scholarly journals To the problems of wastewater treatment from mineral pollutants with the use of microalgae

2021 ◽  
Vol 6 (1) ◽  
pp. 15-20
Author(s):  
Vasil Dyachok ◽  
◽  
Solomiia Mandryk ◽  
Serhiy Huhlych ◽  
◽  
...  

This article presents the results of experimental studies on the use of Chlorella microalgae for wastewater treatment from the most common mineral pollutants. The influence of the mineral pollutants, namely anions HSO3- , NO3 - , H2PO4 - on the dynamics of wastewater treatment has been established. Analytical dependences of microalgae biomass growth rate depending on pollutant concentration HSO3- , NO3 - , H2PO4 - and are obtained. The values of biomass growth coefficients at the corresponding pollutant concentrations are determined. Based on the obtained experimental research results, mathematical models have been constructed that allow predicting the maximum values of mineral pollutants concentrations at which effective wastewater treatment by chlorophyllsynthesizing microalgae is possible. The technological scheme of wastewater treatment from mineral pollutants and the mechanism of the obtained application biomass are proposed.

2018 ◽  
Vol 22 (6) ◽  
pp. 15-19
Author(s):  
E.H. Sakaeva ◽  
L.V. Rudakova

The results of experimental studies on the evaluation of the possibility of using enzyme complexes in the biological treatment of waste water from pulp and paper enterprises are presented. The use of enzyme complexes will increase the efficiency of wastewater treatment by COD and BOD, and will also have a beneficial effect on the hydrochemical and hydrobiological characteristics of activated sludge. Experimental studies have determined the points of introduction of enzyme complexes into the technological scheme of biological wastewater treatment.


2021 ◽  
Author(s):  
Weining Lin

Clostridium phytofermentans, a newly isolated mesophilic anaerobic bacterium from forest soil, has received considerable attention for its potential application in producing ethanol directly from cellulose. This microorganism produces ethanol, acetate, CO₂ and H₂ as major metabolites from cellulose. Potential applications of this research include the transformation of waste materials into valuable products, such as fuels and organic acids. As an initial part of a multi-staged project, this study is to focus on the characerization of this microorganism growth and to verify the bacterium kinetics, including biomass growth, substrate utilization, and gas production. A series of batch fermentation experiments using cellulose substrate (GS-2C) was performed under the incubation temperature of 37°C. To investigate the effects of pH and substrate concentration (S₀) on growth, 12 trial experiments were conducted with various controlled pH values (7.0 to 8.5) and with various initial cellulose concentration settings (0.1 to 6.0 g/L). Our experimental results showed that the optimal growth condition for C. phytofermentans in batch culture was at pH = 8.4 amd S₀ = 6.0 g/L. Under such condition, the maximum growth rate of 0.37h⁻¹ was observed. Comparing results with other celluloytic clostridium studies, relatively high biomass growth rate using C. phytofermentans is confirmed by our experiments. Mathematical models, using a combination modelling approach with the logistic equation. Monod model, and Luedeking-Piret model, were developed for biomass growth, substrate degradation, and biogas production, respectively, base on our experiment results. This study demonstrated the determination of the four parameters (µmax, Ks, Y, and Smin), which can describe satisfactorily growth or degradation phenomena, using the proposed integration modelling approach. The experiments conducted under wide range conditions, such as changing pH and S₀, not only provide insight into growth kinetics but also provide an opportunity to evaluate the performance of the mathematical models and understand their limitations. This leads to look for improvement or modification to the models. It is foreseen that the findings in this study will enhance the overall understanding of the kinetics of growth and substrate utilization and product formation of this bacterium, and provide important information on the design of the bench-scale anaerobic bioreactor for future studies.


2019 ◽  
Vol 135 ◽  
pp. 01026
Author(s):  
Tamara Khalturina ◽  
Olga Churbakova ◽  
Yuri Skolubovich ◽  
Evgeniy Voitov ◽  
Denis Balchugov

The goal of the work was to study the electrocoagulation of oily wastewater using an asymmetric current and to determine the composition of the resulting sludge for disposal. The planning of the experiment according to Box-Hunter method was given and mathematical models - regression equations of the electrocoagulation process of oily wastewater using an asymmetric current were obtained. Optimization was performed by the dissociative-step method due to the regression equations. The structure and composition of sludge obtained under optimal electrocoagulation conditions using asymmetric current for the disposal of sludge in the arbolite mixtures production were studied. The results of experimental studies can be used to develop low-waste efficient, energy-saving technologies for wastewater treatment and waste management.


2021 ◽  
Vol 4 (1(112)) ◽  
pp. 14-25
Author(s):  
Omirserik Zhortuylov ◽  
Gani Zhumatay ◽  
Askar Rzaliyev ◽  
Tokhtar Abilzhanuly ◽  
Orynzhamal Sarsembenova ◽  
...  

This paper presents the results of experimental research on the development and substantiation of parameters and operating modes of the drive mechanism of the cutting apparatus in a mower with a double knife stroke. A structural and technological scheme of the drive mechanism of the cutting device of the segment-finger type mower has been developed, in which a double stroke of the cutting device knife is provided. Analytical relationships were obtained to determine the knife stroke, speed and acceleration. Based on the results of theoretical and experimental studies, the main parameters of the mower drive mechanism were substantiated. Based on the condition of a high-quality cut of plants, at a minimum grass cutting speed, the minimum crank shaft speed was determined. By calculation, the feed area and the load area of the cutter for normal cutting with a double cut of the knife are determined. Analytical relationships were obtained to determine the power required to drive the cutterbar of a mower with a double knife stroke. Based on the research results, the main parameters of the mower with an improved drive are substantiated. An experimental sample was made and preliminary tests of the drive mechanism were carried out, agrotechnical and energy indicators of the mower operation were determined.


