Feasibility of controlling nitrification in predenitrification plants using DO, pH and ORP sensors

2006 ◽  
Vol 53 (4-5) ◽  
pp. 235-243 ◽  
Author(s):  
Y. Ma ◽  
Y. Peng ◽  
Z. Yuan ◽  
S. Wang ◽  
X. Wu

Experimental studies were carried out on a bench-scale nitrogen removal system with a predenitrification configuration to gain insights into the spatial and temporal variations of DO, pH and ORP in such systems. It is demonstrated that these signals correlate strongly with the operational states of the system, and could therefore be used as system performance indicators. The DO concentration in the first aerobic zone, when receiving constant aeration, and the net pH change between the last and first aerobic zones display strong correlations with the influent ammonia concentration for the domestic wastewater used in this study. The pH profile along the aerobic zones gives good indication on the extent of nitrification. The experimental results also showed a good correlation between ORP values in the last aerobic zone and effluent ammonia and nitrate concentrations, provided that DO in this zone is controlled at a constant level. These results suggest that the DO, pH and ORP sensors could potentially be used as alternatives to the on-line nutrient sensors for the control of continuous systems. An idea of using a fuzzy inference system to make an integrated use of these signals for on-line aeration control is presented and demonstrated on the bench-scale system with promising results. The use of these sensors has to date only been demonstrated in intermittent systems, such as sequencing batch reactor systems.

2006 ◽  
Vol 53 (4-5) ◽  
pp. 171-178 ◽  
Author(s):  
S. Puig ◽  
Ll. Corominas ◽  
A. Traore ◽  
J. Colomer ◽  
M.D. Balaguer ◽  
...  

A pilot plant sequencing batch reactor (SBR) was applied in a wastewater treatment plant treating urban wastewater focused on carbon and nitrogen removal. From an initial predefined step-feed cycle definition, the evolution of the on-line monitored pH and calculated oxygen uptake rate (OUR) were analysed in terms of knowledge extraction. First, the aerobic phases of the SBR cycle were operated using an On/Off dissolved oxygen (DO) control strategy that concluded with a sinusoidal pH profile that made detecting the “ammonia valley” difficult. After changing to fuzzy logic control of the dissolved oxygen and by adding an air flow meter to the pilot plant, the pH evolution and on-line calculated OUR showed a clearer trend during the aerobic phases. Finally, a proposed algorithm for adjusting the aerobic phases of the SBR for carbon and ammonia removal is presented and discussed.


1997 ◽  
Vol 36 (4) ◽  
pp. 307-312
Author(s):  
Michael R. Rasmussen ◽  
Torben Larsen

An on-line settling column for measuring the dynamic variations of settling velocity of activated sludge has been developed. The settling column is automatic and self-cleansing insuring continuous and reliable measurements. The settling column was tested on sludge from a batch reactor where sucrose was added as an impulse to activated sludge. The continuous measurement of settling velocity revealed a highly dynamic response after the sucrose was added. The results were verified with simultaneous measurement of the initial settling rate. A 200 hour experiment showed variations in settling velocity, which was not apparent in the DSVI (Diluted Sludge Volume Index).


2002 ◽  
Vol 19 (2) ◽  
pp. 115-130 ◽  
Author(s):  
Rajesh B. Doppalapudi ◽  
George A. Sorial ◽  
Stephen W. Maloney

2012 ◽  
Vol 2012 ◽  
pp. 1-10 ◽  
Author(s):  
Shutao Xing ◽  
Marvin W. Halling ◽  
Qingli Meng

Structural pounding can cause considerable damage and even lead to collapse of structures. Most research focuses on modeling, parameter investigation, and mitigation approaches. With the development of structural health monitoring, the on-line detection of pounding becomes possible. The detection of pounding can provide useful information of potential damage of structures. This paper proposed using wavelet scalograms of dynamic response to detect pounding and examined the feasibility of this method. Numerical investigations were performed on a pounding system that consisted of a damped single-degree-of-freedom (SDOF) structure and a rigid barrier. Hertz contact model was used to simulate pounding behavior. The responses and pounding forces of the system under harmonic and earthquake excitations were numerically solved. The wavelet scalograms of acceleration responses were used to identify poundings. It was found that the scalograms can indicate the occurrence of pounding and occurrence time very well. The severity of the poundings was also approximately estimated. Experimental studies were carried out, in which shake table tests were conducted on a bridge model that underwent pounding between its different components during ground motion excitation. The wavelet scalograms of the bridge responses indicated pounding occurrence quite well. Hence the conclusions from the numerical studies were verified experimentally.


2010 ◽  
Vol 49 (4) ◽  
pp. 587-595 ◽  
Author(s):  
K. Renganathan ◽  
Vidhyacharan Bhaskar

Sign in / Sign up

Export Citation Format

Share Document