Understanding grain moisture percentage and nutrient contents for precision grain management

Crops & Soils ◽  
2017 ◽  
Vol 50 (6) ◽  
pp. 20-24
Author(s):  
Cheryl L. Reese ◽  
C. Gregg Carlson
Keyword(s):  
Nutrient Contents ◽  
Grain Moisture ◽  
Moisture Percentage

scholarly journals Selectivity of the sulfonylurea herbicide group in the crop of maize inbred lines

Pesticidi ◽  
2003 ◽  
Vol 18 (3) ◽  
pp. 187-194 ◽  
Author(s):  
Milivoje Milivojevic ◽  
Lidija Stefanovic ◽  
Ivan Husic ◽  
Milena Simic ◽  
Zdravko Hojka
Keyword(s):  
Untreated Control ◽  
Growing Season ◽  
Inbred Lines ◽  
Sulfonylurea Herbicide ◽  
Growing Period ◽  
Estimated Parameters ◽  
Maize Inbred Lines ◽  
Grain Moisture ◽  
Moisture Percentage ◽  
Ear Height

The selectivity of the nicosulfuron, primisulfuron-methyl and rimsulfuron herbicides in relation to 20 PL maize inbred lines was monitored. Obtained results were compared with the untreated control. The following parameters were measured during the growing period: plant height (cm): ear height (cm) leaf width at the ear bottom (cm): tassel length (cm); number of primary tassel branches; grain yield at the and of growing season (t/ha) and grain moisture percentage (%). The effects of applied herbicides on observed maize inbred lines showed different degrees of selectivity. Average values of estimated parameters for all studied inbreeds differed significantly over applied herbicides. Nicosulfuron was most selective.

Crop maturity in relation to quality of canned cream style sweet corn

1951 ◽  
Vol 2 (1) ◽  
pp. 43
Author(s):  
RS Mitchell ◽  
LJ Lynch
Keyword(s):  
Sweet Corn ◽  
Moisture Loss ◽  
Term Prediction ◽  
Grain Moisture ◽  
Heat Increment ◽  
Moisture Percentage ◽  
Short Term Prediction ◽  
Long Term Prediction

The reliability of grain moisture percentage as a measure of desirable picking maturity was confirmed. The refractive index of the fluid material expressed from the grain was shown to give a rapid estimation of the grain moisture, the accuracy being sufficient for commercial requirements. The rate of moisture loss from ripening grain grown at Windsor, N.S.W., was measured and used for the short-term prediction of the date of harvest. Limits were defined for different planting times in terms of the number of days to picking maturity. Such limits provide a simpler means of long-term prediction than the heat increment method proposed by American workers. A plan is outlined for the field control of commercial sweet corn plantings in the Windsor district.

Productivity of corn hybrids of different fao groups depending on microfertilizers and growth stimulants under irrigation in the south of Ukraine

2016 ◽  
Vol 3 (1) ◽  
pp. 55-60
Author(s):  
Yu. Lavrynenko ◽  
R. Vozhegova ◽  
O. Hozh
Keyword(s):  
Grain Quality ◽  
Laboratory Method ◽  
The South ◽  
Corn Hybrids ◽  
Early Maturity ◽  
Effi Ciency ◽  
Grain Moisture ◽  
Grain Productivity ◽  
The Impact

The purpose of the research is to identify effi cient microfertilizers and growth stimulants considering biologi- cal features of new corn hybrids of different FAO groups under irrigation conditions in the South of Ukraine and trace their impact on grain productivity of the plants. The methods of the research are the fi eld method – to study the interaction of the research object with experimental factors of the natural environment, to register the yield and evaluate the biometrical indices; the laboratory method – to measure soil moisture, grain moisture content and grain quality indices; the statistical method – to evaluate the reliability of the obtained results; the calculation methods – for economic and energetic assessment of the growing techniques used. The results of the research. The paper defi nes the impact of microfertilizers and growth stimulants on the yield and grain quality of the corn hybrids of different maturity groups and on the economic effi ciency of growing them. The conclusions of the research. Under irrigation conditions of the Southern Steppe of Ukraine it is recommended that the following hybrids should be grown in dark-chestnut soils: early maturity DN Pyvykha, medium-early Skadovskyi, medium maturity Kakhovskyi and medium-late Arabat, using the growth stimulants – treating the seeds with Sezam-Nano and fertilizing with Grainactive at the stage of 7–8 leaves.

