scholarly journals A New Recursive Filtering Method of Terrestrial Laser Scanning Data to Preserve Ground Surface Information in Steep-Slope Areas

2017 ◽  
Vol 6 (11) ◽  
pp. 359 ◽  
Author(s):  
Mi-Kyeong Kim ◽  
Sangpil Kim ◽  
Hong-Gyoo Sohn ◽  
Namhoon Kim ◽  
Je-Sung Park
Keyword(s):  
Laser Scanning ◽  
Ground Surface ◽  
Terrestrial Laser Scanning ◽  
Steep Slope ◽  
Recursive Filtering ◽  
Surface Information ◽  
Filtering Method

scholarly journals Deformation Monitoring of Earth Fissure Hazards Using Terrestrial Laser Scanning

Sensors ◽  
2019 ◽  
Vol 19 (6) ◽  
pp. 1463 ◽  
Author(s):  
Yunfeng Ge ◽  
Huiming Tang ◽  
Xulong Gong ◽  
Binbin Zhao ◽  
Yi Lu ◽  
...  
Keyword(s):  
Laser Scanning ◽  
Ground Surface ◽  
Terrestrial Laser Scanning ◽  
Point Clouds ◽  
Vertical Displacement ◽  
Deformation Monitoring ◽  
Earth Fissure ◽  
Displacement Analysis ◽  
Remote Sensing Technique ◽  
Noise Data

Deformation monitoring is a powerful tool to understand the formation mechanism of earth fissure hazards, enabling the engineering and planning efforts to be more effective. To assess the evolution characteristics of the Yangshuli earth fissure hazard more completely, terrestrial laser scanning (TLS), a remote sensing technique which is regarded as one of the most promising surveying technologies in geohazard monitoring, was employed to detect the changes to ground surfaces and buildings in small- and large-scales, respectively. Time-series of high-density point clouds were collected through 5 sequential scans from 2014 to 2017 and then pre-processing was performed to filter the noise data of point clouds. A tiny deformation was observed on both the scarp and the walls, based on the local displacement analysis. The relative height differences between the two sides of the scarp increase slowly from 0.169 m to 0.178 m, while no obvious inclining (the maximum tilt reaches just to 0.0023) happens on the two walls, based on tilt measurement. Meanwhile, global displacement analysis indicates that the overall settlement slowly increases for the ground surface, but the regions in the left side of scarp are characterized by a relatively larger vertical displacement than the right. Furthermore, the comparisons of monitoring results on the same measuring line are discussed in this study and TLS monitoring results have an acceptable consistency with the global positioning system (GPS) measurements. The case study shows that the TLS technique can provide an adequate solution in deformation monitoring of earth fissure hazards, with high effectiveness and applicability.

scholarly journals Terrestrial laser scanning for quantifying small-scale vertical movements of the ground surface in Artic permafrost regions

2017 ◽  
Author(s):  
Sabrina Marx ◽  
Katharina Anders ◽  
Sofia Antonova ◽  
Inga Beck ◽  
Julia Boike ◽  
...  
Keyword(s):  
Laser Scanning ◽  
Three Dimensional ◽  
Ground Surface ◽  
Terrestrial Laser Scanning ◽  
Spatial Sampling ◽  
Small Scale ◽  
Vertical Movements ◽  
North East ◽  
Multi Temporal ◽  
Permafrost Regions

Abstract. Three-dimensional data acquired by terrestrial laser scanning (TLS) provides an accurate representation of Earth's surface, which is commonly used to detect and quantify topographic changes on a small scale. However, in Arctic permafrost regions the tundra vegetation and the micro-topography have significant effects on the surface representation in the captured dataset. The resulting spatial sampling of the ground is never identical between two TLS surveys. Thus, monitoring of heave and subsidence in the context of permafrost processes are challenging. This study evaluates TLS for quantifying small-scale vertical movements in an area located within the continuous permafrost zone, 50 km north-east of Inuvik, Northwest Territories, Canada. We propose a novel filter strategy, which accounts for spatial sampling effects and identifies TLS points suitable for multi-temporal deformation analyses. Further important prerequisites must be met, such as accurate co-registration of the TLS datasets. We found that if the ground surface is captured by more than one TLS scan position, plausible subsidence rates (up to mm-scale) can be derived; compared to e.g. standard raster-based DEM difference maps which contain change rates strongly affected by sampling effects.

