Numerical investigation of leading-edge vortex for low-aspect ratio thin wings

AIAA Journal ◽  
1976 ◽  
Vol 14 (2) ◽  
pp. 253-255 ◽  
Author(s):  
Colmar Rehbach
Keyword(s):  
Aspect Ratio ◽  
Numerical Investigation ◽  
Leading Edge ◽  
Leading Edge Vortex ◽  
Low Aspect Ratio ◽  
Edge Vortex

scholarly journals Leading-Edge Vortex Characteristics of Low-Aspect-Ratio Sweptback Plates at Low Reynolds Number

2021 ◽  
Vol 11 (6) ◽  
pp. 2450
Author(s):  
Jong-Seob Han ◽  
Christian Breitsamter
Keyword(s):  
Reynolds Number ◽  
Aspect Ratio ◽  
Leading Edge ◽  
Flapping Wing ◽  
Flat Plates ◽  
Leading Edge Vortex ◽  
Low Aspect Ratio ◽  
Aspect Ratios ◽  
Oil Flow ◽  
Edge Vortex

A sweptback angle can directly regulate a leading-edge vortex on various aerodynamic devices as well as on the wings of biological flyers, but the effect of a sweptback angle has not yet been sufficiently investigated. Here, we thoroughly investigated the effect of the sweptback angle on aerodynamic characteristics of low-aspect-ratio flat plates at a Reynolds number of 2.85 × 104. Direct force/moment measurements and surface oil-flow visualizations were conducted in the wind-tunnel B at the Technical University of Munich. It was found that while the maximum lift at an aspect ratio of 2.03 remains unchanged, two other aspect ratios of 3.13 and 4.50 show a gradual increment in the maximum lift with an increasing sweptback angle. The largest leading-edge vortex contribution was found at the aspect ratio of 3.13, resulting in a superior lift production at a sufficient sweptback angle. This is similar to that of a revolving/flapping wing, where an aspect ratio around three shows a superior lift production. In the oil-flow patterns, it was observed that while the leading-edge vortices at aspect ratios of 2.03 and 3.13 fully covered the surfaces, the vortex at an aspect ratio of 4.50 only covered up the surface approximately three times the chord, similar to that of a revolving/flapping wing. Based on the pattern at the aspect ratio of 4.50, a critical length of the leading-edge vortex of a sweptback plate was measured as ~3.1 times the chord.

scholarly journals Interplay of the leading-edge vortex and the tip vortex of a low-aspect-ratio thin wing

2020 ◽  
Vol 61 (9) ◽  
Author(s):  
Lei Dong ◽  
Kwing-So Choi ◽  
Xuerui Mao
Keyword(s):  
Aspect Ratio ◽  
Angle Of Attack ◽  
Three Dimensional ◽  
Separated Flow ◽  
Leading Edge ◽  
Tip Vortex ◽  
Leading Edge Vortex ◽  
Low Aspect Ratio ◽  
Thin Wing ◽  
Edge Vortex

Abstract Three-dimensional vortical structures and their interaction over a low-aspect-ratio thin wing have been studied via particle image velocimetry at the chord Reynolds number of $$10^5$$ 10 5 . The maximum lift of this thin wing is found at an angle of attack of $$42^\circ$$ 42 ∘ . The flow separates at the leading-edge and reattaches to the wing surface, forming a strong leading-edge vortex which plays an important role on the total lift. The results show that the induced velocity of the tip vortex increases with the angle of attack, which helps reattach the separated flow and maintains the leading-edge vortex. Turbulent mixing indicated by the high Reynolds stress can be observed near the leading-edge due to an intense interaction between the leading-edge vortex and the tip vortex; however, the reattachment point of the leading-edge vortex moves upstream closer to the wing tip. Graphic abstract

scholarly journals On the lift-optimal aspect ratio of a revolving wing at low Reynolds number

2018 ◽  
Vol 15 (143) ◽  
pp. 20170933 ◽  
Author(s):  
T. Jardin ◽  
T. Colonius
Keyword(s):  
Aspect Ratio ◽  
Lift Coefficient ◽  
Leading Edge ◽  
Rossby Number ◽  
Subsequent Work ◽  
High Lift ◽  
Low Aspect Ratio ◽  
Axis Of Rotation ◽  
Edge Vortex ◽  
Convergent Solution

Lentink & Dickinson (2009 J. Exp. Biol. 212 , 2705–2719. ( doi:10.1242/jeb.022269 )) showed that rotational acceleration stabilized the leading-edge vortex on revolving, low aspect ratio (AR) wings and hypothesized that a Rossby number of around 3, which is achieved during each half-stroke for a variety of hovering insects, seeds and birds, represents a convergent high-lift solution across a range of scales in nature. Subsequent work has verified that, in particular, the Coriolis acceleration plays a key role in LEV stabilization. Implicit in these results is that there exists an optimal AR for wings revolving about their root, because it is otherwise unclear why, apart from possible morphological reasons, the convergent solution would not occur for an even lower Rossby number. We perform direct numerical simulations of the flow past revolving wings where we vary the AR and Rossby numbers independently by displacing the wing root from the axis of rotation. We show that the optimal lift coefficient represents a compromise between competing trends with competing time scales where the coefficient of lift increases monotonically with AR, holding Rossby number constant, but decreases monotonically with Rossby number, when holding AR constant. For wings revolving about their root, this favours wings of AR between 3 and 4.

scholarly journals The effect of aspect ratio on the leading-edge vortex over an insect-like flapping wing

2015 ◽  
Vol 10 (5) ◽  
pp. 056020 ◽  
Author(s):  
Nathan Phillips ◽  
Kevin Knowles ◽  
Richard J Bomphrey
Keyword(s):  
Aspect Ratio ◽  
Leading Edge ◽  
Flapping Wing ◽  
Leading Edge Vortex ◽  
Edge Vortex

scholarly journals Numerical Investigation of a Dynamic Stall on a Single Rotating Blade

Aerospace ◽  
2021 ◽  
Vol 8 (4) ◽  
pp. 90
Author(s):  
Yin Ruan ◽  
Manfred Hajek
Keyword(s):  
Numerical Investigation ◽  
Vortex Structure ◽  
Leading Edge ◽  
Rotor Blades ◽  
Tip Vortex ◽  
Dynamic Stall ◽  
Leading Edge Vortex ◽  
Pitching Airfoil ◽  
Edge Vortex ◽  
High Reynolds

Dynamic stall is a phenomenon on the retreating blade of a helicopter which can lead to excessive control loads. In order to understand dynamic stall and fill the gap between the investigations on pitching wings and full helicopter rotor blades, a numerical investigation of a single rotating and pitching blade is carried out. The flow phenomena thereupon including the Ω-shaped dynamic stall vortex, the interaction of the leading edge vortex with the tip vortex, and a newly noticed vortex structure originating inboard are examined; they show similarities to pitching wings, while also possessing their unique features of a rotating system. The leading edge/tip vortex interaction dominates the post-stall stage. A newly noticed swell structure is observed to have a great impact on the load in the post-stall stage. With such a high Reynolds number, the Coriolis force exerted on the leading edge vortex is negligible compared to the pressure force. The force history/vortex structure of the slice r/R = 0.898 is compared with a 2D pitching airfoil with the same harmonic pitch motion, and the current simulation shows the important role played by the swell structure in the recovery stage.

Sign in / Sign up

Export Citation Format

Share Document