scholarly journals Experimental and Numerical Study on the Impact Fracture Characteristics of a Sea Ice Floe against a Pile Structure

Author(s):  
Shinji Kioka ◽  
Takahiro Takeuchi ◽  
Shunji Kanie
2020 ◽  
Vol 192 ◽  
pp. 04002
Author(s):  
Lihai Tan ◽  
Ting Ren ◽  
Xiaohan Yang ◽  
Xueqiu He

It has been well accepted by mining researchers that coal tends to undergo abrupt fracture under the coupling effect of dynamic and static loads. Hence, the study of influence of coupled static and dynamic loads on coal failure behaviour is meaningful for the understanding of coal burst. In this paper, PFC modelling of SHPB test is adopted to investigate the fracture mode and energy evolution of Australian hard coal under different combinations of pre-stress levels and impact velocities. Results have shown that high dynamic load will make the fracture mode and energy release of coal samples more violent even the static load is low. Although the strain energy increases with pre-stress level, the kinetic energy remains on a low level with the increase of pre-stress level when the impact velocity is 4 m/s.


1984 ◽  
Vol 106 (2) ◽  
pp. 167-172 ◽  
Author(s):  
W. Johnson ◽  
Y. L. Bai ◽  
S. K. Ghosh

This paper derives from a study of grinding wheel break-up behavior due to impact. The impact fracture characteristics of circular disks of plaster of Paris with a concentric central hole were studied experimentally [1] for three types of loading: (a) when the disks were suspended freely and loaded intensely at one point on their circumference by an explosive detonator; (b) when the disks were allowed to fall under gravity from a certain height on to a rigid base; and (c) when a disk, resting on a rigid base, was struck by a flat ended rigid body which was dropped on to it from a certain height. Quasi-static flattening tests on the disks were also carried out. The paper describes a theoretical investigation into the stress analysis of disks under impact, classifies the relevant damage sustained by them and attempts to unify the “gross” impact fracture patterns which arise in different modes of dynamic loading. The extent of local flattening of the quasi-statically loaded disks before fracture, is also reported. Good correlation between the theory and experimental results is obtained, especially for rings of diameter ratio (Di/D0) of around 0.5.


Author(s):  
Biao Su ◽  
Karl Gunnar Aarsæther ◽  
David Kristiansen

This paper presents a numerical model for simulating wave-driven ice floe–structure interactions, which is integrated in a software framework (FhSim) for time-domain simulation of marine systems. The FhSim framework has proved to be a valuable tool for research and development within different applications and areas [1]. In this study, the wave-driven impact of a sea ice floe on a circular cylinder is simulated. The simulation setup refers to a recent experimental study [2], and the kinematics of ice floe in wave is compared with the experimental result. As the impact forces were not measured in the experiment, a closed-form analytical solution proposed by ISO/FDIS 19906 (Arctic offshore structures) is used for comparison. These comparisons indicate that the present numerical model is able to reproduce the ice floe kinematics and impact characteristics during floe–structure interaction. Furthermore, a sensitivity analysis is conducted, aimed at investigating how much the simulated impact force is affected by variations in the pressure–area relationship.


1997 ◽  
Vol 25 ◽  
pp. 111-115 ◽  
Author(s):  
Achim Stössel

This paper investigates the long-term impact of sea ice on global climate using a global sea-ice–ocean general circulation model (OGCM). The sea-ice component involves state-of-the-art dynamics; the ocean component consists of a 3.5° × 3.5° × 11 layer primitive-equation model. Depending on the physical description of sea ice, significant changes are detected in the convective activity, in the hydrographic properties and in the thermohaline circulation of the ocean model. Most of these changes originate in the Southern Ocean, emphasizing the crucial role of sea ice in this marginally stably stratified region of the world's oceans. Specifically, if the effect of brine release is neglected, the deep layers of the Southern Ocean warm up considerably; this is associated with a weakening of the Southern Hemisphere overturning cell. The removal of the commonly used “salinity enhancement” leads to a similar effect. The deep-ocean salinity is almost unaffected in both experiments. Introducing explicit new-ice thickness growth in partially ice-covered gridcells leads to a substantial increase in convective activity, especially in the Southern Ocean, with a concomitant significant cooling and salinification of the deep ocean. Possible mechanisms for the resulting interactions between sea-ice processes and deep-ocean characteristics are suggested.


2021 ◽  
pp. 174425912098418
Author(s):  
Toivo Säwén ◽  
Martina Stockhaus ◽  
Carl-Eric Hagentoft ◽  
Nora Schjøth Bunkholt ◽  
Paula Wahlgren

Timber roof constructions are commonly ventilated through an air cavity beneath the roof sheathing in order to remove heat and moisture from the construction. The driving forces for this ventilation are wind pressure and thermal buoyancy. The wind driven ventilation has been studied extensively, while models for predicting buoyant flow are less developed. In the present study, a novel analytical model is presented to predict the air flow caused by thermal buoyancy in a ventilated roof construction. The model provides means to calculate the cavity Rayleigh number for the roof construction, which is then correlated with the air flow rate. The model predictions are compared to the results of an experimental and a numerical study examining the effect of different cavity designs and inclinations on the air flow rate in a ventilated roof subjected to varying heat loads. Over 80 different test set-ups, the analytical model was found to replicate both experimental and numerical results within an acceptable margin. The effect of an increased total roof height, air cavity height and solar heat load for a given construction is an increased air flow rate through the air cavity. On average, the analytical model predicts a 3% higher air flow rate than found in the numerical study, and a 20% lower air flow rate than found in the experimental study, for comparable test set-ups. The model provided can be used to predict the air flow rate in cavities of varying design, and to quantify the impact of suggested roof design changes. The result can be used as a basis for estimating the moisture safety of a roof construction.