Comparison of terrestrial laser scanning and structure-from-motion photogrammetry for steep slope mapping

2018 ◽  
Author(s):  
Konstantinos G. Nikolakopoulos ◽  
Antonis Antonakakis ◽  
Aggeliki Kyriou ◽  
Ioannis K. Koukouvelas ◽  
Panagiotis Stefanopoulos
Keyword(s):  
Structure From Motion ◽  
Laser Scanning ◽  
Terrestrial Laser Scanning ◽  
Steep Slope

scholarly journals Melite Civitas Romana in 3D: Virtualization Project of the Archaeological Park and Museum of the Domus Romana of Rabat, Malta

2021 ◽  
Vol 7 (1) ◽  
pp. 51-83
Author(s):  
Davide Tanasi ◽  
Stephan Hassam ◽  
Kaitlyn Kingsland ◽  
Paolo Trapani ◽  
Matthew King ◽  
...  
Keyword(s):  
Laser Scanning ◽  
Structured Light ◽  
Terrestrial Laser Scanning ◽  
Archaeological Site ◽  
South Florida ◽  
Virtual Museum ◽  
Current State ◽  
Structured Light Scanning ◽  
The University ◽  
Archaeological Excavations

Abstract The archaeological site of the Domus Romana in Rabat, Malta was excavated almost 100 years ago yielding artefacts from the various phases of the site. The Melite Civitas Romana project was designed to investigate the domus, which may have been the home of a Roman Senator, and its many phases of use. Pending planned archaeological excavations designed to investigate the various phases of the site, a team from the Institute for Digital Exploration from the University of South Florida carried out a digitization campaign in the summer of 2019 using terrestrial laser scanning and aerial digital photogrammetry to document the current state of the site to provide a baseline of documentation and plan the coming excavations. In parallel, structured light scanning and photogrammetry were used to digitize 128 artefacts in the museum of the Domus Romana to aid in off-site research and create a virtual museum platform for global dissemination.

scholarly journals Terrestrial Laser Scanning for Vegetation Analyses with a Special Focus on Savannas

2021 ◽  
Vol 13 (3) ◽  
pp. 507
Author(s):  
Tasiyiwa Priscilla Muumbe ◽  
Jussi Baade ◽  
Jenia Singh ◽  
Christiane Schmullius ◽  
Christian Thau
Keyword(s):  
Remote Sensing ◽  
Vegetation Structure ◽  
Laser Scanning ◽  
Spatial Scales ◽  
Terrestrial Laser Scanning ◽  
Point Clouds ◽  
Parameter Extraction ◽  
Airborne Lidar ◽  
Special Focus ◽  
Vegetation Parameter

Savannas are heterogeneous ecosystems, composed of varied spatial combinations and proportions of woody and herbaceous vegetation. Most field-based inventory and remote sensing methods fail to account for the lower stratum vegetation (i.e., shrubs and grasses), and are thus underrepresenting the carbon storage potential of savanna ecosystems. For detailed analyses at the local scale, Terrestrial Laser Scanning (TLS) has proven to be a promising remote sensing technology over the past decade. Accordingly, several review articles already exist on the use of TLS for characterizing 3D vegetation structure. However, a gap exists on the spatial concentrations of TLS studies according to biome for accurate vegetation structure estimation. A comprehensive review was conducted through a meta-analysis of 113 relevant research articles using 18 attributes. The review covered a range of aspects, including the global distribution of TLS studies, parameters retrieved from TLS point clouds and retrieval methods. The review also examined the relationship between the TLS retrieval method and the overall accuracy in parameter extraction. To date, TLS has mainly been used to characterize vegetation in temperate, boreal/taiga and tropical forests, with only little emphasis on savannas. TLS studies in the savanna focused on the extraction of very few vegetation parameters (e.g., DBH and height) and did not consider the shrub contribution to the overall Above Ground Biomass (AGB). Future work should therefore focus on developing new and adjusting existing algorithms for vegetation parameter extraction in the savanna biome, improving predictive AGB models through 3D reconstructions of savanna trees and shrubs as well as quantifying AGB change through the application of multi-temporal TLS. The integration of data from various sources and platforms e.g., TLS with airborne LiDAR is recommended for improved vegetation parameter extraction (including AGB) at larger spatial scales. The review highlights the huge potential of TLS for accurate savanna vegetation extraction by discussing TLS opportunities, challenges and potential future research in the savanna biome.

Sign in / Sign up

Export Citation Format

Share Document