scholarly journals Measurement of Isolated Myocyte Volume Using the Coulter® Models Z2 and ZM/C256: A Comparison of Instrument Function

BioTechniques ◽  
1998 ◽  
Vol 25 (3) ◽  
pp. 522-525 ◽  
Author(s):  
Suleman Said ◽  
Tetsutaro Tamura ◽  
A. Martin Gerdes
2003 ◽  
Author(s):  
Jose G. Suarez-Romero ◽  
Eduardo Tepichin RodrIguez
Keyword(s):  

2012 ◽  
Vol 5 (4) ◽  
pp. 4667-4710 ◽  
Author(s):  
T. O. Sato ◽  
H. Sagawa ◽  
D. Kreyling ◽  
T. Manabe ◽  
S. Ochiai ◽  
...  

Abstract. Chlorine monoxide (ClO) is the key species for anthropogenic ozone loss in the middle atmosphere. We observed the ClO diurnal variation using the Superconducting Submillimeter-Wave Limb-Emission Sounder (SMILES) on the International Space Station which has a non sun-synchronous orbit. This is the first global observation of the ClO diurnal variation from the stratosphere up to the mesosphere. The SMILES observation reproduced the diurnal variation of stratospheric ClO, an enhancement during a daytime, as observed by the Microwave Limb Sounder on the Upper Atmosphere Research Satellite (UARS/MLS). Mesospheric ClO has shown a different diurnal behavior with an enhancement during nighttime. The ClO enhancement was found at a pressure of 0.02 hPa (about 70 km) with an amplitude of about 100 pptv and reached up to 0.01 hPa (80 km) in the zonal mean of 50° N–65° N in January–February 2010. The observation of mesospheric ClO was possible due to the 10–20 times better signal-to-noise ratio of the spectra than those of past microwave/submillimeter-wave limb-emission sounders. We performed a quantitative error analysis for the strato- and mesospheric ClO of the Level-2 research (L2r) product version 2.1.5 taking into account all possible error contributions; i.e. errors due to spectrum noise, smoothing and uncertainties in the radiative transfer model and instrument function. The SMILES L2r v2.1.5 ClO data are useful over the range 0.01 and 100 hPa with a total error of 10–30 pptv (about 10%) with averaging of 100 profiles. The vertical resolution is 3–5 km and 5–8 km for the stratosphere and mesosphere, respectively. The performance of the SMILES observation opens the new opportunity to investigate ClO up to the mesopause.


2013 ◽  
Vol 33 (suppl_1) ◽  
Author(s):  
Yuefeng Chen ◽  
Songchuan Guo ◽  
Zev Carrey ◽  
Dariush Alaie ◽  
Richard Petrillo ◽  
...  

Background Thyroid hormones (THs) have been shown to improve LV function and remodeling in animals post-MI and in the human setting, as well as induce capillary and arteriolar growth in the hypertrophic heart. Whether THs can improve arteriolar growth in the infarcted heart is unknown. Methods MI was produced by ligation of the LAD in female SD rats. Rats were divided into the following groups: (1) Sham MI, (2) MI, and (3) MI+T4 treatment (T4 pellet 3.3mg, 60 days release, implanted subcutaneously immediately following MI). Each group was further divided into two subgroups (n=9 per subgroup) for myocytes isolation and whole heart tissues collection eight weeks after surgery. Isolated myocyte shape and arteriolar density in the non-infarcted area were measured at terminal study. Results T4 treatment improved LV ±dp/dt, normalized TAU, and increased myocyte cross-sectional area without further increasing myocyte length in MI rats. T4 treatment tended to increase the total length of smaller arterioles (5 to 15 μm) proportional to LV weight increase. Conclusions These results suggest that long-term T4 treatment after MI has beneficial effects on myocyte and arteriolar remodeling in the non-infarcted area.