Unifying Calibration Parameters for Dielectric Moisture Meter

2006 ◽  
Vol 2 (1) ◽  
pp. 73-94 ◽  
Author(s):  
Péter Mészáros ◽  
David B. Funk
Keyword(s):  
The United States ◽  
Temperature Correction ◽  
Physical Parameters ◽  
Correction Coefficient ◽  
Prototype System ◽  
United States Department ◽  
Very High Frequency ◽  
Grain Moisture ◽  
University Of Budapest ◽  
Improved Accuracy

The Unified Grain Moisture Algorithm is capable of improved accuracy and allows the combination of many grain types into a single “unified calibration”. The purposes of this research were to establish processes for determining unifying parameters from the chemical and physical properties of grains. The data used in this research were obtained as part of the United States Department of Agriculture-Grain Inspection, Packers and Stockyards Administration's Annual Moisture Calibration Study. More than 5,000 grain samples were tested with a Hewlett-Packard 4291A Material/Impedance Analyzer. Temperature tests were done with a Very High Frequency prototype system at Corvinus University of Budapest. Typical chemical and physical parameters for each of the major grain types were obtained from the literature. Data were analyzed by multivariate chemometric methods. One of the most important unifying parameters (Slope) and the temperature correction coefficient were successfully modeled. The Offset and Translation unifying parameters were not modeled successfully, but these parameters can be estimated relatively easily through limited grain tests.

Effects of Non-uniform Kernel Moisture Content on Moisture Measurement of Corn

2005 ◽  
Vol 1 (1) ◽  
pp. 77-93
Author(s):  
Bíborka Gillay ◽  
David B. Funk
Keyword(s):  
Moisture Content ◽  
Moisture Measurement ◽  
Safe Storage ◽  
Grain Moisture ◽  
Moisture Meter ◽  
Percent Moisture ◽  
New Crop ◽  
The U.S

The price paid for corn is usually based on 15.0 or 15.5 percent moisture content. However, corn must be dried below 13 percent moisture to ensure safe storage for a year or more. In the U.S., such stored corn cannot be directly remoistened before selling it, but it can be mixed with moist new-crop corn. Accurate moisture measurement of mixtures of dry and moist corn is important to permit adjustment of blending ratios to maximize profitability, but grain moisture meters are less accurate for mixtures of wet and dry grain. This research evaluated the differences between dielectric-type moisture meter results for mixed and equilibrated corn samples at different moisture levels and different measurement frequencies. Equilibrated grain samples tended to give lower moisture results than recently mixed grain samples - especially in the 1 to 10 MHz region. These differences permitted detection of mixtures by using moisture measurements at two frequencies.

Yield performance with heritability measurements of half sib families obtained from maize variety Azam

1970 ◽  
pp. 33-36
Author(s):  
Faizan Mahmood, Hidayat- Ur-Rahman, Nazir Ahmad ◽  
Fahim-ul- Haq ◽  
Samrin Gul, Quaid Hussain ◽  
Ammara Khalid ◽  
Touheed Iqbal ◽  
...  
Keyword(s):  
Grain Yield ◽  
Agronomic Traits ◽  
Heritability Estimate ◽  
Kernel Weight ◽  
Yield Performance ◽  
Grain Moisture ◽  
Maize Variety ◽  
Ear Height ◽  
Sib Families

This study evaluated the performance of 64 half sib families (HSF) derived from “Azam” variety of maize using partially balanced lattice square design with two replications. Data were recorded on grain yield and other agronomic traits. Observations showed difference in half-sib families for studied traits. Among the 64 half-sib families, minimum days to 50% tasseling (51 days) were observed for HS-49 while maximum (57 days) for HS-63. Minimum days to 50% silking (56 days) were counted for HS-6 while maximum (63 days) for HS-23. Minimum days to 50% anthesis (55 days) were counted for HS-1 and HS-6 while maximum (62 days) for HS-23. Similarly, minimum ASI (-2 days) were observed in HS-1, HS-15, HS-16, HS-28 and HS-63 while maximum (2 days) in HS-48. Minimum (60 cm) ear height was recorded for HS-11 and maximum (93.5 cm) for HS-28. Minimum fresh ear weight (1.3 kg) was weighted for HS-17 while maximum (3.2 kg) for HS-21. Grain moisture was recorded minimum (19.35 %) for HS-19 and maximum (31.25%) for HS-2. HS-42 showed minimum (28 g) 100 kernel weight while HS-5 showed maximum (47 g). Grain yield was minimum (2323 kg ha-1) for HS-17 and maximum (5742 kg ha-1) for HS-21. Maximum heritability estimate (0.92) was recorded for fresh ear weight, while minimum (0.41) was observed for ear height.

Sign in / Sign up

Export Citation Format

Share Document