scholarly journals Review on Optimising Solar PV Efficiency by Using Tracking and Cooling System

2019 ◽  
Vol 5 (4) ◽  
pp. 6
Author(s):  
Anil Khatri ◽  
Prof. Nitin Tenguria

The increasing energy demand, continuous drawback of the existing sources of fossil fuels and increasing concern about environmental pollution pushed researchers to explore new technologies for the production of electricity from clean sources, renewable such as solar, wind etc. Solar energy is the oldest primary source of energy. It is a source of clean, renewable energy and it is found in abundance in every part of the world. Using solar energy is possible to convert it into mechanical energy or electricity with adequate efficiency. In this paper of the present of principal of solar cell and the temperature effect. And the Information about the quality and amount of solar energy available at a specific location is of prime importance for the development of a solar energy system. However, the amount of electricity that is obtained is directly proportional to the intensity of sunlight falling on the photovoltaic panel.

2014 ◽  
Vol 899 ◽  
pp. 199-204
Author(s):  
Lukáš Skalík ◽  
Otília Lulkovičová

The energy demand of buildings represents in the balance of heat use and heat consumption of energy complex in the Slovak national economy second largest savings potential. Their complex energy demands is the sum of total investment input to ensure thermal protection and annual operational demands of particular energy systems during their lifetime in building. The application of energy systems based on thermal solar systems reduces energy consumption and operating costs of building for support heating and domestic hot water as well as savings of non-renewable fossil fuels. Correctly designed solar energy system depends on many characteristics, i. e. appropriate solar collector area and tank volume, collector tilt and orientation as well as quality of used components. The evaluation of thermal solar system components by calculation software shows how can be the original thermal solar system improved by means of performance. The system performance can be improved of more than 31 % than in given system by changing four thermal solar system parameters such as heat loss coefficient and aperture area of used solar collector, storage tank volume and its height and diameter ratio.


Author(s):  
Anita Rønne

Increasing focus on sustainable societies and ‘smart cities’ due to emphasis on mitigation of climate change is simultaneous with ‘smart regulation’ reaching the forefront of the political agenda. Consequently, the energy sector and its regulation are undergoing significant innovation and change. Energy innovations include transition from fossil fuels to more renewable energy sources and application of new computer technology, interactively matching production with consumer demand. Smart cities are growing and projects are being initiated for development of urban areas and energy systems. Analysis from ‘Smart Cities Accelerator’, developed under the EU Interreg funding programme that includes Climate-KIC,——provides background for the focus on a smart energy system. Analysis ensures the energy supply systems support the integration of renewables with the need for new technologies and investments. ‘Smart’ is trendy, but when becoming ‘smart’ leads to motivation that is an important step towards mitigating climate change.


2017 ◽  
Vol 9 (1) ◽  
pp. 5-14 ◽  
Author(s):  
Maryam Hamlehdar ◽  
Alireza Aslani

Abstract Today, the fossil fuels have dominant share of energy supply in order to respond to the high energy demand in the world. Norway is one of the countries with rich sources of fossil fuels and renewable energy sources. The current work is to investigate on the status of energy demand in Norway. First, energy and electricity consumption in various sectors, including industrial, residential are calculated. Then, energy demand in Norway is forecasted by using available tools. After that, the relationship between energy consumption in Norway with Basic economics parameters such as GDP, population and industry growth rate has determined by using linear regression model. Finally, the regression result shows a low correlation between variables.


2016 ◽  
Vol 5 (3) ◽  
pp. 51-67
Author(s):  
Mohammad Mehdi Ghiasi ◽  
Alireza Aslani ◽  
Younes Noorollahi

The energy demand has increased dramatically in the recent decades. Due to the limitations and environmental effects of fossil fuels, secure level of energy supply is vital for economic and social development. This work is to review the energy sector in South Africa. After that, the consumptions of coal, oil, natural gas, and nuclear energy are estimated by employing simple exponential smoothing methodology. Finding shows that the primary energy consumption in the South Africa is correlated as a function of population growth rate, industrial growth rate, and GDP.


2019 ◽  
Vol 66 (2) ◽  
pp. 99-120
Author(s):  
Wilmer Emilio García Moreno ◽  
Andressa Ullmann Duarte ◽  
Litiéle dos Santos ◽  
Rogério Vescia Lourega

AbstractThe photovoltaic technologies have been developed year by year in different countries; however, there are some countries where this kind of energy is being born, such as the Brazilian case. In this paper, some important parameters are analysed and applied to different solar cell materials, identifying that if the fossil fuels were substituted by solar cells, it would reduce the CO2 emissions by 93.2%. In addition, it is shown that the efficiency of solar cells is not as farther as it could be thought from coal thermoelectrical plants in Brazil and the cost of energy using solar cells could be as good as these thermoelectrical plants. Finally, the potentiality of Brazilian territory to implant this technology is presented, identifying that with the use of 0.2% of the territory, the energy demand could be supplied.


Author(s):  
Cory Budischak ◽  
Keith W. Goossen

Solar energy will be an important source of energy for a sustainable energy system whether or not it is directly collected (solar thermal, photovoltaics) or indirectly collected (wind, wave, etc). This project focused on increasing the efficiency of the direct conversion of solar energy into electricity, which is also known as photovoltaics (PV). It has long been known that photovoltaic cells perform less efficiently at higher temperatures. In fact, solar modules under concentration are frequently cooled either actively or passively. The current study, however, focused on cooling modules under no concentration. The goal of the current project was to answer the question: Can the energy gained by cooling a photovoltaic module with groundwater be greater than the energy used by the cooling system and is there an economic benefit? A digital simulation of a simple photovoltaic module under groundwater cooling was performed in order to answer the research question. The simulation was performed for Phoenix, AZ and assuming certain control parameters it was found that the overall system produced over 9% more electricity than a system without groundwater cooling. While the groundwater cooled system increased overall electrical production, the economics of the system will also be presented. Recently, an Arizona utility APS introduced time of use pricing for electricity. Because groundwater cooling provides the most benefit during very hot days with high electrical demand, cooling is more economically attractive. A simple economic analysis will be presented including estimated costs of the cooling system and added value of the excess electrical energy produced under different APS rate plans.


