scholarly journals Relationship between larval settlement, alongshore wind stress and surface temperature in a numerical model of the central California coastal circulation

2015 ◽  
Vol 537 ◽  
pp. 71-87 ◽  
Author(s):  
PT Drake ◽  
CA Edwards ◽  
SG Morgan
Keyword(s):  
Numerical Model ◽  
Surface Temperature ◽  
Wind Stress ◽  
Larval Settlement ◽  
Coastal Circulation ◽  
Central California ◽  
Alongshore Wind Stress ◽  
Alongshore Wind

scholarly journals Seasonal variability of the Ekman transport and pumping in the upwelling system off central-northern Chile (∼  30° S) based on a high-resolution atmospheric regional model (WRF)

Ocean Science ◽  
2016 ◽  
Vol 12 (5) ◽  
pp. 1049-1065 ◽  
Author(s):  
Luis Bravo ◽  
Marcel Ramos ◽  
Orlando Astudillo ◽  
Boris Dewitte ◽  
Katerina Goubanova
Keyword(s):  
High Resolution ◽  
Wind Stress ◽  
Seasonal Variability ◽  
Coastal Upwelling ◽  
Ekman Transport ◽  
Northern Chile ◽  
Ekman Pumping ◽  
Relative Contribution ◽  
Alongshore Wind Stress ◽  
Alongshore Wind

Abstract. Two physical mechanisms can contribute to coastal upwelling in eastern boundary current systems: offshore Ekman transport due to the predominant alongshore wind stress and Ekman pumping due to the cyclonic wind stress curl, mainly caused by the abrupt decrease in wind stress (drop-off) in a cross-shore band of 100 km. This wind drop-off is thought to be an ubiquitous feature in coastal upwelling systems and to regulate the relative contribution of both mechanisms. It has been poorly studied along the central-northern Chile region because of the lack in wind measurements along the shoreline and of the relatively low resolution of the available atmospheric reanalysis. Here, the seasonal variability in Ekman transport, Ekman pumping and their relative contribution to total upwelling along the central-northern Chile region (∼  30° S) is evaluated from a high-resolution atmospheric model simulation. As a first step, the simulation is validated from satellite observations, which indicates a realistic representation of the spatial and temporal variability of the wind along the coast by the model. The model outputs are then used to document the fine-scale structures in the wind stress and wind curl in relation to the topographic features along the coast (headlands and embayments). Both wind stress and wind curl had a clear seasonal variability with annual and semiannual components. Alongshore wind stress maximum peak occurred in spring, second increase was in fall and minimum in winter. When a threshold of −3  ×  10−5 s−1 for the across-shore gradient of alongshore wind was considered to define the region from which the winds decrease toward the coast, the wind drop-off length scale varied between 8 and 45 km. The relative contribution of the coastal divergence and Ekman pumping to the vertical transport along the coast, considering the estimated wind drop-off length, indicated meridional alternation between both mechanisms, modulated by orography and the intricate coastline. Roughly, coastal divergence predominated in areas with low orography and headlands. Ekman pumping was higher in regions with high orography and the presence of embayments along the coast. In the study region, the vertical transport induced by coastal divergence and Ekman pumping represented 60 and 40 % of the total upwelling transport, respectively. The potential role of Ekman pumping on the spatial structure of sea surface temperature is also discussed.

scholarly journals Seasonal Evolution of the Upwelling Process South of Cape Blanco*

2008 ◽  
Vol 38 (1) ◽  
pp. 3-28 ◽  
Author(s):  
Steven R. Ramp ◽  
Frederick L. Bahr
Keyword(s):  
Water Column ◽  
Wind Stress ◽  
Transition Period ◽  
Spectral Characteristics ◽  
Satellite Sst ◽  
Strong Energy ◽  
Salinity Data ◽  
Wavelet Transform Analysis ◽  
Alongshore Wind Stress ◽  
Alongshore Wind

