scholarly journals Fermentation Characteristics and In Vitro Digestibility of Fibers and Fiber-Rich Byproducts Used for the Feeding of Pigs

Animals ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 341
Author(s):  
Martin Bachmann ◽  
Sebastian Michel ◽  
Jörg Michael Greef ◽  
Annette Zeyner

Dietary fibers may have positive impact on health and wellbeing of pigs. The study examined physicochemical properties of two lignocelluloses (including and excluding bark), powdered cellulose, Aspergillus niger mycelium, lucerne chaff, soybean shells, wheat bran, and sugar beet pulp in relation to fermentability and digestibility using in vitro batch-culture incubation. Maize starch and a purified cellulose were used as standardized substrates for classification of the test substrates. The substrates covered a wide range regarding their physicochemical properties. Swelling capacity (SC) was 9–411%, water binding capacity (WBC) was 4.4–14.3 g/g dry matter (DM), and water holding capacity (WHC) was 4.1–10.6 g/g DM. Gas production and other fermentation parameters—namely post-incubation pH, CH4, NH3, and short chain fatty acids (SCFA) concentrations—revealed a significant fermentation of sugar beet pulp, soybean shells, lucerne chaff, wheat bran, A. niger mycelium, and powdered cellulose, whereas the lignocelluloses were not fermented. Significant correlations were found between the physicochemical properties and the fermentation parameters (p < 0.05). Enzymatic pre-digestion mostly reduced gas, NH3, and SCFA production. In vitro digestibility of DM (IVDMD) and organic matter (IVOMD) was mostly negligible after enzymatic pre-digestion. Fermentation alone led to only 0.10–0.15 IVDMD and 0.14–0.15 IVOMD in lignocelluloses and powdered cellulose, respectively, but 0.44–0.37 IVDMD and 0.46–0.38 IVOMD in the remainder of substrates (p < 0.05). In vitro digestibility was again correlated with the physicochemical properties of the substrates and the fermentation parameters (p < 0.05). The fiber preparations and fiber-rich byproducts were fermented to a relevant extent. In contrast, lignocelluloses were not fermented and can be used rather as bulk material.

2004 ◽  
Vol 32 ◽  
pp. 211-213
Author(s):  
R Wheeler

Previous work has shown that an increase in readily fermentable carbohydrates (CHO) in the diet of pigs is reflected by a decrease in faecal pH (Canh et al., 1998). It is well documented that a similar increase in CHO in the diet of equids is reflected by a decrease in caecal pH (McLean et al., 2000). Little work has been undertaken to determine if such a relationship exists in equids or indeed if there is a correlation between dietary pH and faecal pH.The feed pH and faecal pH of six groups, each of 8 horses, receiving a variety of diets were examined. The dietary groups covered a wide range of feeds from purely forage based to predominantly concentrate based. Diet 1 consisted of 100% Hay (Hy), diet 2 of 100% grass (Gr), diet 3 of a 70:30 mix of Haylage (Hg) and grass (Gr): stud nuts, diet 4 of a 50:50 mix of haylage and competition mix, diet 5 a 30:70 mix of haylage to race mix and diet 6 a 60:40 mix of haylage, alfalfa and sugar beet pulp: rolled oats.


2007 ◽  
Vol 132 (3-4) ◽  
pp. 212-226 ◽  
Author(s):  
Jérôme Bindelle ◽  
André Buldgen ◽  
Damien Lambotte ◽  
José Wavreille ◽  
Pascal Leterme

Author(s):  
John Ward ◽  
Muhammad Akram ◽  
Roy Garwood

It can be difficult to burn relatively cheap, poor quality, unprepared biomass materials in industrial heating processes because of their variable composition, relatively low calorific values and high moisture contents. Consequently the stability and efficiency of the combustion process can be adversely affected unless they are co-fired with a hydrocarbon support fuel. There is a lack of information on the “optimum” conditions for co-firing of coal and high moisture biomass as well as on the proportions of support fuel which should be used. This paper is therefore concerned with the pilot scale (<25 kW thermal input) fluidised bed combustion of blends of coal with pressed sugar beet pulp, a solid biomass with an average moisture content of 71%. The experimental work was undertaken in collaboration with British Sugar plc who operate a coal-fired 40 MW thermal capacity fluidised bed producing hot combustion gases for subsequent drying applications. The project studied the combustion characteristics of different coal and pressed pulp blends over a wide range of operating conditions. It was found that stable combustion could only be maintained if the proportion of pulp by mass in the blended fuel was no greater than 50%. However evaporation of the moisture in the pressed pulp cools the bed so that the excess air which is necessary to maintain a specified bed temperature at a fixed thermal input can be reduced as the proportion of biomass in the blended fuel is increased. Therefore, with a 50/50 blend the bed can be operated with 20% less fluidising air and this will be beneficial for the output of the full scale plant since at present the flow rate of the air and hence the amount of coal which can be burnt is restricted by supply system pressure drop limitations. A further benefit of co-firing pressed pulp is that NOx emissions are reduced by about 25%. Agglomeration of the bed can be a problem when co-firing biomass because of the formation of “sticky” low melting point alkali metal silicate eutectics which result in subsequent adhesion of the ash and sand particles. Consequently longer term co-firing tests with a 50/50 blended fuel by mass were undertaken. Problems of bed agglomeration were not observed under these conditions with relatively low levels of alkali metals in the ash.


Sign in / Sign up

Export Citation Format

Share Document