scholarly journals Multidimensionality of Chemical Information in Male Greater Sac-Winged Bats (Saccopteryx bilineata)

2016 ◽  
Vol 4 ◽  
Author(s):  
Karin Schneeberger ◽  
Christian C. Voigt ◽  
Caroline Müller ◽  
Barbara A. Caspers
Keyword(s):  
Chemical Information ◽  
Saccopteryx Bilineata

Macroprobe Mode for the Study of Segregation in Steels

1990 ◽  
Vol 48 (2) ◽  
pp. 260-261
Author(s):  
Auclair Gilles ◽  
Benoit Danièle
Keyword(s):  
Mechanical Properties ◽  
Spatial Distribution ◽  
High Performance ◽  
Volume Fraction ◽  
Sheet Steel ◽  
Acquisition Time ◽  
Chemical Information ◽  
X Ray ◽  
Accurate Quantitative Analysis ◽  
Optical Micrographs

During these last 10 years, high performance correction procedures have been developed for classical EPMA, and it is nowadays possible to obtain accurate quantitative analysis even for soft X-ray radiations. It is also possible to perform EPMA by adapting this accurate quantitative procedures to unusual applications such as the measurement of the segregation on wide areas in as-cast and sheet steel products.The main objection for analysis of segregation in steel by means of a line-scan mode is that it requires a very heavy sampling plan to make sure that the most significant points are analyzed. Moreover only local chemical information is obtained whereas mechanical properties are also dependant on the volume fraction and the spatial distribution of highly segregated zones. For these reasons we have chosen to systematically acquire X-ray calibrated mappings which give pictures similar to optical micrographs. Although mapping requires lengthy acquisition time there is a corresponding increase in the information given by image anlysis.

High Resolution Electron Microscopy of internal interfaces in layered materials

1990 ◽  
Vol 48 (4) ◽  
pp. 320-321
Author(s):  
Yoichi Ishida ◽  
Hideki Ichinose ◽  
Yutaka Takahashi ◽  
Jin-yeh Wang
Keyword(s):  
Grain Boundaries ◽  
Mirror Symmetry ◽  
Functional Materials ◽  
High Resolution Electron Microscopy ◽  
Layered Materials ◽  
Plane Boundary ◽  
Chemical Information ◽  
Layer Plane ◽  
High Tc ◽  
Cubic Metals

Layered materials draw attention in recent years in response to the world-wide drive to discover new functional materials. High-Tc superconducting oxide is one example. Internal interfaces in such layered materials differ significantly from those of cubic metals. They are often parallel to the layer of the neighboring crystals in sintered samples(layer plane boundary), while periodically ordered interfaces with the two neighboring crystals in mirror symmetry to each other are relatively rare. Consequently, the atomistic features of the interface differ significantly from those of cubic metals. In this paper grain boundaries in sintered high-Tc superconducting oxides, joined interfaces between engineering ceramics with metals, and polytype interfaces in vapor-deposited bicrystal are examined to collect atomic information of the interfaces in layered materials. The analysis proved that they are not neccessarily more complicated than that of simple grain boundaries in cubic metals. The interfaces are majorly layer plane type which is parallel to the compound layer. Secondly, chemical information is often available, which helps the interpretation of the interface atomic structure.

X-ray microprobe for materials science

1994 ◽  
Vol 52 ◽  
pp. 56-57
Author(s):  
G.E. Ice
Keyword(s):  
Crystallographic Orientation ◽  
Local Structure ◽  
Materials Science ◽  
Chemical Information ◽  
X Ray Diffraction ◽  
Ray Optics ◽  
X Ray ◽  
Novel Materials ◽  
New Information ◽  
Elemental Sensitivity

The increasing availability of synchrotron x-ray sources has stimulated the development of advanced hard x-ray (E≥5 keV) microprobes. With new x-ray optics these microprobes can achieve micron and submicron spatial resolutions. The inherent elemental and crystallographic sensitivity of an x-ray microprobe and its inherently nondestructive and penetrating nature will have important applications to materials science. For example, x-ray fluorescent microanalysis of materials can reveal elemental distributions with greater sensitivity than alternative nondestructive probes. In materials, segregation and nonuniform distributions are the rule rather than the exception. Common interfaces to whichsegregation occurs are surfaces, grain and precipitate boundaries, dislocations, and surfaces formed by defects such as vacancy and interstitial configurations. In addition to chemical information, an x-ray diffraction microprobe can reveal the local structure of a material by detecting its phase, crystallographic orientation and strain.Demonstration experiments have already exploited the penetrating nature of an x-ray microprobe and its inherent elemental sensitivity to provide new information about elemental distributions in novel materials.