Abstract Bursts of upwelling-favorable winds lasting 4–20 days occur year-round south of Cape Blanco, a major headland on the Oregon coast. The ocean’s response to these events was studied using moored current, temperature, and salinity data; satellite SST data; and a few across-shelf sections near the mooring site. The mooring was located at 42°26.49′N, 124°34.47′W, 6 n mi off Gold Beach, Oregon, from May 2000 to October 2003. After the spring transition but before upwelling jet separation, equatorward wind stress produced a steady upwelling response much the same as a long, straight coast. Currents and winds had similar spectral characteristics with a peak near 15 days. After jet separation, upwelling-favorable winds forced a much more variable current consisting of a series of thin equatorward jets that evolved and moved offshore across the mooring, with shorter time scales than the wind stress forcing. During autumn, the equatorward wind stress weakened slightly and a transition period occurred, with the flow often poleward along the bottom. During winter, the water column was unstratified during poleward winds and currents with little variation in SST across the shelf. Winter upwelling restratified the water column from the bottom up by drawing cold, salty water onshore along the bottom, with little or no change in SST. This scenario was modulated by strong intraseasonal and interannual variability in the ocean and atmosphere. A wavelet transform analysis of alongshore wind stress and the first empirical orthogonal mode of the alongshore currents revealed strong energy peaks in the 30–70-day band. These signals were particularly clear in the ocean and were not coherent with the local wind stress, suggesting they were due to Kelvin waves of equatorial origin. The shift toward longer (40–45–60 days) periods from 2000 to 2003 was consistent with decreasing (warming) northern oscillation index, suggesting that the period as well as the energy of the intraseasonal waves may be important in transmitting heat poleward during warm years.

scholarly journals A Study of Low-Frequency, Wind-Driven, Coastal-Trapped Waves along the Southeast Coast of Australia

2018 ◽  
Vol 48 (2) ◽  
pp. 301-316 ◽  
Author(s):  
Fanglou Liao ◽  
Xiao Hua Wang
Keyword(s):  
Spectral Density ◽  
Power Spectral Density ◽  
Wind Stress ◽  
Energy Flux ◽  
Low Frequency ◽  
Coastal Trapped Waves ◽  
Southeast Coast ◽  
Power Spectral ◽  
Alongshore Wind Stress ◽  
Alongshore Wind

AbstractCoastal-trapped waves (CTWs) along the southeast coast of Australia were investigated based on a frictional, wind-driven long-wave theory. It was found that low-frequency sea level anomalies (SLAs) were continuously propagating from the south coast up along the east coast as CTWs, mainly forced by the alongshore wind stress. Three main subinertial peaks existed in the spectral characteristics of the SLAs, with periods of 14.2, 10.2, and 7.8 days, respectively. Power spectral density distributions of the peaks showed that the CTW amplitudes varied significantly along the southeast coast. For idealized linear and exponential shelves, a theoretical analysis indicated that the fundamental factor influencing the eigenvector of mode 1, and therefore the CTW amplitude, was the offshore water depth. This theoretical work was well supported by eight sensitivity cases. Four additional cases were conducted, and time-averaged energy fluxes were calculated to identify the energy source of the CTWs in the Australian Coastal Experiment (ACE) region. It was shown that both the local wind stress and the wind stress in Bass Strait contributed to the CTWs in the ACE region, with the latter playing a more important role. The remaining CTW energy came from remote forcing farther west of Bass Strait. The energy flux calculation also showed that the CTW energy flux was almost constant along the investigated coast because of the balance between frictional dissipation and the energy gain from the alongshore wind stress; the significant variations in the power spectral density (PSD) of the subinertial peaks were mainly due to the variations in the modal eigenvectors caused by the shelf geometry.

Particulate Hydrocarbon and Coprostanol Concentrations in Shelf Waters Adjacent to Chesapeake Bay

1983 ◽  
Vol 40 (S2) ◽  
pp. s34-s40 ◽  
Author(s):  
T. L. Wade ◽  
G. F. Oertel ◽  
R. C. Brown
Keyword(s):  
Chesapeake Bay ◽  
Wind Stress ◽  
Suspended Matter ◽  
Large Scale ◽  
Total Suspended Matter ◽  
Small Scale ◽  
Shelf Water ◽  
Low Salinity ◽  
Alongshore Wind Stress ◽  
Alongshore Wind

