scholarly journals Timonium Elementary School solar energy heating and cooling augmentation experiment. Final engineering report: executive summary (ER-8877)

1977 ◽  
Author(s):  
Keyword(s):  
Elementary School ◽  
Solar Energy ◽  
Executive Summary ◽  
Heating And Cooling

scholarly journals Heat Treatment of Steel 1.1730 with Concentrated Solar Energy

2019 ◽  
Vol 56 (1) ◽  
pp. 261-270
Author(s):  
Maria Stoicanescu ◽  
Aurel Crisan ◽  
Ioan Milosan ◽  
Mihai Alin Pop ◽  
Jose Rodriguez Garcia ◽  
...  
Keyword(s):  
Heat Treatment ◽  
Solar Radiation ◽  
Solar Energy ◽  
Vertical Axis ◽  
Solar Furnace ◽  
Solid Base ◽  
Heating And Cooling ◽  
Concentrated Solar Energy ◽  
Wide Range ◽  
The Impact

This paper presents and discusses research conducted with the purpose of developing the use of solar energy in the heat treatment of steels. For this, a vertical axis solar furnace called at Plataforma Solar de Almeria was adapted such as to allow control of the heating and cooling processes of samples made from 1.1730 steel. Thus temperature variation in pre-set points of the heated samples could be monitored in correlation with the working parameters: the level of solar radiation and implicitly the energy used the conditions of sample exposed to solar radiation, and the various protections and cooling mediums.The recorded data allowed establishing the types of treatments applied for certain working conditions. The distribution of hardness, as the representative feature resulting from heat treatment, was analysed on all sides of the treated samples. In correlation with the time-temperature-transformation diagram of 1.1730 steel, the measured values confirmed the possibility of using solar energy in all types of heat treatment applied to this steel. In parallel the efficiency of using solar energy was analysed in comparison to the energy obtained by burning methane gas for the heat treatment for the same set of samples. The analysis considered energy consumption, productivity and the impact on the environment. Thanks to various data obtained through developed experiences, which cover a wide range of thermic treatments applied steels 1.1730 model, we can certainly state that this can be a solid base in using solar energy in applications of thermic treatment at a high industrial level.

Research of Combined Heating and Cooling by Solar Ground-Source Heat Pump and PCM Thermal Storage

Solar Energy ◽  
2005 ◽  
Author(s):  
Li-Xia Wu ◽  
Mao-Yu Zheng
Keyword(s):  
Heat Exchanger ◽  
Solar Energy ◽  
Cooling System ◽  
Storage System ◽  
Thermal Storage ◽  
Cold Climate ◽  
Coefficient Of Performance ◽  
Tube Heat Exchanger ◽  
Heating And Cooling ◽  
Ground Source

In severely cold climate, significant amount of energy is used to heat buildings. Both the theoretical computation and experiments show that it is difficult and uneconomical to use solar energy collected merely in winter. A new method has been developed to store solar energy during summer, fall, and spring for winter heating. This paper presents in details the combined heating and cooling system by solar ground-source heat pump (GSHP) and short-term phase change material (PCM) thermal storage. The hybrid system and season-shift mode can make the sustainable use of solar energy possible. As for the above system, the solar energy collected is stored into soil through the U-tube heat exchanger. In winter, the thermal energy is taken out for heating using the GSHP. At the end of the heat supply season, the underground soil temperature may drop below 0°C. Then some heat exchangers begin to store the heat into soil while others stop. In summer, the U-tube heat exchanger is used to produce low temperature water without compressor to cool the room. The project was supported by the Energy Conservation Laboratory at Harbin Institute of Technology (HIT). The whole systems, which have run for over two years, consist of a flat plate solar hot water system installed on the roof, a soil thermal storage system, a GSHP system, a PCM thermal storage system and heating-cooling system. The measured results show an average heating coefficient of performance (COP) of 3.2 in winter and the cooling coefficient of performance (COP) of 18.0 in summer. The PCM thermal storage system has been investigated by numerical simulation and experiments in the cold climate. In most time of winter, the PCM thermal storage system was used to supply heat, while solar GSHP was also used during continuous cloudy days and severely cold days. The result shows that above method is feasible. The most advantage of this system is that it does not need the usual energy equipment. The numerical analysis has been used to investigate the thermal energy balance of the underground soil. The variation of the soil temperature field around the U-tube heat exchanger has also been studied, not only for the single exchanger but also for multiple exchangers. The underground soil makes the yearly thermal balance possible because the solar energy supplies the heat that is extracted from the soil for heating in winter. Then this system can operate for a long period.

Sign in / Sign up

Export Citation Format

Share Document