scholarly journals Acoustic emission partial discharge detection technique applied to fault diagnosis: Case studies of generator transformers

2016 ◽  
Vol 13 (2) ◽  
pp. 189-202 ◽  
Author(s):  
Tangella Shanker ◽  
Hebbale Nagamani Narasimhaiah ◽  
Gururaj Punekar
Keyword(s):  
Acoustic Emission ◽  
Fault Diagnosis ◽  
Case Studies ◽  
Partial Discharge ◽  
Detection Technique ◽  
Discharge Detection

Metrics for partial discharge detection by the acoustic emission technique to support decision-making

2016 ◽  
Author(s):  
Andre P. Marques ◽  
Claudio H. B. Azevedo ◽  
Jose A. L. dos Santos ◽  
Felipe R. De C. Sousa ◽  
Cacilda J. Ribeiro ◽  
...  
Keyword(s):  
Decision Making ◽  
Acoustic Emission ◽  
Partial Discharge ◽  
Acoustic Emission Technique ◽  
Support Decision Making ◽  
Discharge Detection

scholarly journals Development of Acoustic Emission Sensor Optimized for Partial Discharge Monitoring in Power Transformers

Sensors ◽  
2019 ◽  
Vol 19 (8) ◽  
pp. 1865 ◽  
Author(s):  
Sikorski
Keyword(s):  
Acoustic Emission ◽  
Partial Discharge ◽  
Low Noise ◽  
Partial Discharges ◽  
Power Transformers ◽  
Laboratory Research ◽  
Fully Differential ◽  
Peak Sensitivity ◽  
Optimal Material ◽  
Discharge Detection

The acoustic emission (AE) technique is one of the unconventional methods of partial discharges (PD) detection. It plays a particularly important role in oil-filled power transformers diagnostics because it enables the detection and online monitoring of PDs as well as localization of their sources. The performance of this technique highly depends on measurement system configuration but mostly on the type of applied AE sensor. The paper presents, in detail, the design and manufacturing stages of an ultrasensitive AE sensor optimized for partial discharge detection in power transformers. The design assumptions were formulated based on extensive laboratory research, which allowed for the identification of dominant acoustic frequencies emitted by partial discharges in oil–paper insulation. The Krimholtz–Leedom–Matthaei (KLM) model was used to iteratively find optimal material and geometric properties of the main structures of the prototype AE sensor. It has two sensing elements with opposite polarization direction and different heights. The fully differential design allowed to obtain the desired properties of the transducer, i.e., a two-resonant (68 kHz and 90 kHz) and wide (30‒100 kHz) frequency response curve, high peak sensitivity (−61.1 dB ref. V/µbar), and low noise. The laboratory tests confirmed that the prototype transducer is characterized by ultrahigh sensitivity of partial discharge detection. Compared to commonly used commercial AE sensors, the average amplitude of PD pulses registered with the prototype sensor was a minimum of 5.2 dB higher, and a maximum of 19.8 dB higher.

Sign in / Sign up

Export Citation Format

Share Document