Adjacent to the entrances of major estuaries, the concentrations and distributions of particulate coprostanol, hydrocarbons, and total suspended matter are controlled by both small-scale and large-scale processes. These processes result in the development of spatially separate plumes of coprostanol, hydrocarbons, and total suspended matter. Particle buoyancy appears to be a major factor controlling the sorting of particles into the three discrete plumes. At the inner shelf adjacent to the Chesapeake Bay entrance, patchiness of coprostanol, hydrocarbon, and total suspended matter concentrations is also controlled by alongshore wind stress which enhances the uncoupling of the distal ends of plumes. While Chesapeake Bay appears to be a chronic source of anthropogenic materials to adjacent shelf water, major pathways of several pollutants (sewage derived and hydrocarbons) do not spatially coincide with turbid or low-salinity plumes.

scholarly journals Continental Shelf Baroclinic Instability. Part I: Relaxation from Upwelling or Downwelling

2016 ◽  
Vol 46 (2) ◽  
pp. 551-568 ◽  
Author(s):  
K. H. Brink
Keyword(s):  
Kinetic Energy ◽  
Wind Stress ◽  
Indirect Evidence ◽  
Good Deal ◽  
Eddy Kinetic Energy ◽  
Bottom Slope ◽  
Coriolis Parameter ◽  
Present Contribution ◽  
Alongshore Wind Stress ◽  
Alongshore Wind

AbstractThere exists a good deal of indirect evidence, from several locations around the world, that there is a substantial eddy field over continental shelves. These eddies appear to have typical swirl velocities of a few centimeters per second and have horizontal scales of perhaps 5–10 km. These eddies are weak compared to typical, wind-driven, alongshore flows but often seem to dominate middepth cross-shelf flows. The idea that motivates the present contribution is that the alongshore wind stress ultimately energizes these eddies by means of baroclinic instabilities, even in cases where obvious intense fronts do not exist. The proposed sequence is that alongshore winds over a stratified ocean cause upwelling or downwelling, and the resulting horizontal density gradients are strong enough to fuel baroclinic instabilities of the requisite energy levels. This idea is explored here by means of a sequence of idealized primitive equation numerical model studies, each driven by a modest, nearly steady, alongshore wind stress applied for about 5–10 days. Different runs vary wind forcing, stratification, bottom slope, bottom friction, and Coriolis parameter. All runs, both upwelling and downwelling, are found to be baroclinically unstable and to have scales compatible with the underlying hypothesis. The model results, combined with physically based scalings, show that eddy kinetic energy generally increases with bottom slope, stratification, wind impulse (time integral of the wind stress), and inverse Coriolis parameter. The dominant length scale of the eddies is found to increase with increasing eddy kinetic energy and to decrease with Coriolis parameter.

scholarly journals A numerical model and validation of phase change material integrated thermoelectric radiant cooling panel

2019 ◽  
Vol 111 ◽  
pp. 01001
Author(s):  
Hansol Lim ◽  
Hye-Jin Cho ◽  
Seong-Yong Cheon ◽  
Soo-Jin Lee ◽  
Jae-Weon Jeong
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Numerical Model ◽  
Surface Temperature ◽  
Phase Change ◽  
Transfer Coefficient ◽  
Phase Change Material ◽  
Overall Heat Transfer Coefficient ◽  
Radiant Cooling ◽  
Change Material

A phase change material based radiant cooling panel with thermoelectric module (PCM-TERCP) is proposed in this study. It consists of two aluminium panels, and phase change materials (PCMs) sandwiched between the two panels. Thermoelectric modules (TEMs) are attached to one of the aluminium panels, and heat sinks are attached to the top side of TEMs. PCM-TERCP is a thermal energy storage concept equipment, in which TEMs freeze the PCM during the night whose melting temperature is 16○C. Therefore, the radiant cooling panel can maintain a surface temperature of 16◦C without the operation of TEM during the day. Furthermore, it is necessary to design the PCM-TERCP in a way that it can maintain the panel surface temperature during the targeted operating time. Therefore, the numerical model was developed using finite difference method to evaluate the thermal behaviour of PCM-TERCP. Experiments were also conducted to validate the performance of the developed model. Using the developed model, the possible operation time was investigated to determine the overall heat transfer coefficient required between radiant cooling panel and TEM. Consequently, the results showed that a overall heat transfer coefficient of 394 W/m2K is required to maintain the surface temperature between 16○C to 18○C for a 3 hours operation.

Sign in / Sign up

Export Citation Format

Share Document