Nanomaterials ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 1425
Author(s):  
Tarek Bouzennada ◽  
Farid Mechighel ◽  
Kaouther Ghachem ◽  
Lioua Kolsi

A 2D-symmetric numerical study of a new design of Nano-Enhanced Phase change material (NEPCM)-filled enclosure is presented in this paper. The enclosure is equipped with an inner tube allowing the circulation of the heat transfer fluid (HTF); n-Octadecane is chosen as phase change material (PCM). Comsol-Multiphysics commercial code was used to solve the governing equations. This study has been performed to examine the heat distribution and melting rate under the influence of the inner-tube position and the concentration of the nanoparticles dispersed in the PCM. The inner tube was located at three different vertical positions and the nanoparticle concentration was varied from 0 to 0.06. The results revealed that both heat transfer/melting rates are improved when the inner tube is located at the bottom region of the enclosure and by increasing the concentration of the nanoparticles. The addition of the nanoparticles enhances the heat transfer due to the considerable increase in conductivity. On the other hand, by placing the tube in the bottom area of the enclosure, the liquid PCM gets a wider space, allowing the intensification of the natural convection.


2021 ◽  
Author(s):  
Zhaomin Ding ◽  
Renguang Wu

AbstractThis study investigates the impact of sea ice and snow changes on surface air temperature (SAT) trends on the multidecadal time scale over the mid- and high-latitudes of Eurasia during boreal autumn, winter and spring based on a 30-member ensemble simulations of the Community Earth System Model (CESM). A dynamical adjustment method is used to remove the internal component of circulation-induced SAT trends. The leading mode of dynamically adjusted SAT trends is featured by same-sign anomalies extending from northern Europe to central Siberia and to the Russian Far East, respectively, during boreal spring and autumn, and confined to western Siberia during winter. The internally generated component of sea ice concentration trends over the Barents-Kara Seas contributes to the differences in the thermodynamic component of internal SAT trends across the ensemble over adjacent northern Siberia during all the three seasons. The sea ice effect is largest in autumn and smallest in winter. Eurasian snow changes contribute to the spread in dynamically adjusted SAT trends as well around the periphery of snow covered region by modulating surface heat flux changes. The snow effect is identified over northeast Europe-western Siberia in autumn, north of the Caspian Sea in winter, and over eastern Europe-northern Siberia in spring. The effects of sea ice and snow on the SAT trends are realized mainly by modulating upward shortwave and longwave radiation fluxes.


2010 ◽  
Vol 7 (12) ◽  
pp. 3941-3959 ◽  
Author(s):  
I. Marinov ◽  
S. C. Doney ◽  
I. D. Lima

Abstract. The response of ocean phytoplankton community structure to climate change depends, among other factors, upon species competition for nutrients and light, as well as the increase in surface ocean temperature. We propose an analytical framework linking changes in nutrients, temperature and light with changes in phytoplankton growth rates, and we assess our theoretical considerations against model projections (1980–2100) from a global Earth System model. Our proposed "critical nutrient hypothesis" stipulates the existence of a critical nutrient threshold below (above) which a nutrient change will affect small phytoplankton biomass more (less) than diatom biomass, i.e. the phytoplankton with lower half-saturation coefficient K are influenced more strongly in low nutrient environments. This nutrient threshold broadly corresponds to 45° S and 45° N, poleward of which high vertical mixing and inefficient biology maintain higher surface nutrient concentrations and equatorward of which reduced vertical mixing and more efficient biology maintain lower surface nutrients. In the 45° S–45° N low nutrient region, decreases in limiting nutrients – associated with increased stratification under climate change – are predicted analytically to decrease more strongly the specific growth of small phytoplankton than the growth of diatoms. In high latitudes, the impact of nutrient decrease on phytoplankton biomass is more significant for diatoms than small phytoplankton, and contributes to diatom declines in the northern marginal sea ice and subpolar biomes. In the context of our model, climate driven increases in surface temperature and changes in light are predicted to have a stronger impact on small phytoplankton than on diatom biomass in all ocean domains. Our analytical predictions explain reasonably well the shifts in community structure under a modeled climate-warming scenario. Climate driven changes in nutrients, temperature and light have regionally varying and sometimes counterbalancing impacts on phytoplankton biomass and structure, with nutrients and temperature dominant in the 45° S–45° N band and light-temperature effects dominant in the marginal sea-ice and subpolar regions. As predicted, decreases in nutrients inside the 45° S–45° N "critical nutrient" band result in diatom biomass decreasing more than small phytoplankton biomass. Further stratification from global warming could result in geographical shifts in the "critical nutrient" threshold and additional changes in ecology.


Sign in / Sign up

Export Citation Format

Share Document