scholarly journals Test plan for reactions between spent fuel and J-13 well water under unsaturated conditions

1993 ◽  
Author(s):  
P.A. Finn ◽  
D.J. Wronkiewicz ◽  
J.C. Hoh ◽  
J.W. Emery ◽  
L.D. Hafenrichter ◽  
...  
Keyword(s):  
1985 ◽  
Vol 50 ◽  
Author(s):  
Virginia M. Oversby ◽  
Charles N. Wilson

AbstractResults are presented for the dissolution of Turkey Point pressurized water reactor (PWR) spent fuel in J-13 well water at ambient hot cell temperatures. These results are compared with those previously obtained on Turkey Point fuel in deionized water, on H. B. Robinson PWR fuel in J-13 water, and by other workers using various fuels in dilute bicarbonate groundwaters. A model is presented that represents the conditions under which maximum dissolution of spent fuel could occur in a repository sited at Yucca Mountain, Nevada. Using an experimentally determined upper limit of 5 mg/l for uranium solubility in J-13 water, a fractional release rate of 6.4 × 10−8 per year is obtained by assuming that all water entering the repository carries away the maximum amount of uranium.


1984 ◽  
Vol 44 ◽  
Author(s):  
R. Daniel McCright ◽  
H. Weiss

AbstractCarbon steels may be used for borehole liners in a potential high-level nuclear waste repository in tuff in Nevada. Borehole liners are needed to facilitate emplacement of the waste packages and to facilitate retrieval of the packages, if required. Corrosion rates of low carbon structural steels AISI 1020 and ASTM A-36 were determined in J-13 well water and in saturated steam at 100°C. J-13 well water is representative of water which has percolated through the tuff horizon where the repository would be located. Tests were conducted in air-sparged J-13 water to attain stronger oxidizing conditions. A limited number of irradiation corrosion and stress corrosion tests were performed. Chromium-molybdenum alloy steels and cast irons were also tested. These materials showed lower general corrosion but were susceptible to stress corrosion cracking when welded.


1993 ◽  
Vol 333 ◽  
Author(s):  
P. A. Finn ◽  
J. K. Bates ◽  
J. C. Hoh ◽  
J. W. Emery ◽  
L D. Hafenrichter ◽  
...  

ABSTRACTPreliminary results for the composition of the leachate from unsaturated tests at 90°C with spent fuel for two successive periods of ~60 days each with pretreated J-13 groundwater are reported. The pH of the leachate solutions ranged from 4 to 7. The americium concentration was 104 to 105 greater than that reported for saturated spent fuel tests in which the leachate pH was 8. The major fraction of material in the leachate was present as colloids containing both americium and curium. The presence of actinides in a form not currently directly included in repository radionuclide transport models provides information that can be used in spent fuel reaction modeling, the performance assessment of the repository and the design of the engineering barrier system.


1987 ◽  
Vol 112 ◽  
Author(s):  
Carol J. Bruton ◽  
Henry F. Shaw

AbstractGeochemical simulations of the degradation of spent fuel waste form in the presence of groundwater at the candidate Yucca Mountain, Nevada repository have been carried out to attempt to predict elemental concentrations in solution and to identify potential radionuclide-bearing precipitates. Spent fuel was assumed to dissolve congruently into a static mass of J-13 groundwater at 25°C and 90°C. No inhibitions to the precipitation and dissolution of secondary phases were assumed to exist. The elements Ac, Zr, Nb, Pd, Sm, Mo, Sb and Cm were not considered in the simulations because of a lack of thermodynamic data.Simulation results indicate that haiweeite, soddyite, Na2U2O7(c) and schoepite are potential U-bearing precipitates. Na2U2O7(c) is only predicted to occur at 90°C. U concentrations in solution and the identity of the U-bearing precipitate depend on the activity of SiO2(aq) in solution. U concentrations are limited to < 1 mg/kg when sufficient SiO2(aq) exists in solution to precipitate uranyl silicates. Depletion of SiO2(aq) in solution by the precipitation of silicates results in predicted increases of U concentrations to 87 and 619 mg/kg at 25°C and 90°C, respectively. Subsequent reaction and precipitation of schoepite cause U concentrations to decrease.Radionuclides other than U commonly precipitate as oxides in the simulations. The precipitation of solid phases appears to be extremely effective in limiting the concentrations of some radionuclides, such as Pu and Th, in solution. Concentrations of other elements are held constant (Sn) or are alternately held constant and then increase (Am, Ni, Np) as various solid phases precipitate and pH decreases from 8.5 to 6.5 at 25°C and 8.7 to 8 at 90°C. No solid phases containing Cs or Tc are predicted to form. Increasing the temperature from 25°C to 90°C does not impact greatly the identity of precipitated phases or solution composition, except in the case of U.A technique involving isotope dilution measurements may allow determination of the rates of spent fuel dissolution in future experiments.


1986 ◽  
Vol 84 ◽  
Author(s):  
Charles N. Wilson ◽  
Henry F. Shaw

AbstractSemi-static dissolution tests using pressurized water reactor spent fuel rod segments and NNWSI reference J-13 well water in sealed stainless steel vessels at 85°C are being conducted in support of the Waste Package Task of the NNWSI Project. Test specimens include: bare fuel plus the empty cladding hulls, fuel rod segments with artificially induced cladding defects and water-tight end caps, and undefected fuel rod segments with water-tight end caps. The test conditions approximate those expected in the proposed NNWSI Project repository when the waste package has cooled sufficiently to allow water to enter a breached container and contact the fuel rods, some of which may exhibit various degrees of cladding failure. Periodic solution samples (unfiltered and filtered) were analyzed for most radionuclides for which cumulative release limits are listed by the U.S. Environmental Protection Agency. Results from the first six-month cycle of the 85° C tests are presented and are compared with results from the first cycle of a previous test series run at 25° in fused silica test vessels.


Sign in / Sign up

Export Citation Format

Share Document