scholarly journals Dynamic Analysis of the Switched-Inductor Buck-Boost Converter Based on the Memristor

Electronics ◽  
2021 ◽  
Vol 10 (4) ◽  
pp. 452
Author(s):  
Yan Yang ◽  
Dongdong Li ◽  
Dongqing Wang
Keyword(s):  
Current Mode ◽  
State Equation ◽  
Equation Model ◽  
Phase Portraits ◽  
Nonlinear Phenomena ◽  
Matlab Simulation ◽  
Power Simulation ◽  
Simulation Based ◽  
Continuous Current ◽  
Continuous Current Mode

The direct current (DC)–DC converter presents abundant nonlinear phenomena, such as periodic bifurcation and chaotic motion, under certain conditions. For a switched-inductor buck-boost (SIBB) converter with the memristive load, this paper constructs its state equation model under two operating statuses, investigates its chaotic dynamic characteristics, and draws and analyzes the bifurcation diagrams of the inductive current and phase portraits, under some parameter changing by the MATLAB simulation based on the state equation. Then, by applying certain minor perturbations to parameters, the chaotic phenomenon suppression method is explored by controlling peak current in continuous current mode (CCM) to keep the converter run normally. Finally, the power simulation (PSIM) verifies that the waveforms and the phase portraits controlling the corresponding parameters are consistent with those of the MATLAB simulation.

scholarly journals Nonlinear Analysis of CCM Superbuck Converter Using Wigner-Ville Distribution

2020 ◽  
Vol 19 ◽  
Keyword(s):  
Output Voltage ◽  
Current Mode ◽  
Nonlinear Phenomena ◽  
Energy Component ◽  
Bifurcation And Chaos ◽  
Time Frequency ◽  
Period 2 ◽  
Continuous Current ◽  
Continuous Current Mode ◽  
Frequency Diagram

In order to analyze the bifurcation and chaos of Superbuck converter in Continuous Current Mode (CCM), a new method of time-frequency diagram based on Wigner-Ville distribution is proposed. The method is used to analyze the variation of the energy component of the output voltage with frequency and time. It reveals that the Superbuck converter exhibits period-1 bifurcation, period-2 bifurcation, period-4 bifurcation and chaos under different reference current. The results of the time-frequency diagram are consistent with the results of the bifurcation diagram, time-domain diagram, phase diagram and Poincare section. It proves that the method can deeply understand the nature of bifurcation and chaos in Superbuck converter, and it provides a new way to analyze the nonlinear phenomena of DC-DC converter

scholarly journals Low Power Photo-Voltaic Harvesting Matrix Based Boost DC–DC Converter with Recycled and Synchro-Recycled Scheme

2020 ◽  
Vol 10 (4) ◽  
pp. 39
Author(s):  
Maziar Rastmanesh ◽  
Ezz El-Masry ◽  
Kamal El-Sankary
Keyword(s):  
Low Power ◽  
Output Voltage ◽  
Current Mode ◽  
Boost Converter ◽  
Boost Converters ◽  
Continuous Current ◽  
Photo Voltaic ◽  
Continuous Current Mode ◽  
Conversion Efficiencies ◽  
Voltage Conversion

Photo-voltaic (PV) power harvest can have decent efficiency when dealing with high power. When operating with a DC–DC boost converter during the low-power harvest, its efficiency and output voltage are degraded due to excessive losses in the converter components. The objective of this paper is to present a systematic approach to designing an efficient low-power photo-voltaic harvesting topology with an improved efficiency and output voltage. The proposed topology uses a boost converter with and extra inductor in recycled and synchro-recycled techniques in continuous current mode (CCM). By exploiting the non-linearity of the PV cell, it reduces the power loss and using the current stored in the second inductor, it enhances the output voltage and output power simultaneously. Further, by utilizing the Metal Oxide Silicon Field Effect Transistor’s (MOSFET) body diode as a switch, it maintains a minimum hardware, and introduces a negligible impact on the reliability. The test results of the proposed boost converters show that it achieves a decent power and output voltage. Theoretical and experimental results of the proposed topologies with a tested prototype are presented along with a strategy to maximize power and voltage conversion efficiencies and output voltage.

Multimode step‐up bidirectional series resonant DC/DC converter using continuous current mode

2016 ◽  
Vol 9 (4) ◽  
pp. 710-718 ◽  
Author(s):  
Federico Martin Ibanez ◽  
Jose Martin Echeverria ◽  
Daniel Astigarraga ◽  
Luis Fontan
Keyword(s):  
Current Mode ◽  
Series Resonant ◽  
Continuous Current ◽  
Continuous Current Mode

scholarly journals An Active Direct Cell-to-Cell Balancing Circuit in Continuous Current Mode for Series Connected Batteries

Energies ◽  
2019 ◽  
Vol 12 (20) ◽  
pp. 3978 ◽  
Author(s):  
Han ◽  
Yang ◽  
Liu ◽  
Yang
Keyword(s):  
Circuit Complexity ◽  
Lithium Ion ◽  
Current Mode ◽  
In Series ◽  
Continuous Current ◽  
Direct Cell ◽  
One Step ◽  
Continuous Current Mode ◽  
Low Complex ◽  
Cell Balancing

Bi-directional cell-to-cell balancing circuits can well prevent voltage imbalance of batteries that are connected in series. However, it is a challenge to achieve high equalization speed and equalization efficiency with low complex circuit structure. In order to overcome this challenge, it is proposed that a direct bi-directional cell-to-cell active equalization method that works in continuous current mode (CCM) is used. The proposed balancing circuit allows energy to transfer directly from the source cell to the target cell in one step, which guarantees high balancing speed and efficiency. The experiments in which six-20 Ah lithium-ion batteries are connected in series have been carried out, and the results show that the balancing circuit achieves a good comprehensive performance of equalization in efficiency, speed, and circuit complexity.

Sign in / Sign up

Export Citation Format

Share Document