2021 ◽  
Author(s):  
Annie Chow

Alternative sources of energy are being sought after in the world today, as the availability of fossil fuels and other non-renewable resources are declining. Solar energy offers a promising solution to this search as it is a less polluting renewable energy resource and can be easily converted into electricity through the usage of photovoltaic systems. This thesis focuses on the modeling of urban solar energy with high spatiotemporal resolution. A methodology was developed to estimate hourly solar PV electricity generation potential on rooftops in an urban environment using a 3-D model. A case study area of Ryerson University, Toronto was chosen and the incident solar radiation upon each building rooftop was calculated using a software tool called Ecotect Analysis 2011. Secondly, orthophotos of the case study area were digitized using Geographic Information Systems in order to eliminate undesirable rooftop objects within the model. Lastly, a software tool called HOMER was used to generate hourly solar PV electricity estimates using the values generated by the other two software tools as input parameters. It was found that hourly solar PV output followed the pattern of a binomial curve and that peak solar generation times coincided with summer peak electricity consumption hours in Ontario.


Author(s):  
Ramzi Alahmadi ◽  
◽  
Kamel Almutairi ◽  

With the increasing global concerns about greenhouse gas emissions caused by the extensive use of fossil fuels, many countries are investing in the deployment of clean energy sources. The utilization of abundant solar energy is one of the fastest growing deployed renewable sources due its technological maturity and economic competitivity. In addition to report from the National Renewable Energy Laboratory (NREL), many studies have suggested that the maturity of solar energy systems will continue to develop, which will increase their economic viability. The focus of analysis in this paper is countries with hot desert climates since they are the best candidates for solar energy systems. The capital of Saudi Arabia, Riyadh is used as the case study due to the country’s ambitious goals in this field. The main purpose of this study is to comprehensively analyze the stochastic behavior and probabilistic distribution of solar irradiance in order to accurately estimate the expected power output of solar systems. A solar Photovoltaic (PV) module is used for the analysis due to its practicality and widespread use in utility-scale projects. In addition to the use of a break-even analysis to estimate the economic viability of solar PV systems in hot desert climates, this paper estimates the indifference point at which the economic feasibility of solar PV systems is justified, compared with the fossil-based systems. The numerical results show that the break-even point of installing one KW generation capacity of a solar PV system is estimated to pay off after producing 16,827 KWh, compared to 15,422 KWh for the case of fossil-based systems. However, the increased cost of initial investment in solar PV systems deployment starts to be economically justified after producing 41,437 KWh.


Author(s):  
Eur Ing A J Blokland ◽  
I P Barendregt ◽  
C J C M Posthumus

The Netherlands Ministry of Defence (MoD) has issued an Operational Energy Strategy (OES) with ambition targets for energy independence and improvement of energy efficiency during the life time of naval platforms. A target is given in 2030 of 20 % reduced dependence on fossil fuels and in 2050 of 70 % reduced dependence on fossil fuels, compared to 2010. More stringent environmental emission (NOx, CO2, etc.) requirements are to be expected as a result from IMO and (local) political regulations. In the last decades the power consumption on board of naval platforms increased substantially as well as the complexity of integrated energy systems. Market surveys shows that the evolution of commercial green technologies are promising but have to be demonstrated in the coming years on low power and energy levels. They will not be de-risked in depth or well proven to be successful in time to be selected for the Royal Netherlands Navy (RNLN) new naval projects (2019 – 2025). Furthermore, new technologies as energy resources and carriers (H2, LNG, methanol, power-to-liquid (PTL), etc.) or new system technologies (DC on high voltage level, fuel cell systems, waste energy recovery, etc.) require a new approach for integration aspects like hazard and safety cases and energy efficiency. This is because the energy demand on board of naval platforms in several military operational modes differ from the merchant and off-shore branch. In this paper an approach for an adaptable energy platform is described to design a new naval platform based on nowadays proven technology as fossil fuels that can be transformed during life time that can fulfill the expectations and requirements of the coming decades (non-fossil fuels, zero emission, improved energy efficiency). Aspects as a naval energy index as reference will be discussed as well as an evaluation of new technologies for new naval platform integration design parameters, such as power or energy demands, consequences of energy resources, energy control as well as build in ship construction safety measures.


2015 ◽  
Vol 11 (1) ◽  
pp. 9-28
Author(s):  
I. Patay ◽  
M. Montvajszki

Water pumping for irrigation has a relatively high energy demand, depending on the applied irrigation method. At the same time, there is a considerable energy from the sun during the irrigation period. The solar PV (photovoltaic) technology may be suitable to ensure electric energy for pumping in many cases in agriculture, where the electric network is not available or reduction of the energy costs is wanted. There are some pilot plants for water pumping on the base of solar energy in the world and the spreading of these solar technologies is predictable. The solar energy based pumping process can be approached both in theoretical and experimental ways. In this paper, both the theoretical questions of the solar based pumping process and the experimental results of a model testing pump station powered by PV panels are shown.


Sign in / Sign up

Export Citation Format

Share Document