooring system for a device, several initial parameters have to be established, such as cable material and thickness, distance to the mooring point on the bottom, and which can influence the device performance in terms of motion, power output and survivability. Different parameters, for which acceptable intervals can be established, will represent different power absorptions, displacements from equilibrium position, load demands on the moorings and of course also different costs. The work presented here analyzes what might be, for wave energy converter floating point absorber, the optimal mooring configuration parameters, respecting certain pre-established acceptable intervals and using a time-domain model that takes into account the non-linearities introduced by the mooring system. Numerical results for the mooring forces demands and also motions and absorbed power, are presented for two different mooring configurations for a system consisting of a hemispherical buoy in regular waves and assuming a liner PTO.

Testing the WET-NZ Wave Energy Converter Using the Ocean Sentinel Instrumentation Buoy

2013 ◽  
Vol 47 (4) ◽  
pp. 164-176 ◽  
Author(s):  
Terry Lettenmaier ◽  
Annette von Jouanne ◽  
Ean Amon ◽  
Sean Moran ◽  
Alister Gardiner
Keyword(s):  
Renewable Energy ◽  
New Zealand ◽  
Wave Energy ◽  
Test Site ◽  
Wave Energy Converter ◽  
Department Of Energy ◽  
State University ◽  
Energy Converter ◽  
Private Company ◽  
Research Consortium

AbstractThis paper describes ocean testing of the half-scale Wave Energy Technology-New Zealand (WET-NZ) prototype wave energy converter (WEC) using the Ocean Sentinel instrumentation buoy during a 6-week deployment period in August‐October 2012. These tests were conducted by the Northwest National Marine Renewable Energy Center (NNMREC) at its Pacific Ocean test site off the coast of Newport, Oregon. The WET-NZ is the product of a research consortium between Callaghan Innovation, a New Zealand Crown Entity, and Power Projects Limited (PPL), a Wellington, New Zealand private company. The Oregon deployment was project managed by Northwest Energy Innovations (NWEI), a Portland, OR firm. NNMREC is a Department of Energy sponsored partnership between Oregon State University (OSU), the University of Washington (UW), and the National Renewable Energy Laboratory (NREL). The Ocean Sentinel instrumentation buoy is a 6-m surface buoy, developed in 2012, that provides a stand-alone electrical load, WEC generator control, and data collection for WECs being tested. The Ocean Sentinel was deployed and operated for the first time during the 2012 WET-NZ tests. During these tests, the operation of the WET-NZ was demonstrated and its performance was characterized, while also proving successful deployment and operation of the Ocean Sentinel.

scholarly journals Nonlinear PTO Effect on Performance of Vertical Axisymmetric Wave Energy Converter Using Semi-Analytical Method

2017 ◽  
Vol 24 (s3) ◽  
pp. 49-57 ◽  
Author(s):  
Ming Liu ◽  
Hengxu Liu ◽  
Xiongbo Zheng ◽  
Hailong Chen ◽  
Liquan Wang ◽  
...  
Keyword(s):  
Wave Energy ◽  
Analytical Method ◽  
Renewable Energy Sources ◽  
Single Point ◽  
Ocean Waves ◽  
Wave Energy Converter ◽  
Energy Converter ◽  
Advantages And Disadvantages ◽  
Axisymmetric Wave ◽  
Efficient Power

Abstract The wave energy, as a clean and non-pollution renewable energy sources, has become a hot research topic at home and abroad and is likely to become a new industry in the future. In this article, to effectively extract and maximize the energy from ocean waves, a vertical axisymmetric wave energy converter (WEC) was presented according to investigating of the advantages and disadvantages of the current WEC. The linear and quadratic equations in frequency-domain for the reactive controlled single-point converter property under regular waves condition are proposed for an efficient power take-off (PTO). A method of damping coefficients, theoretical added mass and exciting force are calculated with the analytical method which is in use of the series expansion of eigen functions. The loads of optimal reactive and resistive, the amplitudes of corresponding oscillation, and the width ratios of energy capture are determined approximately and discussed in numerical results.

Loads and Dynamic Response of a Floating Wave Energy Converter due to Regular Waves From CFD Simulations

2016 ◽  
Author(s):  
Anna Büchner ◽  
Thomas Knapp ◽  
Martin Bednarz ◽  
Philipp Sinn ◽  
Arndt Hildebrandt
Keyword(s):  
Dynamic Response ◽  
Boundary Conditions ◽  
Wave Energy ◽  
Single Point ◽  
Breaking Waves ◽  
Wave Energy Converter ◽  
Wave Loads ◽  
Regular Waves ◽  
Energy Converter ◽  
Set Up

The commercial CFD code ANSYS Fluent is used for the three-dimensional estimation of wave loads and the dynamic response of a floating single point wave energy converter of the SINN Power wave power plant due to non-breaking and unidirectional waves in coastal waters. The VoF method is used to model the free surface and wave theories to set up the boundary conditions at the inlet for regular waves. The wave induced vertical motions of the floating module are computed by a sixDoF solver. Preliminary 2D and 3D studies to set up boundary conditions, mesh densities and solver settings were performed. The numerical results were compared to analytical solutions in form of water surface elevations and wave kinematics which showed good agreement. The paper presents the dynamic response of the floating module for different load cases in terms of non-breaking waves. The resulting horizontal and vertical forces at the floating module will be presented and explained by the flow dynamics. Time and space depending velocities and pressure distributions including details on vortex separation will be given, which reveal valuable insights on the contribution of inertia and drag forces leading to the dynamic structural response of the floating devices.

