Comparison of terrestrial laser scanning and structure-from-motion photogrammetry for steep slope mapping

2018 ◽  
Author(s):  
Konstantinos G. Nikolakopoulos ◽  
Antonis Antonakakis ◽  
Aggeliki Kyriou ◽  
Ioannis K. Koukouvelas ◽  
Panagiotis Stefanopoulos
Keyword(s):  
Structure From Motion ◽  
Laser Scanning ◽  
Terrestrial Laser Scanning ◽  
Steep Slope

Terrestrial laser scanning and structure-from-motion photogrammetry concordance analysis for describing the surface layer of gravel beds

2019 ◽  
Vol 43 (2) ◽  
pp. 260-281 ◽  
Author(s):  
Andrew J Neverman ◽  
Ian C Fuller ◽  
Jon N Procter ◽  
Russell G Death
Keyword(s):  
Surface Layer ◽  
Structure From Motion ◽  
Laser Scanning ◽  
Terrestrial Laser Scanning ◽  
Point Clouds ◽  
Survey Method ◽  
Gravel Beds ◽  
Non Invasive ◽  
Sampling Biases

Terrestrial laser scanning (TLS) and structure-from-motion photogrammetry (SfMp) offer rapid, non-invasive surveying of in situ gravels. Numerous studies have used the point clouds derived from TLS or SfMp to quantify surface layer characteristics, but direct comparison of the methods for grain-scale analysis has received relatively little attention to date. Comparing equivalent products of different data capture methods is critical as differences in errors and sampling biases between the two methods may produce different outputs, effecting further analysis. The sampling biases and errors related to SfMp and TLS lead to differences in the point clouds produced by each method. The metrics derived from the point clouds are therefore likely to differ, potentially leading to different inputs for entrainment threshold models, different trends in surface layer development being identified and different trajectories for physical processes and habitat quality being predicted. This paper provides a direct comparison between TLS and SfMp surveys of an exposed gravel bar for three different survey periods following inundation and reworking of the bar surface during high flow events. The point clouds derived from the two methods are used to describe changes in the character of the surface layer between bar inundation events, and comparisons are made with descriptions derived from conventional pebble counts. The results found differences in the metrics derived using each method do exist, but the grid resolution used to detrend the surfaces and identify spatial variations in surface layer characteristics had a greater impact than survey method. Further research is required to understand the significance of these variations for quantifying surface texture and structure and for predicting entrainment thresholds and transport rates.

scholarly journals A comparison of terrestrial laser scanning and structure-from-motion photogrammetry as methods for digital outcrop acquisition

Geosphere ◽  
2016 ◽  
Vol 12 (6) ◽  
pp. 1865-1880 ◽  
Author(s):  
M.W. Wilkinson ◽  
R.R. Jones ◽  
C.E. Woods ◽  
S.R. Gilment ◽  
K.J.W. McCaffrey ◽  
...  
Keyword(s):  
Structure From Motion ◽  
Laser Scanning ◽  
Terrestrial Laser Scanning ◽  
Digital Outcrop

scholarly journals Structure from motion (SfM) processing of UAV images and combination with terrestrial laser scanning, applied for a 3D-documentation in a hazardous situation

2017 ◽  
Vol 8 (2) ◽  
pp. 1492-1504 ◽  
Author(s):  
Isabel Martínez-Espejo Zaragoza ◽  
Gabriella Caroti ◽  
Andrea Piemonte ◽  
Björn Riedel ◽  
Dieter Tengen ◽  
...  
Keyword(s):  
Structure From Motion ◽  
Laser Scanning ◽  
Terrestrial Laser Scanning ◽  
3D Documentation ◽  
Uav Images

scholarly journals Estimating Mangrove Forest Volume Using Terrestrial Laser Scanning and UAV-Derived Structure-from-Motion

Drones ◽  
2019 ◽  
Vol 3 (2) ◽  
pp. 32 ◽  
Author(s):  
Angus D. Warfield ◽  
Javier X. Leon
Keyword(s):  
Structure From Motion ◽  
Forest Structure ◽  
Mangrove Forest ◽  
Laser Scanning ◽  
Terrestrial Laser Scanning ◽  
Cost Effective ◽  
Stand Age ◽  
Stem Density ◽  
Aerial Vehicle ◽  
Non Destructive

Mangroves provide a variety of ecosystem services, which can be related to their structuralcomplexity and ability to store carbon in the above ground biomass (AGB). Quantifying AGB inmangroves has traditionally been conducted using destructive, time-consuming, and costlymethods, however, Structure-from-Motion Multi-View Stereo (SfM-MVS) combined withunmanned aerial vehicle (UAV) imagery may provide an alternative. Here, we compared the abilityof SfM-MVS with terrestrial laser scanning (TLS) to capture forest structure and volume in threemangrove sites of differing stand age and species composition. We describe forest structure in termsof point density, while forest volume is estimated as a proxy for AGB using the surface differencingmethod. In general, SfM-MVS poorly captured mangrove forest structure, but was efficient incapturing the canopy height for volume estimations. The differences in volume estimations betweenTLS and SfM-MVS were higher in the juvenile age site (42.95%) than the mixed (28.23%) or mature(12.72%) age sites, with a higher stem density affecting point capture in both methods. These resultscan be used to inform non-destructive, cost-effective, and timely assessments of forest structure orAGB in mangroves in the future.

Quantifying 40 years of rockfall activity in Yosemite Valley with historical Structure-from-Motion photogrammetry and terrestrial laser scanning

Geomorphology ◽  
2020 ◽  
Vol 356 ◽  
pp. 107069 ◽  
Author(s):  
Antoine Guerin ◽  
Greg M. Stock ◽  
Mariah J. Radue ◽  
Michel Jaboyedoff ◽  
Brian D. Collins ◽  
...  
Keyword(s):  
Structure From Motion ◽  
Laser Scanning ◽  
Terrestrial Laser Scanning ◽  
Yosemite Valley

scholarly journals Techniki rejestracji zdalnej w kartowaniu geomorfologicznym wybrzeży klifowych

2019 ◽  
Vol 38 ◽  
pp. 35-46
Author(s):  
Marcin Winowski
Keyword(s):  
Structure From Motion ◽  
Laser Scanning ◽  
Optimal Solution ◽  
Terrestrial Laser Scanning ◽  
Point Clouds ◽  
Digital Processing ◽  
Geomorphological Mapping ◽  
Airborne Laser ◽  
Basic Parameters ◽  
Remote Sensing Methods

This paper presents the evaluation of three remote sensing methods used in geomorphological mapping of cliff coasts. The basic parameters of point clouds obtained in the process of airborne laser scanning (ALS), terrestrial laser scanning (TLS) and digital processing of photos obtained with UAV (Structure from Motion – UAV-SfM) were analysed. The obtained results allowed to state that the models with the highest resolution and accuracy can be obtained using the TLS and UAV-SfM methods. These two techniques provide the greatest possibilities in detailed relief analyses and estimation of the sediment budget in small research sites. Images of ALS are less accurate, but for studies carried out in larger areas they seem to be the most optimal solution.

Sign in / Sign up

Export Citation Format

Share Document