scholarly journals Estimation of Ferroelectric Material Properties and Phase-Shifter Design Key Parameters Influence on Its Figure of Merit for Optimization of Development Process

Crystals ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 538
Author(s):  
Alexander Gagarin ◽  
Roman Platonov ◽  
Tatiana Legkova ◽  
Andrey Altynnikov
Keyword(s):  
Material Properties ◽  
Figure Of Merit ◽  
Development Process ◽  
Phase Shifter ◽  
Ferroelectric Phase ◽  
Ferroelectric Material ◽  
Design Parameters ◽  
Band Pass Filter ◽  
Pass Filter ◽  
Band Pass

A model of the estimation of the ferroelectric-based phase-shifter figure of merit concerning the material properties and phase-shifter design parameters is presented. The influence of ferroelectric material tunability and losses on phase-shifter characteristics are analyzed. Two approaches to phase-shifter design (transmission line and band-pass filter) are considered. The review of the published results on the ferroelectric phase-shifter design was performed to approve the method proposed. Recommendations to optimize the phase-shifter development process are suggested on the basis of the elaborated model and analysis performed.

scholarly journals Some Useful Design Parameters of Non-Uniform Integrated Band-Pass Filters

1983 ◽  
Vol 11 (1) ◽  
pp. 65-70
Author(s):  
H. R. Singh
Keyword(s):  
Thin Film ◽  
Performance Characteristics ◽  
Design Parameters ◽  
Distributed Parameter ◽  
Band Pass Filter ◽  
Pass Filter ◽  
Band Pass ◽  
Relationship Of ◽  
Important Design ◽  
Terminal Band

Important design parameters for a two-port three-terminal band-pass filter configuration of the integrated thin-film exponential distributed parameter R–C–KR microstructure are presented. The circuit exhibits load independent characteristics. The changes in the value of design parameters under varying loading conditions are given. Various plots illustrating the inter-relationship of the different parameters with each other that can serve as guidelines for a system designer to obtain a pre-assigned pattern of the performance characteristics of the microstructure are included.

scholarly journals DEVELOPMENT OF A REPEATER FOR A DEVICE FOR MONITORING CHANGES IN THE COMPOSITION OF THE AIR ENVIRONMENT

2021 ◽  
pp. 71-82
Author(s):  
I.B. Shirokov ◽  
◽  
P.A. Evdokimov ◽  
E.I. Shirokova ◽  
◽  
...  
Keyword(s):  
Phase Shifter ◽  
Experimental Studies ◽  
Band Pass Filter ◽  
Pass Filter ◽  
Measuring Device ◽  
Electronic Part ◽  
Microwave Amplifiers ◽  
Band Pass

This work is part of a project to create a device for monitoring changes in the composition of the air environment. The article describes the main elements of the repeater unit included in the measuring device. The results of modeling the developed band-pass filter, which is part of the waveguide path of the repeater, are presented. Experimental studies of the filter and circulator parameters are also carried out. The technical capabilities of the electronic part of the repeater unit, namely microwave amplifiers and a controlled phase shifter, are described.

scholarly journals Microwave Magnetoelectric Devices

2012 ◽  
Vol 2012 ◽  
pp. 1-10 ◽  
Author(s):  
A. S. Tatarenko ◽  
M. I. Bichurin
Keyword(s):  
Phase Shift ◽  
Phase Shifter ◽  
Tuning Range ◽  
Frequency Region ◽  
Band Pass Filter ◽  
Maximum Phase ◽  
Pass Filter ◽  
Band Pass ◽  
Insertion Losses ◽  
Theory And Experiment

Tunable microwave magnetoelectric devices based on layered ferrite-ferroelectric structures are described. The theory and experiment for attenuator, band-pass filter and phase shifter are presented. Tunability of the ME devices characteristics can be executed by application of an electric field. This electric tuning is relatively fast and is not power-consuming. The attenuator insertion losses vary from 26 dB to 2 dB at frequency 7251 MHz. The tuning range of 25 MHz of band-pass filter at frequency 7360 MHz was obtained. A maximum phase shift of 30–40 degree at the frequency region 6–9 GHz was obtained.

OBSERVATION AND SIMULATION OF TSUNAMIS INDUCED BY THE 2003 TOKACHI-OKI EARTHQUAKE (M 8.0)

2015 ◽  
Vol 2 (3) ◽  
Author(s):  
Tatsuo Ohmachi ◽  
Shusaku Inoue ◽  
Tetsuji Imai
Keyword(s):  
Rayleigh Wave ◽  
Water Pressure ◽  
Near Field ◽  
Source Region ◽  
Tsunami Source ◽  
Band Pass Filter ◽  
Pass Filter ◽  
Tsunami Simulation ◽  
Sea Bed ◽  
Band Pass

The 2003 Tokachi-oki earthquake (MJ 8.0) occurred off the southeastern coast of Tokachi, Japan, and generated a large tsunami which arrived at Tokachi Harbor at 04:56 with a wave height of 4.3 m. Japan Marine Science and Technology Center (JAMSTEC) recovered records of water pressure and sea-bed acceleration at the bottom of the tsunami source region. These records are first introduced with some findings from Fourier analysis and band-pass filter analysis. Water pressure disturbance lasted for over 30 minutes and the duration was longer than those of accelerations. Predominant periods of the pressure looked like those excited by Rayleigh waves. Next, numerical simulation was conducted using the dynamic tsunami simulation technique able to represent generation and propagation of Rayleigh wave and tsunami, with a satisfactory result showing validity and usefulness of this technique. Keywords: Earthquake, Rayleigh wave, tsunami, near-field

A comparative study on the demodulation capability of a single loop optoelectronic oscillator with and without a dynamic band Pass filter

Optik ◽  
2021 ◽  
Vol 226 ◽  
pp. 165924
Author(s):  
Shantanu Mandal ◽  
Kousik Bishayee ◽  
Arindum Mukherjee ◽  
B N Biswas ◽  
Chandan Kumar Sarkar
Keyword(s):  
Comparative Study ◽  
Band Pass Filter ◽  
Optoelectronic Oscillator ◽  
Pass Filter ◽  
Single Loop ◽  
Band Pass
Sign in / Sign up

Export Citation Format

Share Document