2017 ◽  
Vol 33 (1) ◽  
pp. 73-78 ◽  
Author(s):  
Grzegorz B. Kaczor ◽  
Krzysztof Chmielowski ◽  
Piotr Bugajski

Abstract The aim of the study was to analyze an influence of an inflow penetrating into two selected small sewerage systems during a rainy weather on pollutant concentration and load in raw sewage. Studies were conducted in 2010–2015 on two small sewerage systems in Małopolska province. The studies confirmed that the inflow penetrating into the sewerage systems resulted in a decrease of pollutant concentrations in sewage. However, they also showed that this dilution was not constant for all types of pollutants. The most important outcome of the study was demonstrating that despite its diluting effect on pollutants, the intense inflow into a sewerage system resulted in an increase of a sewage pollutant load. This increase was not regular, but it was rising dramatically when the inflow share in sewage exceeded 50%. The study indicated that the inflow penetrating into the sewerage system should not be disregarded, as it actually presented a significant threat to the wastewater treatment process and in consequence to the quality of recipient waters.


2021 ◽  
Author(s):  
Weining Lin

Clostridium phytofermentans, a newly isolated mesophilic anaerobic bacterium from forest soil, has received considerable attention for its potential application in producing ethanol directly from cellulose. This microorganism produces ethanol, acetate, CO₂ and H₂ as major metabolites from cellulose. Potential applications of this research include the transformation of waste materials into valuable products, such as fuels and organic acids. As an initial part of a multi-staged project, this study is to focus on the characerization of this microorganism growth and to verify the bacterium kinetics, including biomass growth, substrate utilization, and gas production. A series of batch fermentation experiments using cellulose substrate (GS-2C) was performed under the incubation temperature of 37°C. To investigate the effects of pH and substrate concentration (S₀) on growth, 12 trial experiments were conducted with various controlled pH values (7.0 to 8.5) and with various initial cellulose concentration settings (0.1 to 6.0 g/L). Our experimental results showed that the optimal growth condition for C. phytofermentans in batch culture was at pH = 8.4 amd S₀ = 6.0 g/L. Under such condition, the maximum growth rate of 0.37h⁻¹ was observed. Comparing results with other celluloytic clostridium studies, relatively high biomass growth rate using C. phytofermentans is confirmed by our experiments. Mathematical models, using a combination modelling approach with the logistic equation. Monod model, and Luedeking-Piret model, were developed for biomass growth, substrate degradation, and biogas production, respectively, base on our experiment results. This study demonstrated the determination of the four parameters (µmax, Ks, Y, and Smin), which can describe satisfactorily growth or degradation phenomena, using the proposed integration modelling approach. The experiments conducted under wide range conditions, such as changing pH and S₀, not only provide insight into growth kinetics but also provide an opportunity to evaluate the performance of the mathematical models and understand their limitations. This leads to look for improvement or modification to the models. It is foreseen that the findings in this study will enhance the overall understanding of the kinetics of growth and substrate utilization and product formation of this bacterium, and provide important information on the design of the bench-scale anaerobic bioreactor for future studies.


2019 ◽  
Author(s):  
Faina Satdarova

General analysis of the distribution of crystals orientation and dislocation density in the polycrystalline system is presented. Recovered information in diffraction of X-rays adopting is new to structure states of polycrystal. Shear phase transformations in metals — at the macroscopic and microscopic levels — become a clear process. Visualizing the advances is produced by program included in package delivered. Mathematical models developing, experimental design, optimal statistical estimation, simulation the system under study and evolution process on loading serves as instrumentation. To reduce advanced methods to research and studies problem-oriented software will promote when installed. Automation programs passed a testing in the National University of Science and Technology “MISIS” (The Russian Federation, Moscow). You score an advantage in theoretical and experimental research in the field of physics of metals.


2020 ◽  
Vol 67 (1) ◽  
pp. 148-155
Author(s):  
Anatoliy V. Fedotov ◽  
Viktor S. Grigoriev ◽  
Dmitriy A. Kovalev ◽  
Andrey A. Kovalev

To speed up the wastewater treatment under aerobic conditions and to optimize the processes of anaerobic wastewater treatment in digesters, immobilization technologies of microorganisms and enzymes on solid carriers are used. Ceramic carriers based on aluminosilicates and alumina are one of the promising inorganic biomass carriers. (Research purpose) To study the structure of porous ceramic biomass carriers for anaerobic processing of organic waste and evaluate the prospects for their use. (Materials and methods) The substrate for anaerobic digestion was a mixture of sediments of the primary and secondary sewage sumps of the Lyubertsy treatment facilities. K-65 cattle feed was used to ensure the constancy of the composition of organic substances in substrates as a cosubstrate. The authors used the method of low-temperature nitrogen adsorption of Bruner-Emmett-Teller to study the pore structure and specific surface of solid carriers on a specific surface analyzer Quntachrome Autosorb-1. (Results and discussion) The main characteristics (specific surface, volume of micro- and mesopores, predominant pore radius, water absorption and others) of chamotte foam lightweight and highly porous corundum ceramics were determined. It was revealed that ceramic materials with a developed surface and electrically conductive material provided an increase in biogas yield by 3.8-3.9 percent with an increase in methane content by an average of 5 percent. (Conclusions) The results of anaerobic digestion showed a positive effect of both a conductive carrier and highly porous ceramic materials on the process of anaerobic bioconversion of organic waste into biogas. It is advisable to expand experimental studies on the use of a conductive carrier with a developed surface based on highly porous ceramics.


Sign in / Sign up

Export Citation Format

Share Document