1996 ◽  
Vol 271 (1) ◽  
pp. H51-H58 ◽  
Author(s):  
A. H. Tobias ◽  
B. K. Slinker ◽  
R. D. Kirkpatrick ◽  
K. B. Campbell

The results of isolated myocyte and cardiac muscle experiments indicate that inotropic agents that increase responsiveness of myofilaments to Ca2+ (so-called Ca2+ sensitizers) may prolong myocardial contraction and increase diastolic tone, but the importance of these effects in the whole heart is unclear. Therefore, we studied the effects of the Ca2+ sensitizer EMD-57033 (EMD) on left ventricular (LV) contractile events and passive properties in isovolumically beating isolated rabbit hearts that were buffer perfused at 30 degrees C. Several LV pressure and timing variables were evaluated, including the passive pressure-volume relationship, the Frank-Starling relationship, and the wall stress dependence of the duration of relaxation during perfusion with 0, 2, and 4 microM EMD. EMD (2 microM) increased average peak developed pressure of the Frank-Starling relationship by approximately 18%. In contrast, the peak developed pressure of the Frank-Starling relationship decreased toward control with 4 microM EMD, and therefore all the results presented pertain to 2 microM EMD. The maximum developed pressure at baseline volume was increased by approximately 19% by 2 microM EMD, and this was accompanied by an increase in contraction duration of approximately 13%, due exclusively to slowed relaxation. The relative contributions of maximal wall stress (sigma max) versus an independent negative lusitropic effect of EMD were determined at three LV volumes. At baseline volume, just less than one-half of the effect to slow relaxation was ascribable to an increase in sigma max, whereas the remainder was due to an independent EMD effect. LV passive properties were unchanged by perfusion with 2 microM EMD. We conclude that EMD is a potent inotrope in our isolated rabbit heart preparation, which has no effect on diastolic tone and causes a modest prolongation of contraction duration due to slowed relaxation. At baseline volume, approximately 50% of the slowed relaxation was ascribable to positive inotropy leading to increased sigma max, whereas the remaining approximately 50% was ascribable to a direct negative lusitropic effect of EMD. We discuss our results in terms of the current hypotheses regarding the mechanism of action of the Ca2+ sensitizers.


1988 ◽  
Vol 41 (2) ◽  
pp. 101 ◽  
Author(s):  
William Parrish

The advantages of synchrotron radiation for X-ray polycrystalline diffraction are illustrated by a number of examples. The plane wave parallel-beam X-ray optics uses a Si(lll) channel monochromator for easy wavelength selection and a set of long parallel slits to define the diffracted beam. The constant simple instrument function and the high resolution symmetrical profiles (FWHM 0.05") greatly simplify the data analysis and add a new dimension to profile broadening studies. The geometry permits uncoupling the 6-26 sample-detector relationship without changing the profile shape and makes possible new applications such as grazing angle incidence depth analysis of thin films. The same instrumentation is used for high resolution energy dispersive diffraction (BOD) by step-scanning the monochromator. The resolution is two orders of magnitude better than conventional BOD and can be used at high count rates. The easy wavelength selection yields diffraction patterns with the highest PI B and permits anomalous scattering studies.


1983 ◽  
Vol 27 ◽  
pp. 75-80
Author(s):  
W. Parrish ◽  
T. C. Huang ◽  
G. L. Ayers

AbstractA method for computer simulation of X-ray powder diffraction patterns which are identical to those obtained experimentally is described. The calculated pattern is generated directly from the d's (or 2θs) and intensities of the phase(s) and is based on a profile fitting algorithm which uses the instrument function to form the profile shapes at all reflection angles. Examples of simulated patterns of mixtures, line broadening, linear and amorphous backgrounds, and counting noise are given.


2019 ◽  
Vol 7 (2) ◽  
pp. 65-70
Author(s):  
О. Заломнова ◽  
O. Zalomnova

In this paper have been considered the basic terms of functional safety for industrial processes according to GOST R IEC61511–1–2011 «Functional Safety. Safety Instrument Systems for Industrial Processes»: safe and dangerous failures, safety instrumented system, safety instrument function, safety integrity level. The qualitative analysis method — the study of hazard and operability HAZOP using the control words — has been considered. The algorithm for HAZOP carrying out has been presented. Safety integrity levels for low and high intensity of requests have been considered. An example for safety integrity level determination has been depicted.


Sign in / Sign up

Export Citation Format

Share Document