The Possibilities for Analytical Methods in Photoemission and Low-Energy Electron Microscopy

1990 ◽  
Vol 48 (1) ◽  
pp. 348-349
Author(s):  
Ernst Bauer
Keyword(s):  
Chemical Characterization ◽  
Emission Angle ◽  
Relative Energy ◽  
Objective Lens ◽  
Chemical Information ◽  
Magnetic Lens ◽  
Incident Intensity ◽  
X Ray ◽  
Leed Pattern ◽  
Image Position

One of the major shortcomings of conventional PEEM and of LEEM is the lack of chemical information about the surface. Although the imaging of the LEED pattern in the back focal plane of the objective lens of a LEEM instrument allows chemical characterization via the crystalline structure derived from the LEED pattern, this method fails in the absence of a characteristic LEED pattern. Direct information about the atomic composition of the surface is then needed which can be best obtained from inner shell electrons either directly by x-ray-induced photoemission (XPEEM) or by x-ray- or electron-induced Auger electron emission (AEEM). These modes of excitation and imaging can be combined with conventional PEEM and LEEM in one instrument which is presently being developed. Thus a complete structural and chemical characterization becomes possible in one instrument, with parallel detection and high resolution.In contrast to LEEM, in which up to more than 50% of the incident intensity is available for image formation, the intensity of the emitted electrons is much lower in XPEEM and AEEM and the signal is much lower than the background in AEEM. Therefore, intensity I and resolution d have to be optimized simultaneously which is best done by maximizing Q = I/d2 with respect to maximum emission angle α and relative energy distribution ε = ΔVo/V accepted by the instrument. For a well-designed magnetic lens section of the cathode lens its aberrations are determined by the accelerating field F in front of the specimen. For a homogeneous accelerating field F and a cosine emission distribution one obtains for the optimum α and ε values αo,εo a radius of the minimum disc of confusion of

The impact of traditional plants and their secondary metabolites in the discovery of COVID-19 treatment

2020 ◽  
Vol 26 ◽  
Author(s):  
Shabana Bibi ◽  
Ayesha Sarfraz ◽  
Ghazala Mustafa ◽  
Zeeshan Ahmed ◽  
Muhammad Aurang Zeb ◽  
...  
Keyword(s):  
Secondary Metabolites ◽  
Test System ◽  
Chemical Information ◽  
System Type ◽  
The Family ◽  
Comprehensive Search ◽  
Coronavirus Infection ◽  
The Impact ◽  
First Time ◽  
Plant Sources

Background: Coronavirus Disease-2019 belongs to the family of viruses which cause a serious pneumonia along with fever, breathing issues and infection of lungs for the first time in China and later spread worldwide. Objective: Several studies and clinical trials have been conducted to identify potential drugs and vaccines for Coronavirus Disease-2019. The present study listed natural secondary metabolites identified from plant sources with antiviral properties and could be safer and tolerable treatment for Coronavirus Disease-2019. Methods: A comprehensive search on the reported studies was conducted using different search engine such as Google scholar, SciFinder, Sciencedirect, Medline PubMed, and Scopus for the collection of research articles based on plantderived secondary metabolites, herbal extracts, and traditional medicine for coronavirus infections. Results: Status of COVID-19 worldwide and information of important molecular targets involved in COVID-19 is described and through literature search, is highlighted that numerous plant species and their extracts possess antiviral properties and studied with respect to Coronavirus treatments. Chemical information, plant source, test system type with mechanism of action for each secondary metabolite is also mentioned in this review paper. Conclusion: The present review has listed plants that have presented antiviral potential in the previous coronavirus pandemics and their secondary metabolites which could be significant for the development of novel and a safer drug which could prevent and cure coronavirus infection worldwide.

scholarly journals Potential of spectroscopic analyses for non-destructive estimation of tea quality-related metabolites in fresh new leaves

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Hiroto Yamashita ◽  
Rei Sonobe ◽  
Yuhei Hirono ◽  
Akio Morita ◽  
Takashi Ikka
Keyword(s):  
Short Wave ◽  
Machine Learning Algorithms ◽  
Estimation Methods ◽  
Chemical Information ◽  
Tea Quality ◽  
The Mean ◽  
Processing Techniques ◽  
Spectral Patterns ◽  
Physical And Chemical ◽  
Non Destructive

AbstractSpectroscopic sensing provides physical and chemical information in a non-destructive and rapid manner. To develop non-destructive estimation methods of tea quality-related metabolites in fresh leaves, we estimated the contents of free amino acids, catechins, and caffeine in fresh tea leaves using visible to short-wave infrared hyperspectral reflectance data and machine learning algorithms. We acquired these data from approximately 200 new leaves with various status and then constructed the regression model in the combination of six spectral patterns with pre-processing and five algorithms. In most phenotypes, the combination of de-trending pre-processing and Cubist algorithms was robustly selected as the best combination in each round over 100 repetitions that were evaluated based on the ratio of performance to deviation (RPD) values. The mean RPD values were ranged from 1.1 to 2.7 and most of them were above the acceptable or accurate threshold (RPD = 1.4 or 2.0, respectively). Data-based sensitivity analysis identified the important hyperspectral regions around 1500 and 2000 nm. Present spectroscopic approaches indicate that most tea quality-related metabolites can be estimated non-destructively, and pre-processing techniques help to improve its accuracy.

Sign in / Sign up

Export Citation Format

Share Document