Comparison of Mooring Loads in Survivability Mode on the Wave Dragon Wave Energy Converter Obtained by a Numerical Model and Experimental Data

2012 ◽  
Author(s):  
Stefano Parmeggiani ◽  
Made Jaya Muliawan ◽  
Zhen Gao ◽  
Torgeir Moan ◽  
Erik Friis-Madsen
Keyword(s):  
Numerical Model ◽  
Wave Energy ◽  
Complex Geometry ◽  
Wave Energy Converter ◽  
Scale Model ◽  
Coupled Analysis ◽  
Small Scale ◽  
Energy Converter ◽  
Numerical Predictions ◽  
Small Scale Model

The Wave Dragon Wave Energy Converter is ready to be up-scaled to commercial size. The design and feasibility analysis of a 1.5 MW pre-commercial unit to be deployed at the DanWEC test center in Hanstholm, Denmark, is currently ongoing. With regard to the mooring system, the design has to be carried out numerically, through coupled analyses of alternative solutions. The present study deals with the preliminary hydrodynamic characterization of Wave Dragon needed in order to calibrate the numerical model to be used for the mooring design. A hydrodynamic analysis of the small scale model in the frequency domain is performed by the software HydroD, which uses WAMIT as core software. The quadratic damping term, accounting for the viscous effect, is determined through an iterative procedure aimed at matching numerical predictions on the mooring tension, derived through time domain coupled analysis, with experimental results derived from tank tests of a small scale model. Due to the complex geometry of the device, a sensitivity analysis is performed to discuss the influence of the mean position on the quality of the numerical predictions. Good correspondence is achieved between the experimental and numerical model. The numerical model is hence considered reliable for future design applications.

scholarly journals WECANet: The First Open Pan-European Network for Marine Renewable Energy with a Focus on Wave Energy-COST Action CA17105

Water ◽  
2019 ◽  
Vol 11 (6) ◽  
pp. 1249 ◽  
Author(s):  
Vasiliki Stratigaki
Keyword(s):  
Renewable Energy ◽  
Wave Energy ◽  
Interdisciplinary Approach ◽  
Energy Sector ◽  
Wave Energy Converter ◽  
Energy Resources ◽  
European Network ◽  
Energy Converter ◽  
Cost Action ◽  
Marine Renewable Energy

Growing energy demand has increased interest in marine renewable energy resources (i.e., wave energy, which is harvested through wave energy converter (WEC) arrays. However, the wave energy industry is currently at a significant juncture in its development, facing a number of challenges which require that research re-focuses on a holistic techno-economic perspective, where the economics considers the full life cycle costs of the technology. It also requires development of WECs suitable for niche markets, because in Europe there are inequalities regarding wave energy resources, wave energy companies, national programs and investments. As a result, in Europe there are leading and non-leading countries in wave energy technology. The sector also needs to increase confidence of potential investors by reducing (non-)technological risks. This can be achieved through an interdisciplinary approach by involving engineers, economists, environmental scientists, lawyers, regulators and policy experts. Consequently, the wave energy sector needs to receive the necessary attention compared to other more advanced and commercial offshore energy technologies (e.g., offshore wind). The formation of the first open pan-European network with an interdisciplinary approach will contribute to large-scale WEC array deployment by dealing with the current bottlenecks. The WECANet (Wave Energy Converter Array Network) European COST Action, introduced in September 2018 and presented in this paper, aims at a collaborative and inclusive approach, as it provides a strong networking and collaboration platform that also creates the space for dialogue between all stakeholders in wave energy. An important characteristic of the Action is that participation is open to all parties interested and active in the development of wave energy. Previous activities organised by WECANet core group members have resulted in a number of joint European projects and scientific publications. WECANet’s main target is the equal research, training, networking, collaboration and funding opportunities for all researchers and professionals, regardless of age, gender and country in order to obtain understanding of the main challenges governing the development of the wave energy sector.

scholarly journals A Novel Hybrid Wind-Wave Energy Converter for Jacket-Frame Substructures

Energies ◽  
2018 ◽  
Vol 11 (3) ◽  
pp. 637 ◽  
Author(s):  
Carlos Perez-Collazo ◽  
Deborah Greaves ◽  
Gregorio Iglesias
Keyword(s):  
Wave Energy ◽  
Wind Wave ◽  
Wave Energy Converter ◽  
Energy Converter

Hydraulic investigations of a “tapered channel” model of a wind-wave energy converter

1995 ◽  
Vol 29 (9) ◽  
pp. 505-514
Author(s):  
V. V. Volshanik ◽  
A. L. Zuikov ◽  
T. K. D. Tennakoonge ◽  
B. E. Monakhov
Keyword(s):  
Wave Energy ◽  
Channel Model ◽  
Wind Wave ◽  
Wave Energy Converter ◽  
Energy Converter ◽  
Tapered Channel
Sign in / Sign up

Export Citation Format

Share Document